Searched refs:TXD (Results 1 – 15 of 15) sorted by relevance
/Linux-v5.4/arch/arm/boot/dts/ |
D | ste-href-family-pinctrl.dtsi | 24 pins = "GPIO1_AJ3", "GPIO3_AH3"; /* RTS+TXD */ 41 pins = "GPIO3_AH3"; /* TXD */ 59 pins = "GPIO5_AG6"; /* TXD */ 71 pins = "GPIO5_AG6"; /* TXD */ 89 pins = "GPIO30_W3"; /* TXD */ 101 pins = "GPIO30_W3"; /* TXD */ 229 "GPIO215_AH13", /* TXD */ 246 pins = "GPIO215_AH13"; /* TXD */ 263 pins = "GPIO215_AH13"; /* TXD */ 496 "GPIO12_AC4", /* TXD */ [all …]
|
D | sama5d4.dtsi | 1456 AT91_PIOE 30 AT91_PERIPH_B AT91_PINCTRL_NONE /* TXD */ 1465 AT91_PIOC 26 AT91_PERIPH_C AT91_PINCTRL_NONE /* TXD */ 1474 AT91_PIOD 13 AT91_PERIPH_A AT91_PINCTRL_NONE /* TXD */ 1489 AT91_PIOD 17 AT91_PERIPH_A AT91_PINCTRL_NONE /* TXD */ 1504 AT91_PIOB 5 AT91_PERIPH_B AT91_PINCTRL_NONE /* TXD - conflicts with G0_COL, PCK2 */ 1519 AT91_PIOE 17 AT91_PERIPH_B AT91_PINCTRL_NONE /* TXD */ 1528 AT91_PIOE 27 AT91_PERIPH_B AT91_PINCTRL_NONE /* TXD */
|
D | ste-snowball.dts | 547 "GPIO146_D13", /* TXD */
|
D | gemini-dlink-dir-685.dts | 43 /* Collides with LPC LFRAME, UART RTS, SSP TXD */
|
/Linux-v5.4/drivers/mtd/nand/raw/ |
D | mxic_nand.c | 63 #define TXD(x) (0x14 + ((x) * 4)) macro 361 writel(data, nfc->regs + TXD(nbytes % 4)); in mxic_nfc_data_xfer()
|
/Linux-v5.4/drivers/mailbox/ |
D | bcm-pdc-mailbox.c | 70 #define TXD(x, max_mask) XXD((x), (max_mask)) macro 72 #define NEXTTXD(i, max_mask) TXD((i) + 1, (max_mask)) 73 #define PREVTXD(i, max_mask) TXD((i) - 1, (max_mask)) 76 #define NTXDACTIVE(h, t, max_mask) TXD((t) - (h), (max_mask))
|
/Linux-v5.4/Documentation/devicetree/bindings/net/ |
D | rockchip-dwmac.txt | 43 - tx_delay: Delay value for TXD timing. Range value is 0~0x7F, 0x30 as default.
|
/Linux-v5.4/drivers/spi/ |
D | spi-mxic.c | 62 #define TXD(x) (0x14 + ((x) * 4)) macro 305 writel(data, mxic->regs + TXD(nbytes % 4)); in mxic_spi_data_xfer()
|
/Linux-v5.4/Documentation/devicetree/bindings/pinctrl/ |
D | renesas,rzn1-pinctrl.txt | 146 pinmux = <RZN1_PINMUX(103, RZN1_FUNC_UART0_I)>; /* TXD */
|
D | pinctrl-bindings.txt | 296 pins = "GPIO1_AJ3", "GPIO3_AH3"; /* RTS+TXD */
|
/Linux-v5.4/Documentation/arm/pxa/ |
D | mfp.rst | 32 | SSP2 |---(TXD)----+ | | +---------+ 40 | UART2 |---(TXD)--------+
|
/Linux-v5.4/drivers/net/ethernet/sun/ |
D | sunhme.c | 1913 #define TXD(x) printk x macro 1915 #define TXD(x) macro 1927 TXD(("TX<")); in happy_meal_tx() 1933 TXD(("[%d]", elem)); in happy_meal_tx() 1969 TXD((">")); in happy_meal_tx()
|
/Linux-v5.4/arch/powerpc/boot/dts/ |
D | mpc832x_mds.dts | 11 * 1) On chip U61, lift (disconnect) pins 21 (TXD) and 22 (RXD) from the board.
|
/Linux-v5.4/Documentation/networking/ |
D | phy.rst | 87 for the transmit data lines (TXD[3:0]) processed by the PHY device
|
/Linux-v5.4/Documentation/driver-api/ |
D | pinctl.rst | 437 (these are four pins: CLK, RXD, TXD, FRM). In that case, pin B5 can be used as
|