| /Linux-v5.4/Documentation/devicetree/bindings/regulator/ |
| D | tps65132-regulator.txt | 17 -active-discharge-gpios: (active high, output) Some configurations use delay mechanisms
19 the enable signal goes low. This GPIO is used to actively discharge
20 the delay mechanism. Requires specification of ti,active-discharge-time-us
21 -ti,active-discharge-time-us: how long the active discharge gpio should be
22 asserted for during active discharge, in microseconds.
43 regulator-active-discharge = <0>;
|
| D | tps62360-regulator.txt | 12 - ti,enable-vout-discharge: Enable output discharge. This is boolean value.
43 ti,enable-vout-discharge;
|
| D | max8973-regulator.txt | 24 -maxim,enable-active-discharge: boolean: enable active discharge.
|
| D | st,stpmic1-regulator.txt | 33 - regulator-active-discharge: can be used on pwr_sw1 and pwr_sw2.
|
| /Linux-v5.4/Documentation/devicetree/bindings/power/supply/ |
| D | da9150-fg.txt | 8 - dlg,warn-soc-level: Battery discharge level (%) where warning event raised.
10 - dlg,crit-soc-level: Battery discharge level (%) where critical event raised.
|
| D | axp20x_battery.txt | 11 The supported devices can read the battery voltage, charge and discharge
|
| /Linux-v5.4/Documentation/devicetree/bindings/display/ |
| D | repaper.txt | 10 - discharge-gpios: Discharge control
47 discharge-gpios = <&gpio 15 0>;
|
| /Linux-v5.4/include/sound/ |
| D | wm2200.h | 39 unsigned int discharge:1; /** Actively discharge */ member
|
| D | da7218.h | 80 bool discharge; member
|
| /Linux-v5.4/drivers/gpu/drm/tiny/ |
| D | repaper.c | 71 struct gpio_desc *discharge; member
648 gpiod_set_value_cansleep(epd->discharge, 1); in power_off()
650 gpiod_set_value_cansleep(epd->discharge, 0); in power_off()
671 gpiod_set_value_cansleep(epd->discharge, 0); in repaper_pipe_enable()
1049 epd->discharge = devm_gpiod_get(dev, "discharge", GPIOD_OUT_LOW); in repaper_probe()
1050 if (IS_ERR(epd->discharge)) { in repaper_probe()
1051 ret = PTR_ERR(epd->discharge); in repaper_probe()
|
| /Linux-v5.4/include/linux/mfd/arizona/ |
| D | pdata.h | 61 unsigned int discharge:1; /** Actively discharge */ member
|
| /Linux-v5.4/arch/arm/mach-pxa/ |
| D | sharpsl_pm.h | 18 void (*discharge)(int); member
|
| D | corgi_pm.c | 164 .discharge = corgi_discharge,
|
| D | spitz_pm.c | 199 .discharge = spitz_discharge,
|
| D | sharpsl_pm.c | 526 sharpsl_pm.machinfo->discharge(1); in sharpsl_check_battery_voltage()
541 sharpsl_pm.machinfo->discharge(0); in sharpsl_check_battery_voltage()
|
| /Linux-v5.4/Documentation/devicetree/bindings/sound/ |
| D | da7218.txt | 64 - dlg,discharge : Boolean flag, auto discharge of Mic Bias on jack removal
|
| /Linux-v5.4/drivers/power/supply/ |
| D | axp288_fuel_gauge.c | 391 int ret, discharge; in fuel_gauge_get_current() local
394 ret = iio_read_channel_raw(info->iio_channel[BAT_D_CURR], &discharge); in fuel_gauge_get_current()
398 if (discharge > 0) { in fuel_gauge_get_current()
399 *cur = -1 * discharge; in fuel_gauge_get_current()
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | stm32mp157a-avenger96.dts | 255 regulator-active-discharge;
262 regulator-active-discharge;
|
| D | stm32mp157c-ed1.dts | 244 regulator-active-discharge;
|
| D | stm32mp157a-dk1.dts | 330 regulator-active-discharge;
|
| /Linux-v5.4/arch/arm64/boot/dts/nvidia/ |
| D | tegra210-p3450-0000.dts | 335 regulator-disable-active-discharge;
|
| /Linux-v5.4/drivers/mfd/ |
| D | arizona-core.c | 1383 if (arizona->pdata.micbias[i].discharge) in arizona_dev_init()
|
| /Linux-v5.4/sound/soc/codecs/ |
| D | da7218.c | 2558 hpldet_pdata->discharge = true; in da7218_of_to_pdata()
2869 if (hpldet_pdata->discharge) in da7218_handle_pdata()
|
| D | wm2200.c | 2358 if (wm2200->pdata.micbias[i].discharge) in wm2200_i2c_probe()
|
| /Linux-v5.4/scripts/ |
| D | spelling.txt | 468 disharge||discharge
|
