| /Linux-v5.4/drivers/regulator/ |
| D | wm831x-dcdc.c | 62 struct wm831x_dcdc *dcdc = rdev_get_drvdata(rdev); in wm831x_dcdc_get_mode() local
63 struct wm831x *wm831x = dcdc->wm831x; in wm831x_dcdc_get_mode()
64 u16 reg = dcdc->base + WM831X_DCDC_ON_CONFIG; in wm831x_dcdc_get_mode()
116 struct wm831x_dcdc *dcdc = rdev_get_drvdata(rdev); in wm831x_dcdc_set_mode() local
117 struct wm831x *wm831x = dcdc->wm831x; in wm831x_dcdc_set_mode()
118 u16 reg = dcdc->base + WM831X_DCDC_ON_CONFIG; in wm831x_dcdc_set_mode()
126 struct wm831x_dcdc *dcdc = rdev_get_drvdata(rdev); in wm831x_dcdc_set_suspend_mode() local
127 struct wm831x *wm831x = dcdc->wm831x; in wm831x_dcdc_set_suspend_mode()
128 u16 reg = dcdc->base + WM831X_DCDC_SLEEP_CONTROL; in wm831x_dcdc_set_suspend_mode()
135 struct wm831x_dcdc *dcdc = rdev_get_drvdata(rdev); in wm831x_dcdc_get_status() local
[all …]
|
| D | wm8350-regulator.c | 266 int sel, volt_reg, dcdc = rdev_get_id(rdev); in wm8350_dcdc_set_suspend_voltage() local
269 dev_dbg(wm8350->dev, "%s %d mV %d\n", __func__, dcdc, uV / 1000); in wm8350_dcdc_set_suspend_voltage()
271 switch (dcdc) { in wm8350_dcdc_set_suspend_voltage()
303 int dcdc = rdev_get_id(rdev); in wm8350_dcdc_set_suspend_enable() local
306 switch (dcdc) { in wm8350_dcdc_set_suspend_enable()
343 int dcdc = rdev_get_id(rdev); in wm8350_dcdc_set_suspend_disable() local
346 switch (dcdc) { in wm8350_dcdc_set_suspend_disable()
383 int dcdc = rdev_get_id(rdev); in wm8350_dcdc25_set_suspend_enable() local
386 switch (dcdc) { in wm8350_dcdc25_set_suspend_enable()
408 int dcdc = rdev_get_id(rdev); in wm8350_dcdc25_set_suspend_disable() local
[all …]
|
| D | tps65023-regulator.c | 179 int dcdc = rdev_get_id(dev); in tps65023_dcdc_get_voltage_sel() local
181 if (dcdc < TPS65023_DCDC_1 || dcdc > TPS65023_DCDC_3) in tps65023_dcdc_get_voltage_sel()
184 if (dcdc != tps->driver_data->core_regulator) in tps65023_dcdc_get_voltage_sel()
194 int dcdc = rdev_get_id(dev); in tps65023_dcdc_set_voltage_sel() local
196 if (dcdc != tps->driver_data->core_regulator) in tps65023_dcdc_set_voltage_sel()
|
| D | ltc3676.c | 77 int dcdc = rdev_get_id(rdev); in ltc3676_set_suspend_voltage() local
80 dev_dbg(dev, "%s id=%d uV=%d\n", __func__, dcdc, uV); in ltc3676_set_suspend_voltage()
96 int dcdc = rdev_get_id(rdev); in ltc3676_set_suspend_mode() local
98 dev_dbg(dev, "%s id=%d mode=%d\n", __func__, dcdc, mode); in ltc3676_set_suspend_mode()
122 int ret, dcdc = rdev_get_id(rdev); in ltc3676_set_voltage_sel() local
124 dev_dbg(dev, "%s id=%d selector=%d\n", __func__, dcdc, selector); in ltc3676_set_voltage_sel()
|
| D | Makefile | 135 obj-$(CONFIG_REGULATOR_WM831X) += wm831x-dcdc.o
|
| /Linux-v5.4/drivers/leds/ |
| D | leds-wm8350.c | 101 ret = regulator_enable(led->dcdc); in wm8350_led_enable()
120 ret = regulator_disable(led->dcdc); in wm8350_led_disable()
129 ret = regulator_enable(led->dcdc); in wm8350_led_disable()
188 struct regulator *isink, *dcdc; in wm8350_led_probe() local
210 dcdc = devm_regulator_get(&pdev->dev, "led_vcc"); in wm8350_led_probe()
211 if (IS_ERR(dcdc)) { in wm8350_led_probe()
213 return PTR_ERR(dcdc); in wm8350_led_probe()
226 led->dcdc = dcdc; in wm8350_led_probe()
|
| /Linux-v5.4/Documentation/devicetree/bindings/display/panel/ |
| D | jdi,lt070me05000.txt | 14 - dcdc-en-gpios: phandle of the gpio for power ic line
29 dcdc-en-gpios = <&pm8921_gpio 23 GPIO_ACTIVE_HIGH>;
|
| /Linux-v5.4/include/linux/mfd/wm8350/ |
| D | pmic.h | 723 struct regulator *dcdc; member
752 int wm8350_register_led(struct wm8350 *wm8350, int lednum, int dcdc, int isink,
758 int wm8350_dcdc_set_slot(struct wm8350 *wm8350, int dcdc, u16 start,
760 int wm8350_dcdc25_set_mode(struct wm8350 *wm8350, int dcdc, u16 mode,
|
| /Linux-v5.4/Documentation/devicetree/bindings/regulator/ |
| D | tps65090.txt | 11 dcdc[1-3], fet[1-7] and ldo[1-2] respectively.
19 - dcdc-ext-control-gpios: This is applicable for DCDC1, DCDC2 and DCDC3.
57 dcdc-ext-control-gpios = <&gpio 10 0>;
|
| D | tps65217.txt | 7 after their hardware counterparts: dcdc[1-3] and ldo[1-4]
|
| D | tps65218.txt | 8 after their hardware counterparts: dcdc[1-6] and ldo1
|
| /Linux-v5.4/arch/mips/lantiq/xway/ |
| D | Makefile | 2 obj-y := prom.o sysctrl.o clk.o dma.o gptu.o dcdc.o
|
| /Linux-v5.4/include/linux/mfd/ |
| D | menelaus.h | 25 extern int menelaus_set_vdcdc(int dcdc, unsigned int mV);
|
| /Linux-v5.4/include/linux/mfd/wm831x/ |
| D | pdata.h | 135 struct regulator_init_data *dcdc[WM831X_MAX_DCDC]; member
|
| /Linux-v5.4/Documentation/devicetree/bindings/power/supply/ |
| D | axp20x_usb_power.txt | 26 x-powers,dcdc-freq = <1500>;
|
| /Linux-v5.4/Documentation/devicetree/bindings/mfd/ |
| D | tps65912.txt | 18 after their hardware counterparts: dcdc[1-4] and
|
| D | axp20x.txt | 46 - x-powers,dcdc-freq: defines the work frequency of DC-DC in KHz
74 - x-powers,dcdc-workmode: 1 for PWM mode, 0 for AUTO (PWM/PFM) mode
238 x-powers,dcdc-freq = <1500>;
|
| /Linux-v5.4/drivers/mfd/ |
| D | menelaus.c | 644 int menelaus_set_vdcdc(int dcdc, unsigned int mV) in menelaus_set_vdcdc() argument
649 if (dcdc != 2 && dcdc != 3) in menelaus_set_vdcdc()
651 if (dcdc == 2) in menelaus_set_vdcdc()
|
| /Linux-v5.4/arch/arm/mach-s3c64xx/ |
| D | mach-crag6410.c | 571 .dcdc = {
710 .dcdc = {
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | qcom-msm8974-sony-xperia-castor.dts | 252 vreg_vsp: lcd-dcdc-regulator {
625 lcd_dcdc_en_pin_a: lcd-dcdc-en-active {
|
| D | axp209.dtsi | 79 x-powers,dcdc-freq = <1500>;
|
| D | axp81x.dtsi | 84 x-powers,dcdc-freq = <3000>;
|
| D | axp22x.dtsi | 72 x-powers,dcdc-freq = <3000>;
|
| D | qcom-apq8064-asus-nexus7-flo.dts | 232 dcdc-en-gpios = <&pm8921_gpio 23 GPIO_ACTIVE_HIGH>;
|
| /Linux-v5.4/arch/arm64/boot/dts/allwinner/ |
| D | axp803.dtsi | 87 x-powers,dcdc-freq = <3000>;
|
