| /Linux-v5.4/drivers/gpio/ |
| D | sgpio-aspeed.c | 89 static void __iomem *bank_reg(struct aspeed_sgpio *gpio, in bank_reg() function
139 rc = !!(ioread32(bank_reg(gpio, bank, reg)) & GPIO_BIT(offset)); in aspeed_sgpio_get()
153 addr = bank_reg(gpio, bank, reg_val); in sgpio_set_value()
244 status_addr = bank_reg(gpio, bank, reg_irq_status); in aspeed_sgpio_irq_ack()
263 addr = bank_reg(gpio, bank, reg_irq_enable); in aspeed_sgpio_irq_set_mask()
326 addr = bank_reg(gpio, bank, reg_irq_type0); in aspeed_sgpio_set_type()
331 addr = bank_reg(gpio, bank, reg_irq_type1); in aspeed_sgpio_set_type()
336 addr = bank_reg(gpio, bank, reg_irq_type2); in aspeed_sgpio_set_type()
361 reg = ioread32(bank_reg(data, bank, reg_irq_status)); in aspeed_sgpio_irq_handler()
398 iowrite32(0x00000000, bank_reg(gpio, bank, reg_irq_enable)); in aspeed_sgpio_setup_irqs()
[all …]
|
| D | gpio-aspeed.c | 208 static inline void __iomem *bank_reg(struct aspeed_gpio *gpio, in bank_reg() function
309 void __iomem *c0 = bank_reg(gpio, bank, reg_cmdsrc0); in aspeed_gpio_change_cmd_source()
310 void __iomem *c1 = bank_reg(gpio, bank, reg_cmdsrc1); in aspeed_gpio_change_cmd_source()
356 gpio->dcache[GPIO_BANK(offset)] = ioread32(bank_reg(gpio, bank, reg_rdata)); in aspeed_gpio_copro_request()
386 return !!(ioread32(bank_reg(gpio, bank, reg_val)) & GPIO_BIT(offset)); in aspeed_gpio_get()
397 addr = bank_reg(gpio, bank, reg_val); in __aspeed_gpio_set()
430 void __iomem *addr = bank_reg(gpio, bank, reg_dir); in aspeed_gpio_dir_in()
458 void __iomem *addr = bank_reg(gpio, bank, reg_dir); in aspeed_gpio_dir_out()
497 val = ioread32(bank_reg(gpio, bank, reg_dir)) & GPIO_BIT(offset); in aspeed_gpio_get_direction()
541 status_addr = bank_reg(gpio, bank, reg_irq_status); in aspeed_gpio_irq_ack()
[all …]
|
| /Linux-v5.4/drivers/i2c/ |
| D | i2c-stub.c | 47 static u8 bank_reg[MAX_CHIPS]; variable
48 module_param_array(bank_reg, byte, NULL, S_IRUGO);
49 MODULE_PARM_DESC(bank_reg, "Bank register");
77 u8 bank_reg; member
177 if (chip->bank_words && command == chip->bank_reg) { in stub_xfer()
321 chip->bank_reg = bank_reg[i]; in i2c_stub_allocate_banks()
|
| /Linux-v5.4/arch/arm/mach-s3c24xx/ |
| D | iotiming-s3c2410.c | 56 static inline void __iomem *bank_reg(unsigned int bank) in bank_reg() function
366 bankcon = __raw_readl(bank_reg(bank)); in s3c2410_iotiming_calc()
412 __raw_writel(bt->bankcon, bank_reg(bank)); in s3c2410_iotiming_set()
444 bankcon = __raw_readl(bank_reg(bank)); in s3c2410_iotiming_get()
|
| /Linux-v5.4/drivers/clk/qcom/ |
| D | clk-rcg.c | 73 ret = regmap_read(rcg->clkr.regmap, rcg->bank_reg, ®); in clk_dyn_rcg_get_parent()
213 ret = regmap_read(rcg->clkr.regmap, rcg->bank_reg, ®); in configure_bank()
253 ret = regmap_write(rcg->clkr.regmap, rcg->bank_reg, in configure_bank()
280 ret = regmap_read(rcg->clkr.regmap, rcg->bank_reg, ®); in configure_bank()
284 ret = regmap_write(rcg->clkr.regmap, rcg->bank_reg, reg); in configure_bank()
300 regmap_read(rcg->clkr.regmap, rcg->bank_reg, ®); in clk_dyn_rcg_set_parent()
376 regmap_read(rcg->clkr.regmap, rcg->bank_reg, ®); in clk_dyn_rcg_recalc_rate()
452 regmap_read(rcg->clkr.regmap, rcg->bank_reg, ®); in clk_dyn_rcg_determine_rate()
|
| D | clk-rcg.h | 113 u32 bank_reg; member
|
| D | gcc-ipq806x.c | 2298 .bank_reg = 0x3ca0,
2370 .bank_reg = 0x3ca0,
2442 .bank_reg = 0x3ce0,
2514 .bank_reg = 0x3d00,
2590 .bank_reg = 0x3dc0,
2652 .bank_reg = 0x3d20,
2705 .bank_reg = 0x3d40,
|
| D | mmcc-msm8960.c | 806 .bank_reg = 0x0060,
866 .bank_reg = 0x0074,
967 .bank_reg = 0x0080,
1045 .bank_reg = 0x0178,
1252 .bank_reg = 0x00c0,
1359 .bank_reg = 0x00e8,
1585 .bank_reg = 0x00f8,
|
| /Linux-v5.4/Documentation/i2c/ |
| D | i2c-stub.rst | 55 u8 bank_reg[10], u8 bank_mask[10], u8 bank_start[10], u8 bank_end[10]:
|
