| /Linux-v5.4/sound/pci/ice1712/ |
| D | se.c | 24 unsigned char ch1, ch2; member
450 uc->value.integer.value[0] = spec->vol[n].ch1; in se200pci_cont_volume_get()
461 uc->value.integer.value[0] = spec->vol[n].ch1; in se200pci_cont_boolean_get()
471 uc->value.enumerated.item[0] = spec->vol[n].ch1; in se200pci_cont_enum_get()
482 spec->vol[n].ch1, in se200pci_cont_update()
488 spec->vol[n].ch1, in se200pci_cont_update()
494 spec->vol[n].ch1, in se200pci_cont_update()
500 spec->vol[n].ch1); in se200pci_cont_update()
504 se200pci_WM8776_set_agc(ice, spec->vol[n].ch1); in se200pci_cont_update()
508 se200pci_WM8776_set_afl(ice, spec->vol[n].ch1); in se200pci_cont_update()
[all …]
|
| D | wm8766.h | 125 void (*set)(struct snd_wm8766 *wm, u16 ch1, u16 ch2);
126 void (*get)(struct snd_wm8766 *wm, u16 *ch1, u16 *ch2);
|
| D | wm8776.h | 181 void (*set)(struct snd_wm8776 *wm, u16 ch1, u16 ch2);
182 void (*get)(struct snd_wm8776 *wm, u16 *ch1, u16 *ch2);
|
| /Linux-v5.4/Documentation/devicetree/bindings/clock/ |
| D | uniphier-clock.txt | 39 15: USB3 ch1 host
42 20: USB3 ch1 PHY0
43 21: USB3 ch1 PHY1
80 2: SD ch1 host
83 9: USB2 ch1 host
86 13: USB2 ch1 PHY
123 1: UART ch1
127 5: I2C ch1
|
| /Linux-v5.4/drivers/staging/speakup/ |
| D | keyhelp.c | 51 u_char *kp, counters[MAXFUNCS], ch, ch1; in build_key_data() local
84 ch1 = *kp++; in build_key_data()
85 if (!ch1) in build_key_data()
87 if ((state_tbl[i] & 16) != 0 && ch1 == SPK_KEY) in build_key_data()
90 counters[ch1]--; in build_key_data()
91 offset = key_offsets[ch1]; in build_key_data()
94 p_key = key_data + offset + counters[ch1]; in build_key_data()
|
| /Linux-v5.4/drivers/iio/light/ |
| D | apds9300.c | 65 static unsigned long apds9300_calculate_lux(u16 ch0, u16 ch1) in apds9300_calculate_lux() argument
73 tmp = DIV_ROUND_UP(ch1 * 100, ch0); in apds9300_calculate_lux()
78 lux = 2290 * ch0 - 2910 * ch1; in apds9300_calculate_lux()
80 lux = 1570 * ch0 - 1800 * ch1; in apds9300_calculate_lux()
82 lux = 338 * ch0 - 260 * ch1; in apds9300_calculate_lux()
239 int ch0, ch1, ret = -EINVAL; in apds9300_read_raw() local
250 ch1 = apds9300_get_adc_val(data, 1); in apds9300_read_raw()
251 if (ch1 < 0) { in apds9300_read_raw()
252 ret = ch1; in apds9300_read_raw()
255 *val = apds9300_calculate_lux(ch0, ch1); in apds9300_read_raw()
|
| D | tsl2583.c | 71 unsigned int ch1; member
109 s16 ch1; member
165 u16 ch0, ch1; /* separated ch0/ch1 data from device */ in tsl2583_get_lux() local
217 ch1 = le16_to_cpup((const __le16 *)&buf[2]); in tsl2583_get_lux()
220 chip->als_cur_info.als_ch1 = ch1; in tsl2583_get_lux()
222 if ((ch0 >= chip->als_saturation) || (ch1 >= chip->als_saturation)) in tsl2583_get_lux()
237 ratio = (ch1 << 15) / ch0; in tsl2583_get_lux()
252 ch1lux = ((ch1 * p->ch1) + in tsl2583_get_lux()
253 (gainadj[chip->als_settings.als_gain].ch1 >> 1)) in tsl2583_get_lux()
254 / gainadj[chip->als_settings.als_gain].ch1; in tsl2583_get_lux()
[all …]
|
| /Linux-v5.4/drivers/media/usb/pvrusb2/ |
| D | pvrusb2-context.c | 101 struct pvr2_channel *ch1, *ch2; in pvr2_context_check() local
130 for (ch1 = mp->mc_first; ch1; ch1 = ch2) { in pvr2_context_check()
131 ch2 = ch1->mc_next; in pvr2_context_check()
132 if (ch1->check_func) ch1->check_func(ch1); in pvr2_context_check()
|
| /Linux-v5.4/drivers/misc/ |
| D | tsl2550.c | 143 static int tsl2550_calculate_lux(u8 ch0, u8 ch1) in tsl2550_calculate_lux() argument
149 u16 c1 = count_lut[ch1]; in tsl2550_calculate_lux()
247 u8 ch0, ch1; in __tsl2550_show_lux() local
258 ch1 = ret; in __tsl2550_show_lux()
261 ret = tsl2550_calculate_lux(ch0, ch1); in __tsl2550_show_lux()
|
| /Linux-v5.4/drivers/input/touchscreen/ |
| D | mxs-lradc-ts.c | 161 unsigned int ch1, unsigned int ch2) in mxs_lradc_setup_ts_pressure() argument
175 writel(reg, ts->base + LRADC_CH(ch1)); in mxs_lradc_setup_ts_pressure()
183 ts->base + LRADC_CH(ch1) + STMP_OFFSET_REG_CLR); in mxs_lradc_setup_ts_pressure()
188 writel(LRADC_DELAY_TRIGGER(1 << ch1) | LRADC_DELAY_TRIGGER(1 << ch2) | in mxs_lradc_setup_ts_pressure()
225 unsigned int ch1, unsigned int ch2) in mxs_lradc_read_ts_pressure() argument
230 mask = LRADC_CTRL1_LRADC_IRQ(ch1) | LRADC_CTRL1_LRADC_IRQ(ch2); in mxs_lradc_read_ts_pressure()
238 m1 = mxs_lradc_ts_read_raw_channel(ts, ch1); in mxs_lradc_read_ts_pressure()
|
| /Linux-v5.4/drivers/gpu/drm/i915/display/ |
| D | dvo_tfp410.c | 159 u8 ch1, ch2; in tfp410_getid() local
161 if (tfp410_readb(dvo, addr+0, &ch1) && in tfp410_getid()
163 return ((ch2 << 8) & 0xFF00) | (ch1 & 0x00FF); in tfp410_getid()
|
| /Linux-v5.4/sound/oss/dmasound/ |
| D | dmasound_paula.c | 464 u_char *start, *ch0, *ch1, *ch2, *ch3; in AmiPlayNextFrame() local
476 ch1 = start+write_sq_block_size_half; in AmiPlayNextFrame()
480 ch1 = start; in AmiPlayNextFrame()
489 custom.aud[1].audlc = (u_short *)ZTWO_PADDR(ch1); in AmiPlayNextFrame()
496 custom.aud[1].audlc = (u_short *)ZTWO_PADDR(ch1); in AmiPlayNextFrame()
501 ch2 = ch1+write_sq_block_size_quarter; in AmiPlayNextFrame()
|
| /Linux-v5.4/sound/soc/amd/ |
| D | acp-pcm-dma.c | 340 ch_acp_sysmem = rtd->ch1; in config_acp_dma()
343 ch_acp_i2s = rtd->ch1; in config_acp_dma()
896 rtd->ch1 = SYSRAM_TO_ACP_BT_INSTANCE_CH_NUM; in acp_dma_hw_params()
917 rtd->ch1 = SYSRAM_TO_ACP_CH_NUM; in acp_dma_hw_params()
933 rtd->ch1 = I2S_TO_ACP_DMA_BT_INSTANCE_CH_NUM; in acp_dma_hw_params()
949 rtd->ch1 = I2S_TO_ACP_DMA_CH_NUM; in acp_dma_hw_params()
1072 ch_acp_sysmem = rtd->ch1; in acp_dma_prepare()
1075 ch_acp_i2s = rtd->ch1; in acp_dma_prepare()
1116 acp_dma_start(rtd->acp_mmio, rtd->ch1, true); in acp_dma_trigger()
1118 acp_dma_start(rtd->acp_mmio, rtd->ch1, true); in acp_dma_trigger()
[all …]
|
| D | acp.h | 132 u16 ch1; member
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | stih407-clock.dtsi | 106 "clk-s-c0-fs0-ch1",
211 "clk-s-d0-fs0-ch1",
245 "clk-s-d2-fs0-ch1",
293 "clk-s-d3-fs0-ch1",
|
| D | stih410-clock.dtsi | 107 "clk-s-c0-fs0-ch1",
219 "clk-s-d0-fs0-ch1",
255 "clk-s-d2-fs0-ch1",
303 "clk-s-d3-fs0-ch1",
|
| D | stih418-clock.dtsi | 106 "clk-s-c0-fs0-ch1",
213 "clk-s-d0-fs0-ch1",
249 "clk-s-d2-fs0-ch1",
304 "clk-s-d3-fs0-ch1",
|
| D | r8a77470.dtsi | 343 dma-names = "ch0", "ch1", "ch2", "ch3";
378 dma-names = "ch0", "ch1", "ch2", "ch3";
412 interrupt-names = "ch0", "ch1";
426 interrupt-names = "ch0", "ch1";
440 interrupt-names = "ch0", "ch1";
454 interrupt-names = "ch0", "ch1";
483 "ch0", "ch1", "ch2", "ch3",
516 "ch0", "ch1", "ch2", "ch3",
|
| D | at91-tse850-3.dts | 109 ch1-red {
113 ch1-green {
|
| /Linux-v5.4/Documentation/devicetree/bindings/dma/ |
| D | renesas,usb-dmac.txt | 38 interrupt-names = "ch0", "ch1";
49 interrupt-names = "ch0", "ch1";
|
| D | renesas,rcar-dmac.txt | 77 "ch0", "ch1", "ch2", "ch3",
107 "ch0", "ch1", "ch2", "ch3",
|
| /Linux-v5.4/Documentation/devicetree/bindings/mfd/ |
| D | stm32-timers.txt | 25 names are: "ch1", "ch2", "ch3", "ch4", "up", "trig",
70 dma-names = "ch1", "ch2", "ch3", "ch4", "up", "trig", "com";
|
| /Linux-v5.4/include/linux/platform_data/ |
| D | tsl2772.h | 15 unsigned int ch1; member
|
| /Linux-v5.4/Documentation/devicetree/bindings/sound/ |
| D | st,sta32x.txt | 34 - st,ch1-output-mapping: Channel 1 output mapping
93 st,ch1-output-mapping = /bits/ 8 <0>; // set channel 1 output ch 1
|
| /Linux-v5.4/drivers/clk/sunxi/ |
| D | Makefile | 19 obj-$(CONFIG_CLK_SUNXI_CLOCKS) += clk-sun4i-tcon-ch1.o
|
