Searched refs:drives (Results 1 – 25 of 129) sorted by relevance
123456
| /Linux-v5.4/Documentation/ide/ |
| D | ChangeLog.ide-cd.1994-2004 | 21 * 2.04 Apr 21, 1995 -- Add work-around for Creative Labs CD220E drives.
24 * Aztech drives, which seem to have the same problem.
35 * blocks (like Pioneer drives). Thanks to
70 * 3.03 Oct 27, 1995 -- Some Creative drives have an id of just `CD'.
71 * `DCI-2S10' drives are broken too.
72 * 3.04 Nov 20, 1995 -- So are Vertos drives.
80 * 3.07 Jan 29, 1996 -- More twiddling for broken drives: Sony 55D,
107 * 3.17 Sep 17, 1996 -- Tweak audio reads for some drives.
113 * -- Newer Creative drives don't always set the error
167 * now set ionly for CD-R and CD-RW drives. I had
[all …]
|
| D | ide.rst | 58 14 & 15). There can be up to two drives per interface, as per the ATA-6 spec.::
72 ones), for the drives/geometries attached to those interfaces, and for the IRQ
118 Courtesy of Scott Snyder and others, the driver supports ATAPI cdrom drives
119 such as the NEC-260 and the new MITSUMI triple/quad speed drives.
120 Such drives will be identified at boot time, just like a hard disk.
203 You also need to use "probe" kernel parameter for ide-4drives driver
204 (support for IDE generic chipset with four drives on one port).
245 National Standard for connecting hard drives to PCs. This is the official
252 ATA Packet Interface, a new protocol for controlling the drives,
256 drives.
|
| /Linux-v5.4/fs/adfs/ |
| D | Kconfig | 9 here, Linux will be able to read from ADFS partitions on hard drives
14 /dev/[hs]d?1) on each of your drives. Please read the file
27 hard drives and ADFS-formatted floppy disks. This is experimental
|
| /Linux-v5.4/Documentation/devicetree/bindings/spi/ |
| D | sqi-pic32.txt | 7 - clocks: Should contain phandle of two clocks in sequence, one that drives
8 clock on SPI bus and other that drives SQI controller.
|
| /Linux-v5.4/Documentation/scsi/ |
| D | hpsa.txt | 9 driver (for logical drives) AND a SCSI driver (for tape drives). This
53 (e.g. hot-plugged tape drives, or newly configured or deleted logical drives,
58 tape drives, or entire storage boxes containing pre-configured logical drives.
|
| D | st.txt | 26 QIC-drives). The result is that any tape can be read, writing can be
115 The tape driver currently supports up to 2^17 drives if 4 modes for
156 The st driver maintains statistics for tape drives inside the sysfs filesystem.
264 this read command. Should be disabled for those drives that don't like
384 for SCSI-1 drives and SCSI-2 seek for SCSI-2 drives. The file and
397 SCSI mode page 15. Note that some drives other methods for
398 control of compression. Some drives (like the Exabytes) use
399 density codes for compression control. Some drives use another
401 driver. Some drives without compression capability will accept
413 drives and several early drives this is the physically first
[all …]
|
| D | dc395x.txt | 6 The driver has been tested with CD-R and CD-R/W drives. These should
69 *0 0x01 1 Support more than two drives. (Not used)
|
| /Linux-v5.4/drivers/md/ |
| D | Kconfig | 86 A RAID-1 set consists of several disk drives which are exact copies
90 kernel. In a set with N drives, the available space is the capacity
92 drives.
133 A RAID-5 set of N drives with a capacity of C MB per drive provides
135 of a single drive. For a given sector (row) number, (N - 1) drives
138 while a RAID-5 set distributes the parity across the drives in one
141 A RAID-6 set of N drives with a capacity of C MB per drive
143 against a failure of any two drives. For a given sector
144 (row) number, (N - 2) drives contain data sectors, and two
145 drives contains two independent redundancy syndromes. Like
[all …]
|
| /Linux-v5.4/Documentation/admin-guide/blockdev/ |
| D | paride.rst | 12 CD-ROM, LS-120 and tape drives use the parallel port to connect to their
18 (The Iomega PPA-3 adapter used in the ZIP drives is an example of this
25 drives use the ISA replicator to interface a floppy disk controller,
37 drives or scanners. Many different devices are supported by the
42 - MicroSolutions backpack hard-drives
44 - SyQuest EZ-135, EZ-230 & SparQ drives
49 - Hewlett-Packard 5GB and 8GB tape drives
50 - Hewlett-Packard 7100 and 7200 CD-RW drives
68 (Currently, the pg driver is only used with CD-R drives).
225 For example, if you had two no-name CD-ROM drives both using the
[all …]
|
| D | floppy.rst | 145 you have more than two floppy drives (only two can be
160 (Note: there are two valid types for ED drives. This is because 5 was
161 initially chosen to represent floppy *tapes*, and 6 for ED drives.
162 AMI ignored this, and used 5 for ED drives. That's why the floppy
183 problems. However, some older drives, and also some laptops
|
| /Linux-v5.4/Documentation/admin-guide/device-mapper/ |
| D | dm-raid.rst | 124 2 drives 3 drives 4 drives
142 2 drives 3 drives 4 drives
158 2 drives 3 drives 4 drives
225 given for both the metadata and data drives for a given position.
233 # RAID4 - 4 data drives, 1 parity (no metadata devices)
242 # RAID4 - 4 data drives, 1 parity (with metadata devices)
|
| /Linux-v5.4/Documentation/cdrom/ |
| D | ide-cd.rst | 12 CDROM drives which attach to an IDE interface. Note that some CDROM vendors
14 both ATAPI-compliant drives and drives which use a proprietary
17 probably will). This driver will not work with `ATAPI` drives which
20 this driver will not work with drives like that either (but see the
32 - On drives which support it, reading digital audio data directly
34 Note, however, that only some drives actually support this.
83 respectively. The drives on the secondary interface are called
148 On a few drives, you can read digital audio directly using a program
150 this are Sony and Toshiba drives. You will get errors if you try to
247 The Pioneer DR-A24X CDROM drives are fairly popular these days.
[all …]
|
| D | cdrom-standard.rst | 50 adapted their drives to one or more of the already existing electrical
57 drives are either IDE/ATAPI or SCSI, and it is very unlikely that any
58 manufacturer will create a new interface. Even finding drives for the
71 ejection. Undoubtedly, the capabilities of the different drives vary,
72 but even when two drives have the same capability their drivers'
93 Driver is simply to give people writing application programs for CD-ROM drives
103 the IDE/ATAPI drives and, of course, the SCSI drives, but as prices
106 that these drives behave in the same way. In December 1994, one of the
107 cheapest CD-ROM drives was a Philips cm206, a double-speed proprietary
109 proprietary drives became obsolete and IDE/ATAPI drives became the
[all …]
|
| /Linux-v5.4/drivers/ide/ |
| D | Kconfig | 17 ATAPI units. The most common cases are IDE hard drives and ATAPI
18 CD-ROM drives.
34 comment "Please see Documentation/ide/ide.rst for help/info on IDE drives"
75 Support for ATA/ATAPI disks (including ATAPI floppy drives).
96 This will include support for ATAPI floppy drives
109 Support for Compact Flash cards, outboard IDE disks, tape drives,
110 and CD-ROM drives connected through a PCMCIA card.
126 a newer protocol used by IDE CD-ROM and TAPE drives, similar to the
127 SCSI protocol. Most new CD-ROM drives use ATAPI, including the
129 double(2X) or better speed drives.
[all …]
|
| /Linux-v5.4/Documentation/devicetree/bindings/display/panel/ |
| D | sharp,lq101r1sx01.txt | 4 - left-right: each channel drives the left or right half of the screen
5 - even-odd: each channel drives the even or odd lines of the screen
|
| /Linux-v5.4/drivers/block/paride/ |
| D | Kconfig | 23 EZ-135, EZ-230 and SparQ drives, the Avatar Shark and the backpack
24 hard drives from MicroSolutions.
39 MicroSolutions backpack CD-ROM drives and the Freecom Power CD. If
116 parallel port Series 5 IDE protocol. (Most BACKPACK drives made
117 before 1999 were Series 5) Series 5 drives will NOT always have the
134 parallel port Series 6 IDE protocol. (Most BACKPACK drives made
135 after 1999 were Series 6) Series 6 drives will have the Series noted
176 (low speed) adapter that is used in some portable hard drives. If
272 used in some 2.5" portable hard drives. If you chose to build PARIDE
|
| /Linux-v5.4/Documentation/devicetree/bindings/watchdog/ |
| D | moxa,moxart-watchdog.txt | 7 - clocks : Should contain phandle for the clock that drives the counter
|
| D | dw_wdt.txt | 7 - clocks : phandle + clock-specifier for the clock that drives the
|
| D | digicolor-wdt.txt | 12 - clocks : phandle; specifies the clock that drives the timer
|
| D | nuvoton,npcm-wdt.txt | 15 - clock-frequency : The frequency in Hz of the clock that drives the NPCM7xx
|
| /Linux-v5.4/Documentation/devicetree/bindings/timer/ |
| D | altr,timer-1.0.txt | 8 - clock-frequency : The frequency of the clock that drives the counter, in Hz.
|
| D | brcm,bcm2835-system-timer.txt | 13 - clock-frequency : The frequency of the clock that drives the counter, in Hz.
|
| /Linux-v5.4/Documentation/devicetree/bindings/hwmon/ |
| D | sht15.txt | 8 - "vcc-supply": regulator that drives the VCC pin.
|
| /Linux-v5.4/Documentation/devicetree/bindings/crypto/ |
| D | picochip-spacc.txt | 11 - ref-clock : The input clock that drives the SPAcc.
|
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | sysfs-class-scsi_tape | 44 This value is presented in bytes because tape drives support
75 This value is presented in bytes because tape drives support
|
123456
