Searched refs:sampling (Results 1 – 25 of 122) sorted by relevance
12345
| /Linux-v5.4/drivers/media/pci/cx88/ |
| D | cx88-input.c | 36 u32 sampling; member
199 if (ir->sampling) { in __cx88_ir_start()
216 if (ir->sampling) { in __cx88_ir_stop()
291 ir->sampling = 0xeb04; /* address */ in cx88_ir_init()
305 ir->sampling = 1; in cx88_ir_init()
397 ir->sampling = 0xff00; /* address */ in cx88_ir_init()
403 ir->sampling = 0xff00; /* address */ in cx88_ir_init()
407 ir->sampling = 0xff00; /* address */ in cx88_ir_init()
424 ir->sampling = 1; in cx88_ir_init()
434 ir->sampling = 0xff00; /* address */ in cx88_ir_init()
[all …]
|
| /Linux-v5.4/net/psample/ |
| D | Kconfig | 3 # psample packet sampling configuration
8 tristate "Packet-sampling netlink channel"
11 Say Y here to add support for packet-sampling netlink channel
|
| /Linux-v5.4/Documentation/devicetree/bindings/staging/iio/adc/ |
| D | spear-adc.txt | 7 - sampling-frequency: Default sampling frequency
22 sampling-frequency = <5000000>;
|
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | configfs-usb-gadget-uac2 | 8 c_srate - capture sampling rate
11 p_srate - playback sampling rate
|
| D | configfs-usb-gadget-uac1 | 8 c_srate - capture sampling rate
11 p_srate - playback sampling rate
|
| D | sysfs-bus-iio-timer-stm32 | 79 Reading returns the current sampling frequency.
80 Writing an value different of 0 set and start sampling.
81 Writing 0 stop sampling.
|
| /Linux-v5.4/tools/perf/tests/attr/ |
| D | test-record-group-sampling | 32 # inherit is disabled for group sampling
35 # sampling disabled
|
| /Linux-v5.4/Documentation/devicetree/bindings/iio/adc/ |
| D | amlogic,meson-saradc.txt | 15 - interrupts: the interrupt indicating end of sampling
21 - "adc_clk" for the ADC (sampling) clock
22 - "adc_sel" for the ADC (sampling) clock mux
|
| D | at91-sama5d2_adc.txt | 11 - atmel,min-sample-rate-hz: Minimum sampling rate, it depends on SoC.
12 - atmel,max-sample-rate-hz: Maximum sampling rate, it depends on SoC.
|
| D | renesas,gyroadc.txt | 34 12bit sampling, up to 4 channels can be sampled in
45 15bit sampling, up to 8 channels can be sampled in
54 16bit sampling, up to 8 channels can be sampled in
|
| /Linux-v5.4/Documentation/devicetree/bindings/sound/ |
| D | nau8824.txt | 53 - nuvoton,sar-sampling-time: SAR sampling time
85 nuvoton,sar-sampling-time = <1>;
|
| D | nau8825.txt | 57 - nuvoton,sar-sampling-time: SAR sampling time
97 nuvoton,sar-sampling-time = <0>;
|
| D | st,stm32-i2s.txt | 15 "x8k": I2S parent clock for sampling rates multiple of 8kHz.
16 "x11k": I2S parent clock for sampling rates multiple of 11.025kHz.
|
| D | mt8173-rt5650.txt | 18 1 : internal source from mt8173, MCLK = sampling rate*256
|
| D | fsl,micfil.txt | 4 microphone bitstream in a configurable output sampling rate.
|
| /Linux-v5.4/Documentation/sound/cards/ |
| D | maya44.rst | 29 - playback and capture at all sampling rates
95 The Maya44 card (or more exactly, the Wolfson WM8776 codecs) allow a maximum sampling rate of 192 k…
97 As the ICE1724 chip only allows one global sampling rate, this is handled as follows:
99 * setting the sampling rate on any open PCM device on the maya44 card will always set the *global* …
106 …ditional code for limiting the sampling rate when setting on a capture pcm device. However because…
|
| /Linux-v5.4/arch/mips/kernel/ |
| D | entry.S | 50 # between sampling and return
87 # sampling and return
131 # sampling and return
|
| /Linux-v5.4/Documentation/devicetree/bindings/spi/ |
| D | spi-samsung.txt | 61 - samsung,spi-feedback-delay: The sampling phase shift to be applied on the
66 - 1: 90 degree phase shift sampling.
67 - 2: 180 degree phase shift sampling.
68 - 3: 270 degree phase shift sampling.
|
| /Linux-v5.4/Documentation/devicetree/bindings/mmc/ |
| D | cavium-mmc.txt | 22 - cavium,cmd-clk-skew : number of coprocessor clocks before sampling command
23 - cavium,dat-clk-skew : number of coprocessor clocks before sampling data
|
| /Linux-v5.4/tools/power/cpupower/bench/ |
| D | README-BENCH | 74 sampling rate you get:
79 In round 2, if the ondemand sampling times exactly match the load/sleep
91 |-----|-----|-----|-----|-----|-----|-----|---- ondemand sampling (1)
93 |-----|-----|-----|-----|-----|-----|-----|-- ondemand sampling (2)
|
| /Linux-v5.4/Documentation/media/uapi/v4l/ |
| D | dev-sdr.rst | 53 ADC/DAC sampling rate (sampling frequency) and the possible radio
70 capture and output format. Both the sampling resolution and the data
|
| /Linux-v5.4/Documentation/devicetree/bindings/phy/ |
| D | apm-xgene-phy.txt | 23 data earlier than the nominal sampling point. 1 means
24 sample data later than the nominal sampling point.
|
| /Linux-v5.4/tools/perf/Documentation/ |
| D | tips.txt | 28 To change sampling frequency to 100 Hz: perf record -F 100
42 To show IPC for sampling periods use perf record -e '{cycles,instructions}:S' and then browse conte…
|
| D | perf-top.txt | 223 Enable taken branch stack sampling. Any type of taken branch may be sampled.
228 Enable taken branch stack sampling. Each sample captures a series of consecutive
237 levels are subject to permissions. When sampling on multiple events, branch stack sampling
238 is enabled for all the sampling events. The sampled branch type is the same for all events.
|
| /Linux-v5.4/Documentation/hwmon/ |
| D | adt7410.rst | 59 continuous temperature sampling, as well as sampling one temperature value per
|
12345
