/Linux-v5.4/arch/unicore32/ |
D | .gitignore | 16 # Generated files in boot/compressed 18 boot/compressed/piggy.S 19 boot/compressed/piggy.gzip 20 boot/compressed/vmlinux 21 boot/compressed/vmlinux.lds
|
/Linux-v5.4/Documentation/vm/ |
D | zswap.rst | 10 Zswap is a lightweight compressed cache for swap pages. It takes pages that are 14 significant performance improvement if reads from the compressed cache are 34 Zswap evicts pages from compressed cache on an LRU basis to the backing swap 35 device when the compressed pool reaches its size limit. This requirement had 48 back into memory all of the pages stored in the compressed pool. The 49 pages stored in zswap will remain in the compressed pool until they are 51 pages out of the compressed pool, a swapoff on the swap device(s) will 53 compressed pool. 59 evict pages from its own compressed pool on an LRU basis and write them back to 60 the backing swap device in the case that the compressed pool is full. [all …]
|
D | z3fold.rst | 7 z3fold is a special purpose allocator for storing compressed pages. 8 It is designed to store up to three compressed pages per physical page. 15 * z3fold can hold up to 3 compressed pages in its page 20 stores an integral number of compressed pages per page, but it can store
|
/Linux-v5.4/arch/parisc/boot/ |
D | Makefile | 8 subdir- := compressed 13 $(obj)/bzImage: $(obj)/compressed/vmlinux FORCE 16 $(obj)/compressed/vmlinux: FORCE 17 $(Q)$(MAKE) $(build)=$(obj)/compressed $@
|
/Linux-v5.4/arch/unicore32/boot/ |
D | Makefile | 20 $(obj)/compressed/vmlinux: $(obj)/Image FORCE 21 $(Q)$(MAKE) $(build)=$(obj)/compressed $@ 23 $(obj)/zImage: $(obj)/compressed/vmlinux FORCE 39 subdir- := compressed
|
/Linux-v5.4/arch/h8300/boot/ |
D | Makefile | 5 subdir- := compressed 18 $(obj)/zImage: $(obj)/compressed/vmlinux FORCE 21 $(obj)/compressed/vmlinux: FORCE 22 $(Q)$(MAKE) $(build)=$(obj)/compressed $@
|
/Linux-v5.4/Documentation/media/v4l-drivers/ |
D | fourcc.rst | 19 - b: raw bayer, DPCM compressed 20 - a: A-law compressed 21 - u: u-law compressed 32 4th character: compressed bits-per-pixel 0--9, A--
|
/Linux-v5.4/Documentation/networking/ |
D | ipsec.txt | 5 1. IPcomp: Small IP packet won't get compressed at sender, and failed on 11 If the total size of a compressed payload and the IPComp header, as 13 payload, the IP datagram MUST be sent in the original non-compressed 14 form. To clarify: If an IP datagram is sent non-compressed, no 28 when sending non-compressed packet to the peer (whether or not packet len 29 is smaller than the threshold or the compressed len is larger than original
|
/Linux-v5.4/fs/squashfs/ |
D | block.c | 85 int bytes, compressed, b = 0, k = 0, avail, i; in squashfs_read_data() local 97 compressed = SQUASHFS_COMPRESSED_BLOCK(length); in squashfs_read_data() 103 index, compressed ? "" : "un", length, output->length); in squashfs_read_data() 129 compressed = SQUASHFS_COMPRESSED(length); in squashfs_read_data() 135 compressed ? "" : "un", length); in squashfs_read_data() 156 if (compressed) { in squashfs_read_data()
|
D | Kconfig | 7 Read-Only File System). Squashfs is a highly compressed read-only 112 bool "Include support for ZLIB compressed file systems" 125 bool "Include support for LZ4 compressed file systems" 130 compressed with LZ4 compression. LZ4 compression is mainly 140 bool "Include support for LZO compressed file systems" 145 compressed with LZO compression. LZO compression is mainly 155 bool "Include support for XZ compressed file systems" 160 compressed with XZ compression. XZ gives better compression than 170 bool "Include support for ZSTD compressed file systems" 175 compressed with ZSTD compression. ZSTD gives better compression than
|
/Linux-v5.4/arch/s390/boot/ |
D | Makefile | 44 subdir- := compressed 61 $(obj)/bzImage: $(obj)/compressed/vmlinux $(obj)/section_cmp.boot.data $(obj)/section_cmp.boot.pres… 64 $(obj)/section_cmp%: vmlinux $(obj)/compressed/vmlinux FORCE 67 $(obj)/compressed/vmlinux: $(obj)/startup.a FORCE 68 $(Q)$(MAKE) $(build)=$(obj)/compressed $@
|
/Linux-v5.4/lib/xz/ |
D | xz_dec_stream.c | 66 vli_type compressed; member 81 vli_type compressed; member 232 s->block.compressed += b->in_pos - s->in_start; in dec_block() 239 if (s->block.compressed > s->block_header.compressed in dec_block() 249 if (s->block_header.compressed != VLI_UNKNOWN in dec_block() 250 && s->block_header.compressed in dec_block() 251 != s->block.compressed) in dec_block() 260 + s->block.compressed; in dec_block() 481 s->block_header.compressed = s->vli; in dec_block_header() 483 s->block_header.compressed = VLI_UNKNOWN; in dec_block_header() [all …]
|
D | xz_dec_lzma2.c | 238 uint32_t compressed; member 852 if (s->temp.size > 0 || s->lzma2.compressed == 0) { in lzma2_lzma() 854 if (tmp > s->lzma2.compressed - s->temp.size) in lzma2_lzma() 855 tmp = s->lzma2.compressed - s->temp.size; in lzma2_lzma() 861 if (s->temp.size + tmp == s->lzma2.compressed) { in lzma2_lzma() 880 s->lzma2.compressed -= s->rc.in_pos; in lzma2_lzma() 898 if (in_avail >= s->lzma2.compressed + LZMA_IN_REQUIRED) in lzma2_lzma() 899 s->rc.in_limit = b->in_pos + s->lzma2.compressed; in lzma2_lzma() 907 if (in_avail > s->lzma2.compressed) in lzma2_lzma() 910 s->lzma2.compressed -= in_avail; in lzma2_lzma() [all …]
|
/Linux-v5.4/arch/arm/boot/ |
D | Makefile | 63 $(obj)/compressed/vmlinux: $(obj)/Image FORCE 64 $(Q)$(MAKE) $(build)=$(obj)/compressed $@ 66 $(obj)/zImage: $(obj)/compressed/vmlinux FORCE 118 subdir- := bootp compressed dts
|
/Linux-v5.4/arch/nios2/boot/ |
D | Makefile | 27 $(obj)/zImage: $(obj)/compressed/vmlinux FORCE 31 $(obj)/compressed/vmlinux: $(obj)/vmlinux.gz FORCE 32 $(Q)$(MAKE) $(build)=$(obj)/compressed $@
|
/Linux-v5.4/Documentation/filesystems/ |
D | squashfs.txt | 4 Squashfs is a compressed read-only filesystem for Linux. 46 compressed inode is on average 8 bytes in length (the exact length varies on 109 Metadata (inodes and directories) are compressed in 8Kbyte blocks. Each 110 compressed block is prefixed by a two byte length, the top bit is set if the 112 or if the compressed block was larger than the uncompressed block. 115 boundaries, therefore inodes overlap compressed blocks. Inodes are identified 116 by a 48-bit number which encodes the location of the compressed metadata block 132 Like inodes, directories are packed into compressed metadata blocks, stored 140 compressed metadata block, and therefore, can share the start block. 162 Regular files consist of a sequence of contiguous compressed blocks, and/or a [all …]
|
/Linux-v5.4/arch/sh/boot/ |
D | Makefile | 33 subdir- := compressed romimage 35 $(obj)/zImage: $(obj)/compressed/vmlinux FORCE 39 $(obj)/compressed/vmlinux: FORCE 40 $(Q)$(MAKE) $(build)=$(obj)/compressed $@ 102 $(obj)/vmlinux.srec: $(obj)/compressed/vmlinux
|
/Linux-v5.4/tools/perf/util/ |
D | zstd.c | 61 size_t ret, size, compressed = 0; in zstd_compress_stream_to_records() local 69 compressed += size; in zstd_compress_stream_to_records() 84 compressed += size; in zstd_compress_stream_to_records() 89 return compressed; in zstd_compress_stream_to_records()
|
/Linux-v5.4/arch/x86/boot/ |
D | header.S | 455 # a gzip-compressed kernel as example, to illustrate it: 457 # The file layout of gzip compressed kernel is: 465 # compressed data blocks[N] 493 # compressed data is placed at the end of the buffer. The output pointer 495 # where the compressed data starts. Problems will occur when the output 500 # triggered by data whose compressed form is larger than the uncompressed 503 # The worst case at the block level is a growth of the compressed data 506 # The worst case internal to a compressed block is very hard to figure. 516 # block will stop the byte before the compressed data for a block begins. 517 # To avoid problems with the compressed data's meta information an extra 18 [all …]
|
D | Makefile | 31 subdir- := compressed 85 $(obj)/vmlinux.bin: $(obj)/compressed/vmlinux FORCE 96 $(obj)/zoffset.h: $(obj)/compressed/vmlinux FORCE 111 $(obj)/compressed/vmlinux: FORCE 112 $(Q)$(MAKE) $(build)=$(obj)/compressed $@
|
/Linux-v5.4/arch/x86/boot/compressed/ |
D | vmlinux.lds.S | 30 .rodata..compressed : { 31 *(.rodata..compressed)
|
/Linux-v5.4/arch/parisc/boot/compressed/ |
D | vmlinux.lds.S | 47 .rodata.compressed : { 48 *(.rodata.compressed)
|
/Linux-v5.4/arch/s390/boot/compressed/ |
D | vmlinux.lds.S | 77 .rodata.compressed : { 79 *(.vmlinux.bin.compressed)
|
/Linux-v5.4/Documentation/media/uapi/v4l/ |
D | vidioc-enum-fmt.rst | 124 - This is a compressed format. 132 - The hardware decoder for this compressed bytestream format (aka coded 136 the ``V4L2_FMT_FLAG_COMPRESSED`` flag, since this applies to compressed 141 compressed bytestream format (aka coded format). It will notify the user 145 compressed formats only. It is also only applies to stateful codecs.
|
/Linux-v5.4/drivers/firmware/efi/ |
D | efi-pstore.c | 63 record->compressed = true; in efi_pstore_read_func() 65 record->compressed = false; in efi_pstore_read_func() 74 record->compressed = false; in efi_pstore_read_func() 88 record->compressed = false; in efi_pstore_read_func() 258 record->compressed ? 'C' : 'D'); in efi_pstore_write()
|