Searched refs:bootloader (Results 1 – 25 of 288) sorted by relevance
12345678910>>...12
| /Linux-v5.4/arch/alpha/boot/ |
| D | Makefile | 14 tools/bootpzh bootloader bootpheader bootpzheader
90 $(obj)/tools/lxboot: $(obj)/bootloader $(OBJSTRIP) FORCE
93 $(obj)/tools/bootlx: $(obj)/bootloader $(OBJSTRIP) FORCE
111 $(obj)/bootloader: $(obj)/bootloader.lds $(OBJ_bootlx) $(LIBS_Y) FORCE
114 $(obj)/bootpheader: $(obj)/bootloader.lds $(OBJ_bootph) $(LIBS_Y) FORCE
117 $(obj)/bootpzheader: $(obj)/bootloader.lds $(OBJ_bootpzh) $(LIBS_Y) FORCE
|
| /Linux-v5.4/Documentation/devicetree/bindings/power/reset/ |
| D | reboot-mode.txt | 5 or ram. Then the bootloader can read it and take different
9 the bootloader what to do when the system reboots, and should be named
15 - mode-bootloader: Android fastboot mode, it's a mode to re-flash partitions on the Android based d…
16 - mode-loader: A bootloader mode, it's a mode used to download image on Rockchip platform,
23 mode-bootloader = <BOOT_FASTBOOT>;
|
| D | nvmem-reboot-mode.txt | 4 and stores it in a NVMEM cell named "reboot-mode". Then the bootloader
23 mode-bootloader = <0xBBBB5500>;
|
| D | syscon-reboot-mode.txt | 4 and stores it in a SYSCON mapped register. Then the bootloader
32 mode-bootloader = <BOOT_FASTBOOT>;
|
| /Linux-v5.4/Documentation/translations/zh_CN/arm/ |
| D | Booting | 97 bootloader 必须创建和初始化内核标签列表。一个有效的标签列表以
106 bootloader 必须传递一个系统内存的位置和最小值，以及根文件系统位置。
125 bootloader 必须以 64bit 地址对齐的形式加载一个设备树映像(dtb)到系统
131 bootloader 必须传递一个系统内存的位置和最小值，以及根文件系统位置。
|
| /Linux-v5.4/Documentation/devicetree/bindings/input/touchscreen/ |
| D | cyttsp.txt | 9 - bootloader-key : the 8-byte bootloader key that is required to switch
10 the chip from bootloader mode (default mode) to
60 bootloader-key = /bits/ 8 <0x01 0x02 0x03 0x04 0x05 0x06 0x07 0x08>;
85 bootloader-key = /bits/ 8 <0x01 0x02 0x03 0x04 0x05 0x06 0x07 0x08>;
|
| /Linux-v5.4/arch/powerpc/boot/dts/ |
| D | tqm5200.dts | 29 timebase-frequency = <0>; // from bootloader
30 bus-frequency = <0>; // from bootloader
31 clock-frequency = <0>; // from bootloader
46 bus-frequency = <0>; // from bootloader
47 system-frequency = <0>; // from bootloader
|
| D | mpc8349emitxgp.dts | 34 timebase-frequency = <0>; // from bootloader
35 bus-frequency = <0>; // from bootloader
36 clock-frequency = <0>; // from bootloader
52 bus-frequency = <0>; // from bootloader
189 clock-frequency = <0>; // from bootloader
199 clock-frequency = <0>; // from bootloader
|
| D | charon.dts | 32 timebase-frequency = <0>; // from bootloader
33 bus-frequency = <0>; // from bootloader
34 clock-frequency = <0>; // from bootloader
49 bus-frequency = <0>; // from bootloader
50 system-frequency = <0>; // from bootloader
|
| D | lite5200.dts | 29 timebase-frequency = <0>; // from bootloader
30 bus-frequency = <0>; // from bootloader
31 clock-frequency = <0>; // from bootloader
46 bus-frequency = <0>; // from bootloader
47 system-frequency = <0>; // from bootloader
|
| D | mpc5200b.dtsi | 30 timebase-frequency = <0>; // from bootloader
31 bus-frequency = <0>; // from bootloader
32 clock-frequency = <0>; // from bootloader
47 bus-frequency = <0>; // from bootloader
48 system-frequency = <0>; // from bootloader
|
| D | mpc8349emitx.dts | 36 timebase-frequency = <0>; // from bootloader
37 bus-frequency = <0>; // from bootloader
38 clock-frequency = <0>; // from bootloader
54 bus-frequency = <0>; // from bootloader
283 clock-frequency = <0>; // from bootloader
293 clock-frequency = <0>; // from bootloader
|
| /Linux-v5.4/Documentation/devicetree/bindings/remoteproc/ |
| D | st-rproc.txt | 6 Co-processors can be controlled from the bootloader or the primary OS. If
7 the bootloader starts a co-processor, the primary OS must detect its state
18 - clock-frequency Clock frequency to set co-processor at if the bootloader
|
| /Linux-v5.4/Documentation/x86/x86_64/ |
| D | uefi.rst | 10 the needed bootloader support and associated tools for x86_64 platforms
15 2. Booting Linux kernel on UEFI x86_64 platform requires bootloader
37 elilo bootloader with x86_64 support, elilo configuration file,
|
| /Linux-v5.4/arch/arm/mach-omap1/ |
| D | Kconfig | 41 Pin multiplexing support for OMAP boards. If your bootloader
54 bool "Warn about pins the bootloader didn't set up"
126 need a PalmOS compatible bootloader; check out
135 you'll need a PalmOS compatible bootloader; check out
144 need a PalmOS compatible bootloader (Garux); check out
154 you'll need a SX1 compatible bootloader; check out
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | armada-xp-db-xc3-24g4xg.dts | 9 * Note: this Device Tree assumes that the bootloader has remapped the
13 * boards were delivered with an older version of the bootloader that
15 * situation, you should either update your bootloader (preferred
|
| D | sama5d3xcm.dtsi | 100 bootloader@40000 {
101 label = "bootloader";
106 label = "bootloader env";
|
| D | at91-sama5d4_xplained.dts | 196 bootloader@40000 {
197 label = "bootloader";
202 label = "bootloader env redundant";
207 label = "bootloader env";
|
| D | armada-xp-db-dxbc2.dts | 9 * Note: this Device Tree assumes that the bootloader has remapped the
13 * boards were delivered with an older version of the bootloader that
15 * situation, you should either update your bootloader (preferred
|
| D | hisi-x5hd2-dkb.dts | 57 /* Placeholder, overwritten by bootloader */
71 /* Placeholder, overwritten by bootloader */
|
| D | sama5d3xcm_cmp.dtsi | 154 bootloader@40000 {
155 label = "bootloader";
160 label = "bootloader env";
|
| D | armada-xp-gp.dts | 12 * Note: this Device Tree assumes that the bootloader has remapped the
16 * boards were delivered with an older version of the bootloader that
18 * situation, you should either update your bootloader (preferred
39 * bootloader according the size of the module
|
| D | at91sam9rlek.dts | 97 bootloader@40000 {
98 label = "bootloader";
103 label = "bootloader env";
|
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | sysfs-devices-platform-stratix10-rsu | 105 0 the first stage bootloader didn't run or
107 stage bootloader.
108 1 failed in second bootloader or didn't get
111 2 both first and second stage bootloader ran
|
| /Linux-v5.4/arch/alpha/ |
| D | Kconfig.debug | 18 If you're using aboot 0.7 or later, the bootloader will examine the
24 Say Y if you have a broken bootloader. Say N if you do not, or if
|
12345678910>>...12
