| /Linux-v5.4/Documentation/scsi/ |
| D | hptiop.txt | 84 All queued requests are handled via inbound/outbound queue port.
89 - Get a free request packet by reading the inbound queue port or
92 The value returned from the inbound queue port is an offset
99 - Post the packet to IOP by writing it to inbound queue. For requests
100 allocated in IOP memory, write the offset to inbound queue port. For
102 to the inbound queue port.
121 Non-queued requests (reset/flush etc) can be sent via inbound message
123 of an inbound message.
129 All queued requests are handled via inbound/outbound list.
139 Fill a free inbound list unit with the physical address and the size of
[all …]
|
| D | arcmsr_spec.txt | 19 ** offset 0xa00 : for inbound message code message_rwbuffer
29 ** (inbound queue port) Request frame must be 32 bytes aligned
82 ** ->offset 0xa00 :for inbound message code message_rwbuffer
94 ** ->offset 0xa00 : for inbound message code message_rwbuffer
|
| /Linux-v5.4/Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,smp2p.txt | 38 Definition: two identifiers of the inbound and outbound smem items used
52 Each SMP2P pair contain a set of inbound and outbound entries, these are
59 Definition: specifies the name of this entry, for inbound entries this
67 Definition: marks the entry as inbound; the node should be specified
85 inbound and one outbound entry:
|
| /Linux-v5.4/Documentation/arm/ |
| D | cluster-pm-race-avoidance.rst | 90 state value into two parts (the "cluster" state and "inbound" state) and
222 as seen by a CPU tearing the cluster down. The "inbound side" is the
237 "inbound" state: The state of the cluster on the inbound side.
266 Transitions ===##> can only be made by the inbound CPU, and only
267 involve changes to the "inbound" state, except where there is no
280 The parallelism of the inbound and outbound CPUs is observed by
296 <cluster state>/<inbound state> (<transitioner>)
299 can occur; either the inbound or the outbound side.
304 CLUSTER_DOWN/INBOUND_COMING_UP (inbound)
317 In this state, an inbound CPU sets up the cluster, including
[all …]
|
| /Linux-v5.4/drivers/soc/qcom/ |
| D | smp2p.c | 147 struct list_head inbound; member
202 list_for_each_entry(entry, &smp2p->inbound, node) { in qcom_smp2p_intr()
213 list_for_each_entry(entry, &smp2p->inbound, node) { in qcom_smp2p_intr()
455 INIT_LIST_HEAD(&smp2p->inbound); in qcom_smp2p_probe()
519 list_add(&entry->node, &smp2p->inbound); in qcom_smp2p_probe()
545 list_for_each_entry(entry, &smp2p->inbound, node) in qcom_smp2p_probe()
568 list_for_each_entry(entry, &smp2p->inbound, node) in qcom_smp2p_remove()
|
| /Linux-v5.4/drivers/hv/ |
| D | vmbus_drv.c | 399 struct hv_ring_buffer_debug_info inbound; in in_intr_mask_show() local
405 ret = hv_ringbuffer_get_debuginfo(&hv_dev->channel->inbound, &inbound); in in_intr_mask_show()
409 return sprintf(buf, "%d\n", inbound.current_interrupt_mask); in in_intr_mask_show()
417 struct hv_ring_buffer_debug_info inbound; in in_read_index_show() local
423 ret = hv_ringbuffer_get_debuginfo(&hv_dev->channel->inbound, &inbound); in in_read_index_show()
427 return sprintf(buf, "%d\n", inbound.current_read_index); in in_read_index_show()
435 struct hv_ring_buffer_debug_info inbound; in in_write_index_show() local
441 ret = hv_ringbuffer_get_debuginfo(&hv_dev->channel->inbound, &inbound); in in_write_index_show()
445 return sprintf(buf, "%d\n", inbound.current_write_index); in in_write_index_show()
454 struct hv_ring_buffer_debug_info inbound; in in_read_bytes_avail_show() local
[all …]
|
| D | ring_buffer.c | 187 mutex_init(&channel->inbound.ring_buffer_mutex); in hv_ringbuffer_pre_init()
396 struct hv_ring_buffer_info *rbi = &channel->inbound; in hv_pkt_iter_first()
420 struct hv_ring_buffer_info *rbi = &channel->inbound; in __hv_pkt_iter_next()
467 struct hv_ring_buffer_info *rbi = &channel->inbound; in hv_pkt_iter_close()
|
| D | connection.c | 380 if (likely(hv_end_read(&channel->inbound) == 0)) in vmbus_on_event()
383 hv_begin_read(&channel->inbound); in vmbus_on_event()
|
| D | channel.c | 74 hv_ringbuffer_cleanup(&channel->inbound); in vmbus_free_ring()
146 err = hv_ringbuffer_init(&newchannel->inbound, in __vmbus_open()
233 hv_ringbuffer_cleanup(&newchannel->inbound); in __vmbus_open()
|
| /Linux-v5.4/Documentation/devicetree/bindings/pci/ |
| D | mobiveil-pcie.txt | 4 has up to 8 outbound and inbound windows for the address translation.
25 - ppio-wins : number of requested ppio inbound windows
26 default 1 inbound memory window is configured.
|
| D | brcm,iproc-pcie.txt | 30 - dma-ranges: Some PAXB-based root complexes do not have inbound mapping done
32 the mapping, based on inbound memory regions specified by this property.
|
| D | xgene-pci.txt | 15 - dma-ranges: ranges for the inbound memory regions.
|
| D | cdns,cdns-pcie-host.txt | 23 number of least significant bits kept during inbound (PCIe -> AXI) address
|
| D | pci-rcar-gen2.txt | 40 - dma-ranges: a single range for the inbound memory region. If not supplied,
|
| /Linux-v5.4/drivers/uio/ |
| D | uio_hv_generic.c | 84 dev->channel->inbound.ring_buffer->interrupt_mask = !irq_state; in hv_uio_irqcontrol()
99 chan->inbound.ring_buffer->interrupt_mask = 1; in hv_uio_channel_cb()
168 new_sc->inbound.ring_buffer->interrupt_mask = 1; in hv_uio_new_channel()
213 dev->channel->inbound.ring_buffer->interrupt_mask = 1; in hv_uio_open()
|
| /Linux-v5.4/drivers/net/ppp/ |
| D | ppp_async.c | 107 int len, int inbound);
951 int len, int inbound) in async_lcp_peek() argument
967 if (code == (inbound? CONFACK: CONFREQ)) { in async_lcp_peek()
976 if (!inbound) { in async_lcp_peek()
987 } else if (inbound) in async_lcp_peek()
998 if (inbound) in async_lcp_peek()
1005 if (inbound) in async_lcp_peek()
|
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | sysfs-bus-rpmsg | 23 inbound messages arrive to this address, the rpmsg core
41 inbound messages arrive to this address, the rpmsg core
49 and it is listening for inbound messages that may be sent
|
| /Linux-v5.4/arch/arm/common/ |
| D | mcpm_entry.c | 92 sync_cache_r(&c->inbound); in __mcpm_outbound_enter_critical()
93 if (c->inbound == INBOUND_COMING_UP) in __mcpm_outbound_enter_critical()
437 mcpm_sync.clusters[i].inbound = INBOUND_NOT_COMING_UP; in mcpm_sync_init()
|
| /Linux-v5.4/Documentation/driver-api/rapidio/ |
| D | tsi721.rst | 9 It supports maintenance read and write operations, inbound and outbound RapidIO
10 doorbells, inbound maintenance port-writes and RapidIO messaging.
17 For inbound messages this driver uses destination ID matching to forward messages
|
| /Linux-v5.4/arch/arm/include/asm/ |
| D | mcpm.h | 294 s8 inbound __aligned(__CACHE_WRITEBACK_GRANULE);
|
| /Linux-v5.4/Documentation/networking/ |
| D | secid.txt | 13 If this is an inbound flow, the label is derived from the IPSec security
|
| D | xfrm_proc.txt | 25 i.e. Either inbound SPI, address, or IPsec protocol at SA is wrong
|
| /Linux-v5.4/Documentation/ABI/stable/ |
| D | firewire-cdev | 36 link layers, reception of inbound requests to such
38 to inbound requests
|
| /Linux-v5.4/include/net/sctp/ |
| D | ulpevent.h | 79 __u16 inbound,
|
| /Linux-v5.4/Documentation/ |
| D | rpmsg.txt | 60 a unique rpmsg local address (a 32-bit integer). This way when inbound messages
63 with the payload of the inbound message).
200 inbound messages arrive, they are dispatched by the rpmsg bus using the
214 relevant inbound messages arrive (i.e. messages which their dst address
|
