| /Linux-v5.4/arch/parisc/include/asm/ |
| D | led.h | 10 #define LED2 0x04 macro
16 #define LED_DISK_IO LED2 /* for disk activity */
|
| /Linux-v5.4/drivers/iio/health/ |
| D | afe4404.c | 97 LED2 = 1, enumerator
106 [LED2] = AFE440X_LED2VAL,
115 [LED2] = F_ILED2,
121 [LED2] = F_OFFDAC_LED2,
129 AFE440X_INTENSITY_CHAN(LED2, BIT(IIO_CHAN_INFO_OFFSET)),
136 AFE440X_CURRENT_CHAN(LED2),
|
| D | afe4403.c | 78 LED2 = 1, enumerator
87 [LED2] = AFE440X_LED2VAL,
96 [LED2] = F_ILED2,
102 AFE440X_INTENSITY_CHAN(LED2, 0),
109 AFE440X_CURRENT_CHAN(LED2),
|
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-health-afe440x | 9 1 -> LED2
13 Note that channels 5 and 6 represent LED2-ALED2 and LED1-ALED1
|
| /Linux-v5.4/drivers/leds/ |
| D | leds-bd2802.c | 40 LED2, enumerator
223 reg = bd2802_get_reg_addr(LED2, RED, BD2802_REG_HOURSETUP); in bd2802_configure()
236 enum led_ids other_led = (id == LED1) ? LED2 : LED1; in bd2802_enable()
550 BD2802_CONTROL_RGBS(led2r, LED2, RED);
551 BD2802_CONTROL_RGBS(led2g, LED2, GREEN);
552 BD2802_CONTROL_RGBS(led2b, LED2, BLUE);
|
| /Linux-v5.4/include/linux/mfd/ |
| D | tps65010.h | 113 #define LED2 2 macro
|
| /Linux-v5.4/Documentation/devicetree/bindings/leds/ |
| D | leds-lm3692x.txt | 25 2 - Will enable the LED2 sync
|
| D | leds-mt6323.txt | 56 label = "LED2";
|
| /Linux-v5.4/arch/arc/boot/dts/ |
| D | abilis_tb100_dvk.dts | 65 label = "LED2";
|
| D | abilis_tb101_dvk.dts | 65 label = "LED2";
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | imx7d-mba7.dts | 42 /* LED1: Link/Activity, LED2: error */
|
| D | s3c6410-mini6410.dts | 144 label = "LED2";
|
| D | imx7-mba7.dtsi | 217 /* LED1: Link/Activity, LED2: Error */
219 /* Active low, LED1 and LED2 driven by phy */
|
| D | sun4i-a10-cubieboard.dts | 85 gpios = <&pio 7 20 GPIO_ACTIVE_HIGH>; /* LED2 */
|
| D | omap3-devkit8000-common.dtsi | 27 gpios = <&gpio6 3 GPIO_ACTIVE_HIGH>; /* 163 -> LED2 */
|
| D | sh73a0-kzm9g.dts | 92 label = "LED2";
|
| D | imx6q-marsboard.dts | 308 MX6QDL_PAD_EIM_D28__GPIO3_IO28 0x1b0b1 /* LED2 */
|
| /Linux-v5.4/drivers/usb/gadget/udc/ |
| D | net2272.h | 368 #define LED2 26 macro
|
| /Linux-v5.4/arch/arm/mach-omap1/ |
| D | board-osk.c | 219 tps65010_set_led(LED2, OFF); in osk_tps_setup()
|
| /Linux-v5.4/drivers/pinctrl/cirrus/ |
| D | pinctrl-lochnagar.c | 207 LN1_PIN_MUX(LED2, "led2");
308 LN1_PIN(LED1), LN1_PIN(LED2),
646 LN1_GROUP_PIN(LED1), LN1_GROUP_PIN(LED2),
|
| /Linux-v5.4/arch/arm64/boot/dts/actions/ |
| D | s900-bubblegum-96.dts | 212 "LED2", /* GPIO_139 */
|
| /Linux-v5.4/arch/arm64/boot/dts/renesas/ |
| D | r8a774c0-cat874.dts | 53 label = "LED2";
|
| /Linux-v5.4/drivers/net/wireless/zydas/zd1211rw/ |
| D | zd_chip.c | 336 chip->link_led = ((value >> 4) & 1) ? LED1 : LED2; in read_pod()
1321 other_led = chip->link_led == LED1 ? LED2 : LED1; in zd_chip_control_leds()
1326 ioreqs[1].value = v[1] & ~(LED1|LED2); in zd_chip_control_leds()
|
| D | zd_chip.h | 482 #define LED2 (1 << 9) macro
|
| /Linux-v5.4/drivers/mfd/ |
| D | tps65010.c | 776 led = LED2; in tps65010_set_led()
|
