Searched refs:proximity (Results 1 – 25 of 34) sorted by relevance
12
| /Linux-v5.4/Documentation/misc-devices/ |
| D | bh1770glc.txt | 16 BH1770GLC and SFH7770 are combined ambient light and proximity sensors.
17 ALS and proximity parts operates on their own, but they shares common I2C
19 but ALS side results are used to estimate reliability of the proximity sensor.
25 amount of reflected IR light and produces proximity result. Resolution is
27 reliability of the proximity results. Thus ALS is always running while
28 proximity detection is needed.
32 by using a delayed work. As long as there is proximity threshold above
33 interrupts the delayed work is pushed forward. So, when proximity level goes
35 finally run. This is handled as no proximity indication.
86 RO - measured proximity value
[all …]
|
| D | apds990x.txt | 16 APDS990x is a combined ambient light and proximity sensor. ALS and proximity
18 while the proximity functionality is enabled.
88 RO - measured proximity value
95 RW - enable / disable proximity - uses counting logic
96 1 enables the proximity
97 0 disables the proximity
101 values: 0 or prox0_sensor_range value. 0 means no proximity,
102 1023 means proximity. This causes minimal number of interrupts.
111 RW - threshold level which trigs proximity events.
|
| /Linux-v5.4/drivers/iio/light/ |
| D | Kconfig | 56 tristate "Avago APDS9960 gesture/RGB/ALS/proximity sensor"
63 APDS9960 gesture/RGB/ALS/proximity sensor.
121 tristate "Capella CM3605 ambient light and proximity sensor"
125 ambient light and short range proximity sensor.
135 This option enables proximity & RGB sensor using
145 Say Y here if you use the light and proximity sensors
159 Say Y here if you have a Sharp GP2AP020A00F proximity/ALS combo-chip
166 tristate "Intersil 29018 light and proximity sensor"
172 proximity infrared sensing from Intersil ISL29018.
174 in lux, proximity infrared sensing and normal infrared sensing.
[all …]
|
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-light-isl29018 | 9 Scheme 0, makes full n (4, 8, 12, 16) bits (unsigned) proximity
10 detection. The range of Scheme 0 proximity count is from 0 to
13 range of Scheme 1 proximity count is from -2^(n-1) to 2^(n-1).
15 Scheme 0 has wider dynamic range, Scheme 1 proximity detection
|
| /Linux-v5.4/Documentation/devicetree/bindings/iio/light/ |
| D | cm3605.txt | 7 This ALS and proximity sensor was one of the very first deployed in mobile
16 the POUT (proximity sensor out) line. The edge detection must
18 and away from the proximity sensor.
|
| D | vl6180.txt | 1 STMicro VL6180 - ALS, range and proximity sensor
|
| D | vcnl4035.txt | 1 VISHAY VCNL4035 - Ambient Light and proximity sensor
|
| D | apds9960.txt | 1 * Avago APDS9960 gesture/RGB/ALS/proximity sensor
|
| D | vcnl4000.txt | 1 VISHAY VCNL4000 - Ambient Light and proximity sensor
|
| D | gp2ap020a00f.txt | 3 The proximity detector sensor requires power supply
|
| D | cm36651.txt | 9 of the cm36651 for proximity detection.
|
| /Linux-v5.4/Documentation/driver-api/iio/ |
| D | intro.rst | 28 * proximity sensors
33 combined functionality (e.g. light plus proximity sensor).
|
| /Linux-v5.4/drivers/staging/iio/Documentation/ |
| D | sysfs-bus-iio-light | 14 in proximity mode. When this is enabled, then the device should
16 proximity reading. If this is not enabled, the driver can still
24 This property is supported by proximity sensors and should be
|
| /Linux-v5.4/Documentation/devicetree/bindings/iio/proximity/ |
| D | sx9500.txt | 1 Semtech's SX9500 capacitive proximity button device driver
|
| D | maxbotix,mb1232.txt | 24 proximity@70 {
|
| /Linux-v5.4/drivers/iio/ |
| D | Makefile | 37 obj-y += proximity/
|
| D | Kconfig | 94 source "drivers/iio/proximity/Kconfig"
|
| /Linux-v5.4/drivers/iio/proximity/ |
| D | Kconfig | 90 tristate "SX9500 Semtech proximity sensor"
97 proximity/button sensor.
|
| /Linux-v5.4/Documentation/hwmon/ |
| D | ltc4261.rst | 56 the proximity of the ADIN2 pin to the OV pin. ADIN2 is, however, not available
|
| /Linux-v5.4/Documentation/input/ |
| D | event-codes.rst | 226 proximity of the device and while the value of the BTN_TOUCH code is 0. If
230 proximity and set to 0 when the tool leaves detectable proximity.
|
| /Linux-v5.4/drivers/misc/ |
| D | Kconfig | 333 SFH7770 (Osram) combined ambient light and proximity sensor chip.
339 tristate "APDS990X combined als and proximity sensors"
343 combined ambient light and proximity sensor chip.
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | imx6sx-softing-vining-2000.dts | 164 proximity: sx9500@28 { label
|
| D | qcom-apq8060-dragonboard.dts | 88 * Capella CM3605 light and proximity sensor mounted directly
427 * ambient light and proximity sensor
|
| D | qcom-msm8974-lge-nexus5-hammerhead.dts | 549 amstaos,proximity-diodes = <0>;
|
| D | tegra20-ventana.dts | 348 /* ALS and proximity sensor */
|
12
