Searched refs:rails (Results 1 – 22 of 22) sorted by relevance
117 list_for_each_entry(rail, &iccsense->rails, head) { in nvkm_iccsense_read_all()141 list_for_each_entry_safe(rail, tmpr, &iccsense->rails, head) { in nvkm_iccsense_dtor()291 list_add_tail(&rail->head, &iccsense->rails); in nvkm_iccsense_oneinit()328 INIT_LIST_HEAD(&(*iccsense)->rails); in nvkm_iccsense_new_()
11 struct list_head rails; member
10 three independent power rails.
22 entry then driver will just configure this rails as external control
16 power rails when PMIC_STBY_REQ line is asserted during the power off sequence.
20 * In general an attempt is made to include all rails called out by21 * the schematic as long as those rails interact in some way with25 * - Rails _are_ included if the rails go to the AP even if the AP30 * If two rails are substantially the same from the AP's point of32 * put the child rail as an alias of the parent rail. Sometimes rails36 * - The rails are actually connected to each other by a jumper and
108 rails. See chip datasheets for details.114 created for enabled rails. See chip datasheets for
14 rails provided to the minicards. The Current Monitor does not require any
29 sequences up to 12 independent voltage rails. The device integrates a 12-bit
6 if DDR power rails will be kept powered during system suspend.
30 rails need to be kept powered when backup mode is
122 GPIO1/nRST_IO pins are HIGH only if all rails124 If any of the rails goes down(which are enabled for POK
127 AS3722 supports the system power off by turning off all its rails.
481 power rails and an LDO.610 This driver supports the control of different power rails of device619 This driver supports the control of different power rails of device628 This driver supports the control of different power rails of device637 This driver supports the control of different power rails of device646 This driver supports the control of different power rails of device772 This driver supports the control of different power rails of device782 This driver supports the control of different power rails of device
55 /* Common 1.8V and 3.3V rails, used by several devices on APE6EVM */
15 /* Name the GPIO muxed rails on the HREF boards */
93 /* Name the GPIO muxed rails on the Snowball board */
134 0x10 afcrl Flag indicating if AFC rails
108 that corresponding clocks and/or power-rails can be turned off to save power.
303 if (!iccsense || !iccsense->data_valid || list_empty(&iccsense->rails)) in nouveau_power_is_visible()
141 clock/voltage rails with it).
512 to control power rails and sensor reading/writing on the
