Searched refs:EOC (Results 1 – 5 of 5) sorted by relevance
| /Linux-v6.1/drivers/net/ethernet/realtek/ |
| D | atp.h | 28 #define EOC 0xE0 macro
97 outb(EOC+offset, port + PAR_DATA); in read_nibble()
101 outb(EOC+offset, port + PAR_DATA); in read_nibble()
163 outb(EOC | reg, port + PAR_DATA); in write_reg()
175 outb(EOC | outval, port + PAR_DATA); in write_reg()
181 unsigned char outval = EOC | HNib | reg; in write_reg_high()
194 outb(EOC | HNib | outval, port + PAR_DATA); in write_reg_high()
203 outb(EOC | reg, port + PAR_DATA); /* Reset the address register. */ in write_reg_byte()
215 outb(EOC | value, port + PAR_DATA); /* Reset the address register. */ in write_reg_byte()
|
| D | atp.c | 506 outb(EOC+MAR, ioaddr + PAR_DATA); in write_packet()
763 outb(EOC+MAR, ioaddr + PAR_DATA); in net_rx()
822 outb(EOC+HNib+MAR, ioaddr + PAR_DATA); in read_block()
|
| /Linux-v6.1/drivers/hwmon/ |
| D | as370-hwmon.c | 25 #define EOC BIT(12) macro
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | imx27-apf27dev.dts | 218 MX27_PAD_UART1_RTS__GPIO5_15 0x0 /* EOC */
|
| /Linux-v6.1/Documentation/admin-guide/ |
| D | dynamic-debug-howto.rst | 86 :#> ddcmd <<"EOC"
89 EOC
|
