| /Linux-v5.4/Documentation/devicetree/bindings/clock/ |
| D | ti,cdce925.txt | 30 For all PLL1, PLL2, ... an optional child node can be used to specify spread
32 - spread-spectrum: SSC mode as defined in the data sheet.
33 - spread-spectrum-center: Use "centered" mode instead of "max" mode. When
50 spread-spectrum = <4>;
51 spread-spectrum-center;
|
| D | marvell,berlin.txt | 7 Clock related registers are spread among the chip control registers. Berlin
|
| /Linux-v5.4/Documentation/misc-devices/ |
| D | ics932s401.rst | 25 frequency. If spread spectrum mode is enabled, the driver also reports by what
26 percent the clock signal is being spread, which should be between 0 and -0.5%.
|
| /Linux-v5.4/Documentation/devicetree/bindings/ata/ |
| D | imx-sata.txt | 24 - fsl,no-spread-spectrum : disable spread-spectrum clocking on the SATA
|
| /Linux-v5.4/Documentation/devicetree/bindings/phy/ |
| D | rcar-gen3-phy-usb3.txt | 5 If you want to enable spread spectrum clock (ssc), you should use USB_EXTAL
35 - renesas,ssc-range: Enable/disable spread spectrum clock (ssc) by using
|
| D | brcm-sata-phy.txt | 27 - brcm,enable-ssc: use spread spectrum clocking (SSC) on this port
|
| /Linux-v5.4/fs/udf/ |
| D | balloc.c | 563 uint32_t spread = 0xFFFFFFFF, nspread = 0xFFFFFFFF; in udf_table_new_block() local
594 while (spread && in udf_table_new_block()
607 if (nspread < spread) { in udf_table_new_block()
608 spread = nspread; in udf_table_new_block()
623 if (spread == 0xFFFFFFFF) { in udf_table_new_block()
|
| /Linux-v5.4/drivers/gpu/drm/bridge/ |
| D | tc358767.c | 234 bool spread; member
438 if (tc->link.spread) in tc_srcctrl()
685 tc->link.spread = reg & DP_MAX_DOWNSPREAD_0_5; in tc_get_display_props()
705 tc->link.spread ? "0.5%" : "0.0%", in tc_get_display_props()
903 (tc->link.spread ? DP0_SRCCTRL_SSCG : 0) | in tc_main_link_enable()
982 tmp[0] = tc->link.spread ? DP_SPREAD_AMP_0_5 : 0x00; in tc_main_link_enable()
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | imx6q-dms-ba16.dts | 113 fsl,no-spread-spectrum;
|
| D | imx6q-cubox-i-emmc-som-v15.dts | 59 fsl,no-spread-spectrum;
|
| D | imx6q-cubox-i-som-v15.dts | 58 fsl,no-spread-spectrum;
|
| D | imx6q-cubox-i.dts | 58 fsl,no-spread-spectrum;
|
| D | imx6q-hummingboard2-emmc-som-v15.dts | 62 fsl,no-spread-spectrum;
|
| D | imx6q-hummingboard2-som-v15.dts | 61 fsl,no-spread-spectrum;
|
| D | imx6q-hummingboard2.dts | 60 fsl,no-spread-spectrum;
|
| /Linux-v5.4/Documentation/devicetree/bindings/pinctrl/ |
| D | pinctrl-zx.txt | 40 the pin spread in both controllers. This type of pins are called 'AON pins'.
|
| /Linux-v5.4/Documentation/admin-guide/device-mapper/ |
| D | switch.rst | 22 is created it is spread across multiple members. The details of the
44 spread with an address region size on the order of 10s of MBs, which
|
| /Linux-v5.4/Documentation/admin-guide/cgroup-v1/ |
| D | cpusets.rst | 23 1.6 What is memory spread ?
179 - cpuset.memory_spread_page flag: if set, spread page cache evenly on allowed nodes
180 - cpuset.memory_spread_slab flag: if set, spread slab cache evenly on allowed nodes
306 1.6 What is memory spread ?
314 the kernel will spread the file system buffers (page cache) evenly
319 then the kernel will spread some file system related slab caches,
332 When new cpusets are created, they inherit the memory spread settings
336 or slab caches to ignore the task's NUMA mempolicy and be spread
339 their containing task's memory spread settings. If memory spreading
370 to access large file system data sets that need to be spread across
|
| /Linux-v5.4/kernel/irq/ |
| D | Kconfig | 122 ( Sparse irqs can also be beneficial on NUMA boxes, as they spread
|
| /Linux-v5.4/kernel/sched/ |
| D | debug.c | 486 spread, rq0_min_vruntime, spread0; in print_cfs_rq() local
516 spread = max_vruntime - MIN_vruntime; in print_cfs_rq()
518 SPLIT_NS(spread)); in print_cfs_rq()
|
| /Linux-v5.4/tools/perf/Documentation/ |
| D | callchain-overhead-calculation.txt | 19 spread over the children.
|
| /Linux-v5.4/Documentation/mips/ |
| D | ingenic-tcu.rst | 55 The functionalities of the TCU hardware are spread across multiple drivers:
|
| /Linux-v5.4/Documentation/devicetree/bindings/arm/ |
| D | syna.txt | 68 CPU boot address. Unfortunately, the individual registers are spread among the
|
| /Linux-v5.4/include/uapi/linux/ |
| D | omap3isp.h | 607 __u8 spread; member
|
| /Linux-v5.4/Documentation/filesystems/ext4/ |
| D | allocators.rst | 48 block group that it can find. This encourages directories to spread out
|
