Searched refs:MIPI (Results 1 – 25 of 111) sorted by relevance
12345
| /Linux-v5.4/Documentation/devicetree/bindings/media/i2c/ |
| D | tc358743.txt | 1 * Toshiba TC358743 HDMI-RX to MIPI CSI2-TX Bridge
3 The Toshiba TC358743 HDMI-RX to MIPI CSI2-TX (H2C) is a bridge that converts
4 a HDMI stream to MIPI CSI-2 TX. It is programmable through I2C.
20 MIPI CSI-2 clock is continuous or non-continuous.
25 For further information on the MIPI CSI-2 endpoint node properties, see
|
| /Linux-v5.4/drivers/media/platform/cadence/ |
| D | Kconfig | 14 tristate "Cadence MIPI-CSI2 RX Controller"
20 Support for the Cadence MIPI CSI2 Receiver controller.
26 tristate "Cadence MIPI-CSI2 TX Controller"
32 Support for the Cadence MIPI CSI2 Transceiver controller.
|
| /Linux-v5.4/Documentation/devicetree/bindings/media/ |
| D | samsung-mipi-csis.txt | 1 Samsung S5P/EXYNOS SoC series MIPI CSI-2 receiver (MIPI CSIS)
11 - interrupts : should contain MIPI CSIS interrupt; the format of the
14 - vddio-supply : MIPI CSIS I/O and PLL voltage supply (e.g. 1.8V);
15 - vddcore-supply : MIPI CSIS Core voltage supply (e.g. 1.1V);
42 - data-lanes : (required) an array specifying active physical MIPI-CSI2
|
| D | imx.txt | 27 This is the device node for the MIPI CSI-2 Receiver core in the i.MX
28 SoC. This is a Synopsys Designware MIPI CSI-2 host controller core
39 - clocks : the MIPI CSI-2 receiver requires three clocks: hsi_tx
46 connecting with a MIPI CSI-2 source, and ports 1
49 MIPI CSI-2 virtual channel outputs.
|
| D | video-interfaces.txt | 103 1 - MIPI CSI-2 C-PHY
104 2 - MIPI CSI1
106 4 - MIPI CSI-2 D-PHY
127 physical lane, e.g. for 2-lane MIPI CSI-2 bus we could have
132 serial busses only (e.g. MIPI CSI-2).
135 physical lane, e.g. for a MIPI CSI-2 bus we could have "clock-lanes = <0>;",
137 serial busses only (e.g. MIPI CSI-2). Note that for the MIPI CSI-2 bus this
139 - clock-noncontinuous: a boolean property to allow MIPI CSI-2 non-continuous
141 - link-frequencies: Allowed data bus frequencies. For MIPI CSI-2, for
157 camera sensors with a parallel and serial (MIPI CSI-2) video bus respectively.
[all …]
|
| D | imx7-mipi-csi2.txt | 7 This is the device node for the MIPI CSI-2 receiver core in i.MX7 SoC. It is
14 - interrupts : should contain MIPI CSIS interrupt;
25 provides power to MIPI CSIS core;
48 - data-lanes : (required) an array specifying active physical MIPI-CSI2
|
| /Linux-v5.4/Documentation/devicetree/bindings/display/mediatek/ |
| D | mediatek,dsi.txt | 5 drive up to 4-lane MIPI DSI output. Two DSIs can be synchronized for dual-
16 - phys: phandle link to the MIPI D-PHY controller.
22 MIPI TX Configuration Module
25 The MIPI TX configuration module controls the MIPI D-PHY.
|
| /Linux-v5.4/Documentation/driver-api/soundwire/ |
| D | summary.rst | 5 SoundWire is a new interface ratified in 2015 by the MIPI Alliance.
58 The MIPI SoundWire specification uses the term 'device' to refer to a Master
69 Programs all the MIPI-defined Slave registers. Represents a SoundWire
77 Driver controlling the Slave device. MIPI-specified registers are controlled
91 Bus implements API to read standard Master MIPI properties and also provides
132 MIPI specification, so Bus calls the "sdw_master_port_ops" callback
140 The MIPI specification requires each Slave interface to expose a unique
153 board-file, ACPI or DT. The MIPI Software specification defines additional
180 For capabilities, Bus implements API to read standard Slave MIPI properties
197 SoundWire MIPI specification 1.1 is available at:
[all …]
|
| /Linux-v5.4/Documentation/media/v4l-drivers/ |
| D | imx7.rst | 16 - MIPI CSI-2 Receiver
20 MIPI Camera Input ---> MIPI CSI-2 --- > |\
39 This is the MIPI CSI-2 receiver entity. It has one sink pad to receive the pixel
40 data from MIPI CSI-2 camera sensor. It has one source pad, corresponding to the
48 sensor with a parallel interface or from MIPI CSI-2 virtual channel 0. It has
55 can interface directly with Parallel and MIPI CSI-2 buses. It has 256 x 64 FIFO
76 On this platform an OV2680 MIPI CSI-2 module is connected to the internal MIPI
|
| D | fimc.rst | 28 - camera serial interface capture (MIPI-CSI2);
32 instance to any parallel video input or any MIPI-CSI front-end);
50 - MIPI-CSI2 receiver subdev
72 connections of the MIPI-CSIS device(s) to the FIMC entities.
104 MIPI-CSI receiver device (currently up to two).
147 sub-device node is created per each MIPI-CSIS device.
171 optional s5p-csis.ko (MIPI-CSI receiver subdev).
|
| D | imx.rst | 32 camera sensors over Parallel, BT.656/1120, and MIPI CSI-2 buses.
66 - MIPI CSI-2 Receiver for camera sensors with the MIPI CSI-2 bus
84 - Supports parallel, BT.565, and MIPI CSI-2 interfaces.
111 This is the MIPI CSI-2 receiver entity. It has one sink pad to receive
112 the MIPI CSI-2 stream (usually from a MIPI CSI-2 camera sensor). It has
113 four source pads, corresponding to the four MIPI CSI-2 demuxed virtual
117 This entity actually consists of two sub-blocks. One is the MIPI CSI-2
118 core. This is a Synopsys Designware MIPI CSI-2 core. The other sub-block
138 MIPI CSI-2 virtual channels from imx6-mipi-csi2 entity. They have a
143 the four MIPI CSI-2 virtual channels (a total of five sink pads). The
[all …]
|
| /Linux-v5.4/drivers/hwtracing/stm/ |
| D | Kconfig | 8 Trace Protocol (STP) format as defined by MIPI STP standards.
21 exclusively until the MIPI SyS-T support was added. Use this
24 The receiving side only needs to be able to decode the MIPI
31 tristate "MIPI SyS-T STM framing protocol driver"
34 This is an implementation of MIPI SyS-T protocol to be used
40 addition to the MIPI STP, in order to extract the data.
|
| /Linux-v5.4/Documentation/trace/ |
| D | sys-t.rst | 4 MIPI SyS-T over STP
7 The MIPI SyS-T protocol driver can be used with STM class devices to
11 In order to use the MIPI SyS-T protocol driver with your STM device,
33 Now, with the MIPI SyS-T protocol driver, each policy node in the
52 MIPI SyS-T message header. It is off by default as the STP already
|
| /Linux-v5.4/Documentation/devicetree/bindings/display/exynos/ |
| D | exynos_dsim.txt | 1 Exynos MIPI DSI Master
19 - vddcore-supply: MIPI DSIM Core voltage supply (e.g. 1.1V)
20 - vddio-supply: MIPI DSIM I/O and PLL voltage supply (e.g. 1.8V)
23 according to DSI host bindings (see MIPI DSI bindings [1])
32 Should contain DSI peripheral nodes (see MIPI DSI bindings [1]).
|
| /Linux-v5.4/Documentation/devicetree/bindings/display/panel/ |
| D | sitronix,st7701.txt | 5 several system interfaces like MIPI/RGB/SPI.
7 Techstar TS8550B is 480x854, 2-lane MIPI DSI LCD panel which has
17 - VCC-supply: analog regulator for MIPI circuit
|
| D | raydium,rm67191.txt | 1 Raydium RM67171 OLED LCD panel with MIPI-DSI protocol
5 - reg: virtual channel for MIPI-DSI protocol
11 the input port should be connected to a MIPI-DSI device
|
| D | orisetech,otm8009a.txt | 1 Orise Tech OTM8009A 3.97" 480x800 TFT LCD panel (MIPI-DSI video mode)
4 a MIPI-DSI video interface. Its backlight is managed through the DSI link.
|
| D | raydium,rm68200.txt | 1 Raydium Semiconductor Corporation RM68200 5.5" 720p MIPI-DSI TFT LCD panel
4 panel connected using a MIPI-DSI video interface.
|
| /Linux-v5.4/drivers/media/platform/exynos4-is/ |
| D | Kconfig | 34 tristate "S5P/EXYNOS MIPI-CSI2 receiver (MIPI-CSIS) driver"
39 This is a V4L2 driver for Samsung S5P and EXYNOS4 SoC MIPI-CSI2
40 receiver (MIPI-CSIS) devices.
|
| /Linux-v5.4/Documentation/devicetree/bindings/display/bridge/ |
| D | dw_mipi_dsi.txt | 1 Synopsys DesignWare MIPI DSI host controller
4 This document defines device tree properties for the Synopsys DesignWare MIPI
13 - reg: Memory mapped base address and length of the DesignWare MIPI DSI
|
| /Linux-v5.4/drivers/gpu/drm/stm/ |
| D | Kconfig | 19 tristate "STMicroelectronics specific extensions for Synopsys MIPI DSI"
23 Choose this option for MIPI DSI support on STMicroelectronics SoC.
|
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | configfs-stp-policy-p_sys-t | 8 tagged with this UUID in the MIPI SyS-T packet stream, to
17 Include payload length in the MIPI SyS-T header, boolean.
28 MIPI SyS-T packet metadata, if this many milliseconds have
|
| /Linux-v5.4/drivers/media/platform/rcar-vin/ |
| D | Kconfig | 3 tristate "R-Car MIPI CSI-2 Receiver"
9 Support for Renesas R-Car MIPI CSI-2 receiver.
|
| /Linux-v5.4/Documentation/devicetree/bindings/phy/ |
| D | mixel,mipi-dsi-phy.txt | 3 The Mixel MIPI-DSI PHY IP block is e.g. found on i.MX8 platforms (along the
4 MIPI-DSI IP from Northwest Logic). It represents the physical layer for the
|
| /Linux-v5.4/drivers/phy/samsung/ |
| D | Kconfig | 15 tristate "S5P/EXYNOS SoC series MIPI CSI-2/DSI PHY driver"
21 Support for MIPI CSI-2 and MIPI DSI DPHY found on Samsung S5P
|
12345
