Home
last modified time | relevance | path

Searched refs:SFP (Results 1 – 20 of 20) sorted by relevance

/Linux-v5.4/fs/reiserfs/
Dprocfs.c50 #define SFP( x ) SF( s_proc_info_data.x ) macro
51 #define SFPL( x ) SFP( x[ level ] )
52 #define SFPF( x ) SFP( scan_bitmap.x )
53 #define SFPJ( x ) SFP( journal.x )
122 SF(s_indirect2direct), SFP(max_hash_collisions), SFP(breads), in show_super()
123 SFP(bread_miss), SFP(search_by_key), in show_super()
124 SFP(search_by_key_fs_changed), SFP(search_by_key_restarted), in show_super()
125 SFP(insert_item_restarted), SFP(paste_into_item_restarted), in show_super()
126 SFP(cut_from_item_restarted), in show_super()
127 SFP(delete_solid_item_restarted), SFP(delete_item_restarted), in show_super()
[all …]
/Linux-v5.4/Documentation/devicetree/bindings/net/
Dsff,sfp.txt1 Small Form Factor (SFF) Committee Small Form-factor Pluggable (SFP)
7 "sff,sfp" for SFP modules
10 - i2c-bus : phandle of an I2C bus controller for the SFP two wire serial
33 Select (AKA RS1) output gpio signal (SFP+ only), low: low Tx rate, high:
40 Example #1: Direct serdes to SFP connection
60 Example #2: Serdes to PHY to SFP connection
Dapm-xgene-enet.txt50 - rxlos-gpios: Input gpio from SFP+ module to indicate availability of
/Linux-v5.4/Documentation/networking/device_drivers/intel/
Dixgbe.rst35 SFP+ Devices with Pluggable Optics
44 - When 82599-based SFP+ devices are connected back to back, they should be set
53 | Intel | DUAL RATE 1G/10G SFP+ SR (bailed) | FTLX8571D3BCV-IT |
55 | Intel | DUAL RATE 1G/10G SFP+ SR (bailed) | AFBR-703SDZ-IN2 |
57 | Intel | DUAL RATE 1G/10G SFP+ SR (bailed) | AFBR-703SDDZ-IN1 |
61 | Intel | DUAL RATE 1G/10G SFP+ LR (bailed) | FTLX1471D3BCV-IT |
63 | Intel | DUAL RATE 1G/10G SFP+ LR (bailed) | AFCT-701SDZ-IN2 |
65 | Intel | DUAL RATE 1G/10G SFP+ LR (bailed) | AFCT-701SDDZ-IN1 |
68 The following is a list of 3rd party SFP+ modules that have received some
74 | Finisar | SFP+ SR bailed, 10g single rate | FTLX8571D3BCL |
[all …]
Di40e.rst46 SFP+ and QSFP+ Devices
131 balancing (in SFP mode only).
/Linux-v5.4/arch/arm/boot/dts/
Darmada-388-clearfog.dtsi190 * Routed to SFP, mikrobus, and PCIe.
191 * SFP limits this to 100kHz, and requires an AT24C01A/02/04 with
204 /* SFP, PCIe, mSATA, mikrobus */
Darmada-385-turris-omnia.dts185 /* routed to SFP+ */
211 * GPIO expander for SFP+ signals and
Dbcm958625hr.dts59 * which would prevent reading from a SFP's EEPROM (256 byte).
Dam3874-iceboard.dts145 /* SFP */
/Linux-v5.4/Documentation/networking/
Dkapi.rst153 and SFF modules (eg, hot-pluggable SFP) that may contain PHYs. PHYLINK
161 SFP support
Dsfp-phylink.rst15 and SFP (Small Formfactor Pluggable) modules at present.
270 For information describing the SFP cage in DT, please see the binding
/Linux-v5.4/drivers/net/ethernet/ni/
DKconfig27 support either 10G or 1G PHYs via SFP+ ports.
/Linux-v5.4/arch/arm64/boot/dts/marvell/
Darmada-8040-clearfog-gt-8k.dts150 * [49] SFP+ present signal
276 /* SFP */
314 * [29] CP0 10G SFP TX Disable
Darmada-3720-turris-mox.dts106 /* enabled by U-Boot if SFP module is present */
/Linux-v5.4/Documentation/networking/device_drivers/aquantia/
Datlantic.txt22 SFP+ Devices (for AQC-100 based adapters)
25 This release tested with passive Direct Attach Cables (DAC) and SFP+/LC Optical Transceiver.
/Linux-v5.4/Documentation/devicetree/bindings/net/dsa/
Dmt7530.txt57 Like in the Ubiquiti ER-X-SFP.
/Linux-v5.4/drivers/net/phy/
DKconfig254 config SFP config
255 tristate "SFP cage support"
/Linux-v5.4/drivers/bus/
DKconfig39 their settings. For example the GPIOs on Mox SFP module are
/Linux-v5.4/drivers/gpio/
DKconfig1462 bus. For example the Mox module with SFP cage needs this driver
/Linux-v5.4/
DMAINTAINERS14653 SFF/SFP/SFP+ MODULE SUPPORT