Home
last modified time | relevance | path

Searched refs:reception (Results 1 – 25 of 69) sorted by relevance

123

/Linux-v5.4/Documentation/ABI/stable/
Dfirewire-cdev24 - Isochronous stream transmission and reception
25 - Asynchronous stream transmission and reception
27 - PHY packet transmission and reception
33 - Bus reset initiation, bus reset event reception
36 link layers, reception of inbound requests to such
48 - PHY packet transmission and reception
73 request reception, or PHY packet reception. Always use a read
76 of all event types and for which ioctls affect reception of
80 Allocate a DMA buffer for isochronous reception or transmission
84 prot = at least PROT_READ for reception and at least PROT_WRITE
[all …]
/Linux-v5.4/Documentation/ABI/testing/
Dsysfs-class-led-trigger-netdev42 Signal reception of data on the named network device.
43 If set to 0 (default), the LED will not blink on reception.
45 in interval to signal reception.
/Linux-v5.4/drivers/staging/pi433/Documentation/
Dpi433.txt9 (www.pi433.de). It supports transmission and reception. It can be opened
10 by multiple applications for transmission and reception. While transmit
12 application asking for reception will block out all other applications
40 b) reception
43 reception there is only one configuration set.
44 As soon as an application sets a request for receiving a telegram, the reception
47 receiver) is reached. Until this hasn't happened, the reception can be
52 read. So also for reception it is possible to receive more data than the hardware
181 If this value is exceeded, a reception cycle starts
/Linux-v5.4/Documentation/devicetree/bindings/media/
Dgpio-ir-receiver.txt5 - gpios: specifies GPIO used for IR signal reception.
/Linux-v5.4/Documentation/devicetree/bindings/sound/
Dsirf-audio-port.txt11 named "tx") and one for reception (should be named "rx").
Dbrcm,bcm2835-i2s.txt12 named "tx") and one for reception (should be named "rx").
Dsirf-usp.txt11 named "tx") and one for reception (should be named "rx").
/Linux-v5.4/Documentation/media/uapi/v4l/
Dext-ctrls-fm-rx.rst31 Enables/disables RDS reception by the radio tuner
78 Configures the de-emphasis value for reception. A de-emphasis filter
Dvidioc-g-tuner.rst256 - Stereo audio reception is supported.
373 stereo reception the driver shall fall back to ``MODE_MONO``.
381 bilingual audio or SAP, or their reception is not supported the
387 bilingual audio or SAP, or their reception is not supported the
Dpixfmt-meta-uvc.rst47 reception of the payload
/Linux-v5.4/Documentation/media/uapi/rc/
Dlirc-set-wideband-receiver.rst48 reduced range of reception.
/Linux-v5.4/Documentation/media/
Dintro.rst29 Internet reception via one of the several digital tv standards. While it is
/Linux-v5.4/Documentation/devicetree/bindings/i2c/
Drenesas,iic.txt51 reception.
Drenesas,i2c.txt45 transmission, and one for reception.
/Linux-v5.4/Documentation/devicetree/bindings/spi/
Dspi-rspi.txt41 one for transmission, and one for reception.
Dsh-msiof.txt63 reception.
/Linux-v5.4/drivers/usb/atm/
DKconfig62 and reception as module parameters. You may need to initialize
/Linux-v5.4/drivers/staging/qlge/
DTODO1 * reception stalls permanently (until admin intervention) if the rx buffer
/Linux-v5.4/Documentation/devicetree/bindings/serial/
Dqcom,msm-uartdm.txt33 used with RX DMA channel. Required when using DMA for reception
/Linux-v5.4/arch/sh/include/mach-kfr2r09/mach/
Dpartner-jet-setup.txt32 LIST "RF frequency and improved reception sensitivity."
/Linux-v5.4/Documentation/media/v4l-drivers/
Dv4l-with-ir.rst26 switch the protocol and to test the reception of scan codes;
/Linux-v5.4/Documentation/networking/
Dcan.rst164 transmission and reception of media dependent frames. Due to the
166 may be delayed by the reception of a high prio CAN frame. To
201 errors may be selected. The reception of error messages is disabled
362 at the reception of a CAN frame.
439 The reception of CAN frames using CAN_RAW sockets can be controlled
474 To disable the reception of CAN frames on the selected CAN_RAW socket:
489 reception time. To reduce the number of checks that need to be performed
566 needs. The reception of the CAN frames on the same socket that was
892 is activated directly - even without a former CAN frame reception.
1125 The virtual CAN interfaces allow the transmission and reception of CAN
/Linux-v5.4/tools/bpf/bpftool/Documentation/
Dbpftool-net.rst65 **xdpoffload** - Offload XDP. runs directly on NIC on each packet reception;
/Linux-v5.4/Documentation/media/uapi/dvb/
Dfe_property_parameters.rst286 whether the channel is in partial reception mode or not.
409 Hierarchical reception in ISDB-T is achieved by enabling or disabling
414 If the channel is in the partial reception mode
/Linux-v5.4/drivers/net/wireless/
Dwl3501.h484 u8 reception; member

123