Searched refs:circuit (Results 1 – 25 of 65) sorted by relevance
123
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-temperature-max31856 | 5 Open-circuit fault. The detection of open-circuit faults,
8 '1' = An open circuit such as broken thermocouple wires
10 '0' = No open circuit or broken thermocouple wires are detected
|
| D | sysfs-class-led-flash | 65 * controller-short-circuit - the short circuit protection
71 a short or open circuit condition on the indicator LED
|
| D | sysfs-bus-iio-frequency-adf4371 | 11 A divide by 1, 2, 4, 8, 16, 32 or circuit generates
|
| /Linux-v5.4/Documentation/hwmon/ |
| D | ntc_thermistor.rst | 37 and four circuit models with an option not to use any of the four models.
44 The four circuit models provided are:
94 When one of the four circuit models is used, read_uV, pullup_uV, pullup_ohm,
|
| D | ltc4215.rst | 45 circuit will be used.
|
| D | da9055.rst | 19 different inputs. The track and hold circuit ensures stable input voltages at
|
| D | da9052.rst | 20 different inputs. The track and hold circuit ensures stable input voltages at
|
| /Linux-v5.4/Documentation/devicetree/bindings/media/i2c/ |
| D | adv7343.txt | 15 circuit are disabled.
17 internal PLL 1 circuit to be powered down and the
|
| /Linux-v5.4/Documentation/spi/ |
| D | spi-lm70llp.rst | 63 A "gotcha": National Semiconductor's LM70 LLP eval board circuit schematic
68 Interpreting this circuit, when the LM70 SI/O line is High (or tristate
84 - Nadir Billimoria for help interpreting the circuit schematic.
|
| /Linux-v5.4/Documentation/devicetree/bindings/i2c/ |
| D | i2c-st.txt | 18 allowed through the deglitch circuit. In units of us.
20 allowed through the deglitch circuit. In units of us.
|
| /Linux-v5.4/net/netrom/ |
| D | af_netrom.c | 59 static unsigned short circuit = 0x101; variable
191 unsigned short id = circuit; in nr_find_next_circuit()
679 circuit = nr_find_next_circuit(); in nr_connect()
682 nr->my_index = circuit / 256; in nr_connect()
683 nr->my_id = circuit % 256; in nr_connect()
685 circuit++; in nr_connect()
963 circuit = nr_find_next_circuit(); in nr_rx_frame()
966 nr_make->my_index = circuit / 256; in nr_rx_frame()
967 nr_make->my_id = circuit % 256; in nr_rx_frame()
969 circuit++; in nr_rx_frame()
|
| /Linux-v5.4/Documentation/devicetree/bindings/power/reset/ |
| D | mt6323-poweroff.txt | 4 powering off or on the remote MediaTek SoC through the circuit BBPU.
|
| /Linux-v5.4/Documentation/devicetree/bindings/input/ |
| D | dlink,dir685-touchkeys.txt | 4 CY8C214 MCU with some firmware in its internal 8KB flash. The circuit
|
| /Linux-v5.4/Documentation/devicetree/bindings/power/supply/ |
| D | battery.txt | 27 - ocv-capacity-table-0: An array providing the open circuit voltage (OCV)
30 circuit voltage unit is microvolt.
|
| D | bq24190.txt | 31 - Some circuit boards wire the chip's "OTG" pin high (enabling 500mA default
|
| /Linux-v5.4/Documentation/devicetree/bindings/iio/afe/ |
| D | current-sense-amplifier.txt | 7 describes such a current sense circuit.
|
| D | current-sense-shunt.txt | 7 sense circuit.
|
| /Linux-v5.4/Documentation/devicetree/bindings/display/panel/ |
| D | sitronix,st7701.txt | 17 - VCC-supply: analog regulator for MIPI circuit
|
| /Linux-v5.4/Documentation/devicetree/bindings/pinctrl/ |
| D | cirrus,madera-pinctrl.txt | 50 spkl-short-circuit, spkr-short-circuit, spk-shutdown,
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | ls1021a-tsn.dts | 153 /* Current sensing circuit for 1V VDDCORE PMIC rail */
160 /* Current sensing circuit for 12V VCC rail */
|
| /Linux-v5.4/drivers/net/wireless/st/cw1200/ |
| D | Kconfig | 18 and similar designs that utilize a hardware reset circuit. To
|
| /Linux-v5.4/Documentation/devicetree/bindings/watchdog/ |
| D | gpio-wdt.txt | 14 - hw_margin_ms: Maximum time to reset watchdog circuit (milliseconds).
|
| /Linux-v5.4/Documentation/devicetree/bindings/iio/dac/ |
| D | mcp4725.txt | 17 connected to the internal resistor ladder circuit.
|
| /Linux-v5.4/Documentation/devicetree/bindings/mtd/ |
| D | denali-nand.txt | 14 interface clock, and the ECC circuit clock.
|
| /Linux-v5.4/Documentation/devicetree/bindings/regulator/ |
| D | max8973-regulator.txt | 30 circuit is enabled and set for high sensitivity. If this
|
123
