| /Linux-v6.1/drivers/staging/axis-fifo/ |
| D | Kconfig | 3 # "Xilinx AXI-Stream FIFO IP core driver"
6 tristate "Xilinx AXI-Stream FIFO IP core driver"
9 This adds support for the Xilinx AXI-Stream FIFO IP core driver.
10 The AXI Streaming FIFO allows memory mapped access to a AXI Streaming
11 interface. The Xilinx AXI-Stream FIFO IP core can be used to interface
|
| D | axis-fifo.txt | 1 Xilinx AXI-Stream FIFO v4.1 IP core
37 - xlnx,rx-fifo-depth: Depth of RX FIFO in words
45 - xlnx,tx-fifo-depth: Depth of TX FIFO in words
51 - xlnx,use-rx-data: <0x1> if RX FIFO is enabled, <0x0> otherwise
54 - xlnx,use-tx-data: <0x1> if TX FIFO is enabled, <0x0> otherwise
|
| /Linux-v6.1/Documentation/devicetree/bindings/interrupt-controller/ |
| D | cirrus,clps711x-intc.txt | 24 12: UTXINT1 UART1 transmit FIFO half empty
25 13: URXINT1 UART1 receive FIFO half full
29 17: SS2RX SSI2 receive FIFO half or greater full
30 18: SS2TX SSI2 transmit FIFO less than half empty
31 28: UTXINT2 UART2 transmit FIFO half empty
32 29: URXINT2 UART2 receive FIFO half full
|
| /Linux-v6.1/Documentation/networking/device_drivers/can/freescale/ |
| D | flexcan.rst | 15 - FIFO
20 configured for RX-FIFO mode.
22 The RX FIFO mode uses a hardware FIFO with a depth of 6 CAN frames,
23 while the mailbox mode uses a software FIFO with a depth of up to 62
40 more performant "RX mailbox" mode and will use "RX FIFO" mode
|
| /Linux-v6.1/drivers/video/fbdev/riva/ |
| D | riva_hw.c | 1351 LOAD_FIXED_STATE(nv4,FIFO); in UpdateFifoState()
1353 chip->Tri05 = (RivaTexturedTriangle05 __iomem *)&(chip->FIFO[0x0000E000/4]); in UpdateFifoState()
1362 LOAD_FIXED_STATE(nv10,FIFO); in UpdateFifoState()
1364 chip->Tri05 = (RivaTexturedTriangle05 __iomem *)&(chip->FIFO[0x0000E000/4]); in UpdateFifoState()
1397 chip->Tri03 = (RivaTexturedTriangle03 __iomem *)&(chip->FIFO[0x0000E000/4]); in LoadStateExt()
1436 chip->Tri03 = (RivaTexturedTriangle03 __iomem *)&(chip->FIFO[0x0000E000/4]); in LoadStateExt()
1441 chip->Tri03 = (RivaTexturedTriangle03 __iomem *)&(chip->FIFO[0x0000E000/4]); in LoadStateExt()
1482 chip->Tri03 = (RivaTexturedTriangle03 __iomem *)&(chip->FIFO[0x0000E000/4]); in LoadStateExt()
1487 chip->Tri03 = (RivaTexturedTriangle03 __iomem *)&(chip->FIFO[0x0000E000/4]); in LoadStateExt()
1645 LOAD_FIXED_STATE(Riva,FIFO); in LoadStateExt()
[all …]
|
| /Linux-v6.1/Documentation/spi/ |
| D | pxa2xx.rst | 15 The driver is built around a &struct spi_message FIFO serviced by kernel
16 thread. The kernel thread, spi_pump_messages(), drives message FIFO and
107 used to configure the SSP hardware FIFO. These fields are critical to the
109 FIFO overruns (especially in PIO mode transfers). Good default values are::
124 trailing bytes in the SSP receiver FIFO. The correct value for this field is
144 .tx_threshold = 8, /* SSP hardward FIFO threshold */
145 .rx_threshold = 8, /* SSP hardward FIFO threshold */
151 .tx_threshold = 8, /* SSP hardward FIFO threshold */
152 .rx_threshold = 8, /* SSP hardward FIFO threshold */
|
| /Linux-v6.1/Documentation/devicetree/bindings/serial/ |
| D | mvebu-uart.txt | 7 (32 bytes FIFO, no DMA, level interrupts, 8-bit access to the
8 FIFO), called also UART1.
10 UART (128 bytes FIFO, DMA, front interrupts, 8-bit or 32-bit
11 accesses to the FIFO), called also UART2.
|
| /Linux-v6.1/Documentation/devicetree/bindings/powerpc/fsl/ |
| D | mpc5121-psc.txt | 8 fsl,mpc5121-immr SoC node. Additionally the PSC FIFO
19 PSC FIFO Controller and b is a field that represents an
42 FIFO Controller
44 PSC FIFO Controller and b is a field that represents an
|
| /Linux-v6.1/Documentation/devicetree/bindings/edac/ |
| D | socfpga-eccmgr.txt | 85 Ethernet FIFO ECC
93 NAND FIFO ECC
101 DMA FIFO ECC
109 USB FIFO ECC
117 QSPI FIFO ECC
125 SDMMC FIFO ECC
268 Ethernet FIFO ECC
275 NAND FIFO ECC
282 DMA FIFO ECC
289 USB FIFO ECC
[all …]
|
| /Linux-v6.1/drivers/scsi/aic7xxx/ |
| D | aic79xx.seq | 169 * Since this status did not consume a FIFO, we have to
171 * to this transaction. There are two states that a FIFO still
174 * 1) Configured and draining to the host, with a FIFO handler.
177 * Case 1 can be detected by noticing a non-zero FIFO active
179 * the FIFO to complete the SCB.
182 * pointers for this same context in the other FIFO. So, if
308 * The FIFO use count field is shared with the
583 * Allocate a FIFO for a non-packetized transaction.
585 * can allocate a FIFO for a non-packetized transaction.
589 * Do whatever work is required to free a FIFO.
[all …]
|
| /Linux-v6.1/arch/sparc/include/asm/ |
| D | floppy_64.h | 449 #define FIFO (port + 5) macro
468 sun_pci_fd_out_byte(port, 0x08, FIFO); in sun_pci_fd_sensei()
479 result[i++] = inb(FIFO); in sun_pci_fd_sensei()
514 sun_pci_fd_out_byte(port, 0x07, FIFO); in sun_pci_fd_test_drive()
515 sun_pci_fd_out_byte(port, drive & 0x03, FIFO); in sun_pci_fd_test_drive()
530 #undef FIFO
|
| /Linux-v6.1/drivers/video/fbdev/nvidia/ |
| D | nv_local.h | 92 NV_WR32(&(par)->FIFO[0x0010], 0, (data) << 2); \
96 #define READ_GET(par) (NV_RD32(&(par)->FIFO[0x0011], 0) >> 2)
|
| /Linux-v6.1/arch/powerpc/platforms/512x/ |
| D | Kconfig | 14 tristate "MPC512x LocalPlus Bus FIFO driver"
17 Enable support for Freescale MPC512x LocalPlus Bus FIFO (SCLPC).
|
| /Linux-v6.1/drivers/edac/ |
| D | Kconfig | 433 bool "Altera Ethernet FIFO ECC"
437 Altera Ethernet FIFO Memory for Altera SoCs.
440 bool "Altera NAND FIFO ECC"
444 Altera NAND FIFO Memory for Altera SoCs.
447 bool "Altera DMA FIFO ECC"
451 Altera DMA FIFO Memory for Altera SoCs.
454 bool "Altera USB FIFO ECC"
458 Altera USB FIFO Memory for Altera SoCs.
461 bool "Altera QSPI FIFO ECC"
465 Altera QSPI FIFO Memory for Altera SoCs.
[all …]
|
| /Linux-v6.1/Documentation/devicetree/bindings/dma/ |
| D | atmel-dma.txt | 31 - bit 11-8: FIFO configuration. 0 for half FIFO, 1 for ALAP, 2 for ASAP.
|
| /Linux-v6.1/drivers/char/tpm/ |
| D | Kconfig | 48 tristate "TPM Interface Specification 1.2 Interface / TPM 2.0 FIFO Interface"
53 TCG TIS 1.2 TPM specification (TPM1.2) or the TCG PTP FIFO
59 tristate "TPM Interface Specification 1.3 Interface / TPM 2.0 FIFO Interface - (SPI)"
65 TCG TIS 1.3 TPM specification (TPM1.2) or the TCG PTP FIFO
78 tristate "TPM Interface Specification 1.3 Interface / TPM 2.0 FIFO Interface - (I2C - generic)"
90 tristate "TPM Interface Specification 1.2 Interface / TPM 2.0 FIFO Interface (MMIO - SynQuacer)"
95 TCG TIS 1.2 TPM specification (TPM1.2) or the TCG PTP FIFO
|
| /Linux-v6.1/arch/arm/include/debug/ |
| D | samsung.S | 56 @ FIFO enabled...
80 @ FIFO enabled...
|
| /Linux-v6.1/Documentation/networking/device_drivers/can/ctu/ |
| D | ctucanfd-driver.rst | 194 device HW queue (FIFO, mailboxes or whatever the implementation is)
336 the RXNE (RX FIFO Not Empty) bit is set. Frames are read one by one
337 until either no frame is left in the RX FIFO or the maximum work quota
345 in the first word of RX FIFO.
348 for the frame, and only if it succeeds, fetch the frame from FIFO;
350 correct ``skb``, we have to fetch the first work of FIFO. There are
360 #. Add option to peek into the FIFO instead of consuming the word.
373 a partial frame may stay in the FIFO for a prolonged time. Nonetheless,
374 there may be just one owner of the RX FIFO, and thus no one else should
401 SocketCAN, however, supports only one FIFO queue for outgoing
[all …]
|
| /Linux-v6.1/Documentation/devicetree/bindings/display/tilcdc/ |
| D | panel.txt | 10 - fdd: FIFO DMA Request Delay
14 - fifo-th: DMA FIFO threshold
|
| /Linux-v6.1/Documentation/sound/cards/ |
| D | sb-live-mixer.rst | 93 The result is forwarded to the ADC capture FIFO (thus to the standard capture
106 The result is forwarded to the ADC capture FIFO (thus to the standard capture
120 The result is forwarded to the ADC capture FIFO (thus to the standard capture
149 of the AC97 codec. The result is forwarded to the ADC capture FIFO (thus to
166 forwarded to the ADC capture FIFO (thus to the standard capture PCM device).
178 forwarded to the ADC capture FIFO (thus to the standard capture PCM device).
189 digital inputs. The result samples are forwarded to the ADC capture FIFO
201 digital inputs. The result samples are forwarded to the ADC capture FIFO
214 capture FIFO (thus to the standard capture PCM device).
|
| D | audigy-mixer.rst | 84 The result is forwarded to the ADC capture FIFO (thus to the standard capture
97 The result is forwarded to the ADC capture FIFO (thus to the standard capture
105 capture FIFO (device 1 - 16bit/8KHz mono) too without volume control.
110 The result is forwarded to the ADC capture FIFO (thus to the standard capture
123 forwarded to the ADC capture FIFO (thus to the standard capture PCM device).
134 digital inputs. The result samples are forwarded to the ADC capture FIFO
147 capture FIFO (thus to the standard capture PCM device).
160 capture FIFO (thus to the standard capture PCM device).
172 capture FIFO (thus to the standard capture PCM device).
|
| /Linux-v6.1/sound/soc/cirrus/ |
| D | Kconfig | 20 Underflow of internal I2S controller FIFO could confuse the
24 fills FIFO with zeroes.
|
| /Linux-v6.1/drivers/staging/media/omap4iss/ |
| D | TODO | 1 * Fix FIFO/buffer overflows and underflows
|
| /Linux-v6.1/Documentation/admin-guide/blockdev/ |
| D | floppy.rst | 98 you have an FDC without a FIFO (8272A or 82072). 82072A and
100 If you use nodma mode, I suggest you also set the FIFO
104 If you have a FIFO-able FDC, the floppy driver automatically
113 Disables the FIFO entirely. This is needed if you get "Bus
118 Enables the FIFO. (default)
121 Sets the FIFO threshold. This is mostly relevant in DMA
|
| /Linux-v6.1/Documentation/devicetree/bindings/security/tpm/ |
| D | google,cr50.txt | 5 SPI using the FIFO protocol described in the PTP Spec, section 6.
|
