Searched refs:numbered (Results 1 – 25 of 125) sorted by relevance
12345
| /Linux-v5.4/Documentation/devicetree/bindings/display/bridge/ |
| D | renesas,dw-hdmi.txt | 30 - ports: See dw_hdmi.txt. The DWC HDMI shall have one port numbered 0
31 corresponding to the video input of the controller and one port numbered 1
32 corresponding to its HDMI output, and one port numbered 2 corresponding to
|
| D | thine,thc63lvd1024.txt | 33 endpoint. In dual-link mode, even-numbered pixels are received on port@0 and
34 odd-numbered pixels on port@1, and both port@0 and port@1 shall contain
|
| /Linux-v5.4/Documentation/hid/ |
| D | hidraw.rst | 50 On a device which uses numbered reports, the first byte of the returned data
52 byte. For devices which do not use numbered reports, the report data
63 number. If the device does not use numbered reports, the first byte should
116 which do not use numbered reports, set the first byte to 0. The report data
125 number of the requested report. For devices which do not use numbered
|
| /Linux-v5.4/Documentation/filesystems/ext4/ |
| D | index.rst | 9 :numbered:
|
| /Linux-v5.4/Documentation/mips/ |
| D | index.rst | 9 :numbered:
|
| /Linux-v5.4/Documentation/input/ |
| D | input_kapi.rst | 13 :numbered:
|
| D | input_uapi.rst | 13 :numbered:
|
| /Linux-v5.4/Documentation/devicetree/bindings/media/ |
| D | cdns,csi2rx.txt | 26 port nodes are numbered as follows:
39 the endpoints are not numbered.
|
| D | cdns,csi2tx.txt | 26 port nodes are numbered as follows.
39 the endpoints are not numbered.
|
| D | st,stih4xx.txt | 25 Each BDISP should have a numbered alias in the aliases node, in the form of
|
| /Linux-v5.4/Documentation/PCI/ |
| D | index.rst | 9 :numbered:
|
| /Linux-v5.4/Documentation/input/devices/ |
| D | index.rst | 9 :numbered:
|
| /Linux-v5.4/Documentation/translations/zh_CN/process/ |
| D | development-process.rst | 14 :numbered:
|
| /Linux-v5.4/Documentation/devicetree/bindings/pinctrl/ |
| D | pinctrl-mt65xx.txt | 15 - pins-are-numbered: Specify the subnodes are using numbered pinmux to
94 pins-are-numbered;
|
| /Linux-v5.4/Documentation/x86/ |
| D | index.rst | 9 :numbered:
|
| /Linux-v5.4/Documentation/devicetree/bindings/net/ |
| D | mdio-gpio.txt | 11 Note: Each gpio-mdio bus should have an alias correctly numbered in "aliases"
|
| /Linux-v5.4/Documentation/devicetree/bindings/display/rockchip/ |
| D | dw_hdmi-rockchip.txt | 24 - ports: See dw_hdmi.txt. The DWC HDMI shall have a single port numbered 0
26 endpoints, numbered 0 and 1, connected respectively to the vopb and vopl.
|
| /Linux-v5.4/Documentation/devicetree/bindings/timer/ |
| D | cirrus,clps711x-timer.txt | 9 Note: Each timer should have an alias correctly numbered in "aliases" node.
|
| /Linux-v5.4/Documentation/devicetree/bindings/serial/ |
| D | arc-uart.txt | 20 Note: Each port should have an alias correctly numbered in "aliases" node.
|
| D | qca,ar9330-uart.txt | 16 Each UART port must have an alias correctly numbered in "aliases"
|
| D | digicolor-usart.txt | 14 Note: Each UART port should have an alias correctly numbered
|
| /Linux-v5.4/Documentation/iio/ |
| D | ep93xx_adc.rst | 17 not defined. So the last three are numbered randomly, let's say.
|
| /Linux-v5.4/Documentation/process/ |
| D | development-process.rst | 9 :numbered:
|
| /Linux-v5.4/Documentation/devicetree/bindings/gpio/ |
| D | gpio-clps711x.txt | 14 Note: Each GPIO port should have an alias correctly numbered in "aliases"
|
| /Linux-v5.4/Documentation/media/cec-drivers/ |
| D | index.rst | 32 :numbered:
|
12345
