Searched refs:altered (Results 1 – 25 of 53) sorted by relevance
123
75 This value may be reset to 0 if the current protocol is altered.91 This value may be reset to 0 if the current protocol is altered.134 This value may be reset to 0 if the wakeup protocol is altered.151 This value may be reset to 0 if the wakeup protocol is altered.
47 This value may be reset to 0 if the current protocol is altered.62 This value may be reset to 0 if the current protocol is altered.96 This value may be reset to 0 if the wakeup protocol is altered.111 This value may be reset to 0 if the wakeup protocol is altered.
45 /* This location must not be altered */71 /* This location must not be altered */79 /* This location must not be altered */95 /* This location must not be altered */
45 /* This location must not be altered */71 /* This location must not be altered */88 /* This location must not be altered */
45 /* This location must not be altered */73 /* This location must not be altered */90 /* This location must not be altered */
80 /* This location must not be altered */88 /* This location must not be altered */105 /* This location must not be altered */
63 /* This location must not be altered */71 /* This location must not be altered */
52 /* This location must not be altered */78 /* This location must not be altered */86 /* This location must not be altered */
132 /* This location must not be altered */148 /* This location must not be altered */
37 /* This location must not be altered */
63 /* This location must not be altered */
121 /* This location must not be altered */
449 u8 status, altered; in z8530_status() local452 altered = chan->status ^ status; in z8530_status()463 if (altered & chan->dcdcheck) in z8530_status()560 u8 status, altered; in z8530_dma_status() local563 altered=chan->status^status; in z8530_dma_status()583 if (altered & chan->dcdcheck) in z8530_dma_status()
18 their speed can be altered by software (depending on the system use and to save
68 /* This location must not be altered */
8 a machine died while the region was being altered. In the case of
71 Additionally the operation of the touchpad can be altered by adjusting the135 The state of crc_enabled can be altered with this knob.175 By echoing a hexadecimal value to a register it contents can be altered.362 By echoing a hexadecimal value to a register it contents can be altered.
49 bits describing the rounding mode. The emulator could be altered to
13 the PHY powering up process had to be altered. This adaptation layer is
103 The tdc_config.py file contains multiple values that can be altered to suit104 your needs. Any value in the NAMES dictionary can be altered without affecting
