| /Linux-v5.4/drivers/power/supply/ |
| D | da9030_battery.c | 100 struct da9030_battery_thresholds thresholds; member
257 charger->thresholds.vbat_charge_start)) { in da9030_charger_check_state()
268 charger->thresholds.vbat_charge_stop) { in da9030_charger_check_state()
271 charger->thresholds.vbat_charge_restart); in da9030_charger_check_state()
273 charger->thresholds.vbat_low) { in da9030_charger_check_state()
278 charger->thresholds.vbat_low); in da9030_charger_check_state()
280 if (charger->adc.vchmax_res > charger->thresholds.vcharge_max || in da9030_charger_check_state()
281 charger->adc.vchmin_res < charger->thresholds.vcharge_min || in da9030_charger_check_state()
283 charger->adc.tbat_res < charger->thresholds.tbat_high || in da9030_charger_check_state()
284 charger->adc.tbat_res > charger->thresholds.tbat_low) { in da9030_charger_check_state()
[all …]
|
| /Linux-v5.4/Documentation/media/uapi/v4l/ |
| D | ext-ctrls-detect.rst | 45 detection threshold. These thresholds are set through the
49 value that specifies which per-region motion detection thresholds
50 should be used. Each region has its own thresholds. How these
51 per-region thresholds are set up is driver-specific. The region
62 Sets the motion detection thresholds for each cell in the grid. To
|
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-light-lm3533-als | 6 Event generated when channel passes one of the four thresholds
16 Get the hysteresis for thresholds Y, that is,
32 These thresholds correspond to the eight zone-boundary
42 in_illuminance0_threshY_{falling,rising} thresholds.
|
| D | sysfs-bus-iio-adc-hi8435 | 23 Hysteresis between low and high thresholds can not be lower then 2 and
40 Hysteresis between low and high thresholds can not be lower then 2 and
|
| /Linux-v5.4/Documentation/driver-api/thermal/ |
| D | nouveau_thermal.rst | 29 temperature thresholds:
41 Some of these thresholds may not be used by Nouveau depending
44 The default value for these thresholds comes from the GPU's vbios. These
45 thresholds can be configured thanks to the following HWMON attributes:
|
| /Linux-v5.4/Documentation/hwmon/ |
| D | lm92.rst | 43 alarms for high, low, and critical thresholds. There's also an hysteresis to
44 control the thresholds for resetting alarms.
|
| D | smsc47m192.rst | 78 in[0-7]_max lower and upper alarm thresholds for in[0-7]_input reading
90 temp[1-3]_max lower and upper alarm thresholds for temperatures
|
| D | jc42.rst | 124 and critical thresholds.
126 There is also an hysteresis to control the thresholds for resetting alarms.
|
| D | lm70.rst | 54 The TMP122/TMP124 also feature configurable temperature thresholds.
|
| /Linux-v5.4/drivers/gpu/drm/nouveau/nvkm/subdev/therm/ |
| D | temp.c | 86 static const char * const thresholds[] = { in nvkm_therm_sensor_event() local
97 temperature, thresholds[thrs]); in nvkm_therm_sensor_event()
100 temperature, thresholds[thrs]); in nvkm_therm_sensor_event()
|
| /Linux-v5.4/drivers/net/ethernet/netronome/nfp/abm/ |
| D | main.c | 477 abm->thresholds = kvcalloc(abm->num_thresholds, in nfp_abm_init()
478 sizeof(*abm->thresholds), GFP_KERNEL); in nfp_abm_init()
479 if (!abm->thresholds) in nfp_abm_init()
510 kvfree(abm->thresholds); in nfp_abm_init()
528 kvfree(abm->thresholds); in nfp_abm_clean()
|
| D | main.h | 72 u32 *thresholds; member
|
| /Linux-v5.4/mm/ |
| D | memcontrol.c | 3983 t = rcu_dereference(memcg->thresholds.primary); in __mem_cgroup_threshold()
4075 struct mem_cgroup_thresholds *thresholds; in __mem_cgroup_usage_register_event() local
4088 thresholds = &memcg->thresholds; in __mem_cgroup_usage_register_event()
4091 thresholds = &memcg->memsw_thresholds; in __mem_cgroup_usage_register_event()
4097 if (thresholds->primary) in __mem_cgroup_usage_register_event()
4100 size = thresholds->primary ? thresholds->primary->size + 1 : 1; in __mem_cgroup_usage_register_event()
4111 if (thresholds->primary) { in __mem_cgroup_usage_register_event()
4112 memcpy(new->entries, thresholds->primary->entries, (size - 1) * in __mem_cgroup_usage_register_event()
4139 kfree(thresholds->spare); in __mem_cgroup_usage_register_event()
4140 thresholds->spare = thresholds->primary; in __mem_cgroup_usage_register_event()
[all …]
|
| /Linux-v5.4/drivers/net/wireless/intel/iwlwifi/fw/api/ |
| D | phy.h | 262 __le16 thresholds[IWL_MAX_DTS_TRIPS]; member
|
| /Linux-v5.4/Documentation/networking/ |
| D | xfrm_sync.txt | 21 the events. i.e we are going to set thresholds to say "let me
23 These thresholds are set system-wide via sysctls or can be updated
105 Programs installing SAs will need to specify the two thresholds, however,
147 thresholds for an SA using XFRM_MSG_NEWAE (as described in #i above).
|
| D | dctcp.txt | 15 thresholds. The default ECN marking threshold heuristic for DCTCP on
|
| /Linux-v5.4/include/linux/ |
| D | fsl-diu-fb.h | 152 __be32 thresholds; member
|
| /Linux-v5.4/drivers/media/pci/solo6x10/ |
| D | solo6x10-disp.c | 201 const u16 *thresholds) in solo_set_motion_block() argument
214 buf[x] = cpu_to_le16(thresholds[y * SOLO_MOTION_SZ + x]); in solo_set_motion_block()
|
| /Linux-v5.4/Documentation/admin-guide/cgroup-v1/ |
| D | memcg_test.rst | 333 9.10 Memory thresholds
336 Memory controller implements memory thresholds using cgroups notification
351 the thresholds.
353 Use /cgroup/A/memory.memsw.usage_in_bytes to test memsw thresholds.
|
| /Linux-v5.4/Documentation/input/devices/ |
| D | ntrig.rst | 93 events until it hits thresholds and begins propagating. In the interest in
103 Setting the activation size thresholds to large values will result in deciding
105 activation slack while reducing the size thresholds may suffice to eliminate
|
| /Linux-v5.4/sound/soc/codecs/ |
| D | cs42l42.c | 1574 unsigned int thresholds[CS42L42_NUM_BIASES]; in cs42l42_handle_device_data() local
1694 (u32 *)thresholds, CS42L42_NUM_BIASES); in cs42l42_handle_device_data()
1698 if ((thresholds[i] >= CS42L42_HS_DET_LEVEL_MIN) && in cs42l42_handle_device_data()
1699 (thresholds[i] <= CS42L42_HS_DET_LEVEL_MAX)) in cs42l42_handle_device_data()
1700 cs42l42->bias_thresholds[i] = thresholds[i]; in cs42l42_handle_device_data()
1704 thresholds[i]); in cs42l42_handle_device_data()
|
| /Linux-v5.4/drivers/net/wireless/intel/iwlwifi/mvm/ |
| D | tt.c | 579 cmd.thresholds[idx++] = in iwl_mvm_send_temp_report_ths_cmd()
589 sort(cmd.thresholds, idx, sizeof(s16), compare_temps, NULL); in iwl_mvm_send_temp_report_ths_cmd()
596 if (le16_to_cpu(cmd.thresholds[i]) == in iwl_mvm_send_temp_report_ths_cmd()
|
| /Linux-v5.4/Documentation/devicetree/bindings/sound/ |
| D | cs43130.txt | 36 Define 2 DC impedance thresholds in ohms for HP output control.
|
| /Linux-v5.4/Documentation/devicetree/bindings/iio/light/ |
| D | us5182d.txt | 11 - upisemi,dark-ths: array of 8 elements containing 16-bit thresholds (adc
|
| /Linux-v5.4/drivers/staging/comedi/drivers/ |
| D | jr3_pci.h | 241 struct thresh_struct thresholds[4]; member
|
