Searched refs:tied (Results 1 – 25 of 33) sorted by relevance
12
| /Linux-v5.4/Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,smd.txt | 61 In turn, subnodes of the "edges" represent devices tied to SMD channels on that
69 Definition: a list of channels tied to this device, used for matching
75 "rpm" subsystem. For the "rpm" subsystem we have a device tied to the
|
| D | qcom,glink.txt | 41 Each subnode of the GLINK node represent function tied to a virtual
49 Definition: a list of channels tied to this function, used for matching
|
| D | qcom,apr.txt | 26 Each subnode of the APR node represents service tied to this apr. The name
|
| /Linux-v5.4/drivers/gpu/drm/nouveau/nvkm/engine/disp/ |
| D | vga.c | 166 u32 tied = nvkm_rd32(device, 0x001084) & 0x10000000; in nvkm_rdvgaowner() local
167 if (tied == 0) { in nvkm_rdvgaowner()
|
| /Linux-v5.4/Documentation/spi/ |
| D | spi-lm70llp.rst | 66 collector is tied to VCC.
72 hand, the transistor is cut off and the voltage tied to it's collector is
|
| /Linux-v5.4/Documentation/driver-api/nvdimm/ |
| D | security.rst | 93 An key with the current passphrase payload that is tied to the nvdimm should be
101 An key with the current passphrase payload that is tied to the nvdimm should be
115 An encrypted-key with the current user passphrase that is tied to the nvdimm
|
| /Linux-v5.4/drivers/staging/wilc1000/ |
| D | Kconfig | 31 immediately following reset when pin 9 (SDIO_SPI_CFG) is tied to
|
| /Linux-v5.4/Documentation/driver-api/ |
| D | device_connection.rst | 19 They are only descriptions which are not tied to either of the devices directly.
|
| /Linux-v5.4/Documentation/devicetree/bindings/mfd/ |
| D | cirrus,lochnagar.txt | 55 tied in hardware.
|
| D | aspeed-lpc.txt | 185 The UARTs present in the ASPEED SoC can have their resets tied to the reset
|
| /Linux-v5.4/arch/powerpc/boot/dts/ |
| D | xpedite5200.dts | 431 cle-line = <0x8>; /* CLE tied to A3 */
432 ale-line = <0x10>; /* ALE tied to A4 */
|
| D | xpedite5200_xmon.dts | 435 cle-line = <0x8>; /* CLE tied to A3 */
436 ale-line = <0x10>; /* ALE tied to A4 */
|
| D | walnut.dts | 225 /* Walnut has all 4 IRQ pins tied together per slot */
|
| D | bamboo.dts | 281 /* Bamboo has all 4 IRQ pins tied together per slot */
|
| D | ebony.dts | 316 /* Ebony has all 4 IRQ pins tied together per slot */
|
| /Linux-v5.4/Documentation/virt/kvm/arm/ |
| D | psci.txt | 11 a given guest is tied to a particular PSCI revision (unlikely), or if
|
| /Linux-v5.4/Documentation/devicetree/bindings/spi/ |
| D | spi-davinci.txt | 23 lines can be tied to the interrupt controller. Set this
|
| /Linux-v5.4/Documentation/media/uapi/v4l/ |
| D | pixfmt-meta-intel-ipu3.rst | 73 Both 3A statistics and pipeline parameters described here are closely tied to
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | armada-388-clearfog.dtsi | 192 * address pins tied low, which takes addresses 0x50 and 0x51.
|
| D | sun7i-a20-bananapi-m1-plus.dts | 262 /* VBUS on usb host ports are tied to DC5V and therefore always on */
|
| /Linux-v5.4/Documentation/fb/ |
| D | ep93xx-fb.rst | 127 the VIDSCRNPAGE (framebuffer physical offset) to be tied low. There is
|
| /Linux-v5.4/Documentation/media/v4l-drivers/ |
| D | cx88.rst | 118 GPIO 16(I believe) is tied to the IR port (if present).
|
| /Linux-v5.4/Documentation/devicetree/bindings/media/ |
| D | renesas,drif.txt | 21 The internal channels sharing the CLK & SYNC are tied together by their
|
| /Linux-v5.4/Documentation/filesystems/ext4/ |
| D | blockgroup.rst | 66 (flex\_bg). In a flex\_bg, several block groups are tied together as one
|
| /Linux-v5.4/Documentation/core-api/ |
| D | xarray.rst | 440 on every index that is tied together. The current implementation
442 eg indices 64-127 may be tied together, but 2-6 may not be. This may
|
12
