Home
last modified time | relevance | path

Searched refs:pci_warn (Results 1 – 22 of 22) sorted by relevance

/Linux-v5.4/drivers/pci/hotplug/
Dpnv_php.c274 pci_warn(php_slot->pdev, "Error %d getting FDT blob\n", ret); in pnv_php_add_devtree()
288 pci_warn(php_slot->pdev, "Cannot unflatten FDT\n"); in pnv_php_add_devtree()
298 pci_warn(php_slot->pdev, "Error %d populating changeset\n", in pnv_php_add_devtree()
306 pci_warn(php_slot->pdev, "Error %d applying changeset\n", ret); in pnv_php_add_devtree()
347 pci_warn(php_slot->pdev, "Wrong msg (%lld, %lld, %lld)\n", in pnv_php_set_slot_power_state()
354 pci_warn(php_slot->pdev, "Error %d powering %s\n", in pnv_php_set_slot_power_state()
381 pci_warn(php_slot->pdev, "Error %d getting power status\n", in pnv_php_get_power_state()
405 pci_warn(php_slot->pdev, "Error %d getting presence\n", ret); in pnv_php_get_adapter_state()
678 pci_warn(php_slot->pdev, "Error %d registering slot\n", ret); in pnv_php_register_slot()
731 pci_warn(pdev, "Error %d enabling MSIx\n", ret); in pnv_php_enable_msix()
[all …]
Dpciehp.h42 pci_warn(ctrl->pcie->port, format, ## arg)
Dshpchp.h59 pci_warn(ctrl->pci_dev, format, ## arg)
/Linux-v5.4/drivers/pci/
Dquirks.c957 pci_warn(dev, "TI XIO2000a quirk detected; secondary bus fast back-to-back transfers disabled\n"); in quirk_xio2000a()
1028 pci_warn(dev, "I/O APIC: AMD Erratum #22 may be present. In the event of instability try\n"); in quirk_amd_ioapic()
1029 pci_warn(dev, " : booting with the \"noapic\" option\n"); in quirk_amd_ioapic()
1204 pci_warn(dev, "BIOS failed to enable PCI standards compliance; fixing this error\n"); in quirk_amd_ordering()
1835 pci_warn(dev, "PXH quirk detected; SHPC device MSI disabled\n"); in quirk_pcie_pxh()
2207 pci_warn(dev, "Can't map e100 registers\n"); in quirk_e100_interrupt()
2213 pci_warn(dev, "Firmware left e100 interrupts enabled; disabling\n"); in quirk_e100_interrupt()
2441 pci_warn(dev, "MSI quirk detected; MSI disabled\n"); in quirk_disable_all_msi()
2456 pci_warn(dev, "MSI quirk detected; subordinate MSI disabled\n"); in quirk_disable_msi()
2514 pci_warn(dev, "MSI quirk detected; subordinate MSI disabled\n"); in quirk_msi_ht_cap()
[all …]
Dvpd.c101 pci_warn(dev, "invalid large VPD tag %02x size at offset %zu", in pci_vpd_size()
121 pci_warn(dev, "invalid %s VPD tag %02x at offset %zu", in pci_vpd_size()
171 …pci_warn(dev, "VPD access failed. This is likely a firmware bug on this device. Contact the card… in pci_vpd_wait()
557 pci_warn(dev, FW_BUG "disabling VPD access (can't determine size of non-standard VPD format)\n"); in quirk_blacklist_vpd()
Dp2pdma.c494 pci_warn(client, "ACS redirect is set between the client and provider (%s)\n", in upstream_bridge_distance_warn()
498 …pci_warn(client, "to disable ACS redirect for this path, add the kernel parameter: pci=disable_acs… in upstream_bridge_distance_warn()
503 …pci_warn(client, "cannot be used for peer-to-peer DMA as the client and provider (%s) do not share… in upstream_bridge_distance_warn()
Diov.c303 pci_warn(pdev, "%d VFs already enabled. Disable before enabling %d VFs\n", in sriov_numvfs_store()
314 pci_warn(pdev, "%d VFs requested; only %d enabled\n", in sriov_numvfs_store()
780 pci_warn(dev, "driver left SR-IOV enabled after remove\n"); in pci_iov_remove()
1060 pci_warn(dev, "Cannot modify SR-IOV while VFs are assigned\n"); in pci_sriov_configure_simple()
Dpci-acpi.c145 pci_warn(dev, "PCI settings rev %d not supported; using defaults\n", in program_hpx_type0()
217 pci_warn(dev, "PCI-X settings not supported\n"); in program_hpx_type1()
295 pci_warn(dev, "PCIe settings rev %d not supported\n", in program_hpx_type2()
533 pci_warn(dev, "Encountered _HPX type 3 with unsupported config space location"); in program_hpx_type3_register()
Dbus.c326 pci_warn(dev, "device attach failed (%d)\n", retval); in pci_bus_add_device()
Dprobe.c1168 pci_warn(dev, "Primary bus is hard wired to 0\n"); in pci_scan_bridge_extend()
1220 pci_warn(dev, "bridge has subordinate %02x but max busn %02x\n", in pci_scan_bridge_extend()
1899 …pci_warn(dev, "Max Payload Size %d, but upstream %s set to %d; if necessary, use \"pci=pcie_bus_sa… in pci_configure_mps()
1921 …pci_warn(dev, "can't set Max Payload Size to %d; if necessary, use \"pci=pcie_bus_safe\" and repor… in pci_configure_mps()
2640 pci_warn(dev, "Failed attempting to set the MRRS\n"); in pcie_write_mrrs()
Dpci.c176 pci_warn(pdev, "can't ioremap BAR %d: %pR\n", bar, res); in pci_ioremap_bar()
2182 pci_warn(dev, "can't enable PME#\n"); in pci_pme_active()
3221 …pci_warn(dev, "cannot disable ACS redirect for this hardware as it does not have ACS capabilities\… in pci_disable_acs_redir()
3732 pci_warn(pdev, "BAR %d: can't reserve %pR\n", bar, in __pci_request_region()
4451 pci_warn(dev, "not ready %dms after %s; giving up\n", in pci_dev_wait()
5881 pci_warn(dev, "Unable to allocate DMA alias mask\n"); in pci_add_dma_alias()
6092 pci_warn(dev, "Can't reassign resources to host bridge\n"); in pci_reassigndev_resource_alignment()
Dxen-pcifront.c285 pci_warn(dev, "MSI-X entry %d is invalid: %d!\n", in pci_frontend_enable_msix()
338 pci_warn(dev, "MSI entry is invalid: %d!\n", in pci_frontend_enable_msi()
Dsetup-bus.c147 pci_warn(dev, "BAR %d: %pR has bogus alignment\n", in pdev_sort_resources()
1029 pci_warn(dev, "disabling BAR %d: %pR (bad alignment %#llx)\n", in pbus_size_mem()
/Linux-v5.4/drivers/pci/pcie/
Ddpc.c114 pci_warn(pdev, "root port still busy\n"); in dpc_wait_rp_inactive()
242 pci_warn(pdev, "%s detected\n", in dpc_handler()
309 pci_warn(pdev, "request IRQ%d failed: %d\n", dev->irq, in dpc_probe()
Daer_inject.c403 pci_warn(dev, "The correctable error(s) is masked by device\n"); in aer_inject()
410 pci_warn(dev, "The uncorrectable error(s) is masked by device\n"); in aer_inject()
465 pci_warn(edev->port, "AER service is not initialized\n"); in aer_inject()
Daspm.c271 pci_warn(parent, "ASPM: current common clock configuration is broken, reconfiguring\n"); in pcie_aspm_configure_common_clock()
1086 pci_warn(pdev, "can't disable ASPM; OS doesn't have ASPM control\n"); in __pci_disable_link_state()
/Linux-v5.4/drivers/vfio/pci/
Dvfio_pci.c336 pci_warn(pdev, "Failed to setup Intel IGD regions\n"); in vfio_pci_enable()
345 pci_warn(pdev, "Failed to setup NVIDIA NV2 RAM region\n"); in vfio_pci_enable()
354 pci_warn(pdev, "Failed to setup NVIDIA NV2 ATSD region\n"); in vfio_pci_enable()
1271 pci_warn(pdev, in vfio_pci_request()
1310 pci_warn(pdev, "Cannot bind to PF with SR-IOV enabled\n"); in vfio_pci_probe()
Dvfio_pci_config.c1297 pci_warn(pdev, "%s: unknown length for PCI cap %#x@%#x\n", in vfio_cap_len()
1371 pci_warn(pdev, "%s: unknown length for PCI ecap %#x@%#x\n", in vfio_ext_cap_len()
1485 pci_warn(pdev, "%s: PCI config conflict @%#x, was cap %#x now cap %#x\n", in vfio_cap_init()
1570 pci_warn(pdev, "%s: PCI config conflict @%#x, was ecap %#x now ecap %#x\n", in vfio_ecap_init()
1695 pci_warn(pdev, in vfio_config_init()
/Linux-v5.4/drivers/dma/dw-edma/
Ddw-edma-pcie.c206 pci_warn(pdev, "can't remove device properly: %d\n", err); in dw_edma_pcie_remove()
/Linux-v5.4/arch/powerpc/platforms/pseries/
Dsetup.c676 pci_warn(pdev, "No hypervisor support for SR-IOV on this device, IOV BARs disabled.\n"); in pseries_disable_sriov_resources()
/Linux-v5.4/drivers/video/fbdev/core/
Dfbmem.c1800 pci_warn(pdev, "%s: passed res_id (%d) is not a memory bar\n", in remove_conflicting_pci_framebuffers()
/Linux-v5.4/include/linux/
Dpci.h2392 #define pci_warn(pdev, fmt, arg...) dev_warn(&(pdev)->dev, fmt, ##arg) macro