Searched refs:CS1 (Results 1 – 25 of 52) sorted by relevance
123
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | sysfs-class-watchdog | 91 chip at CS1.
93 from (CS0->CS1, CS1->CS0) to (CS0->CS0,
94 CS1->CS1).
100 For alternate boot mode (booted from CS1 due to wdt2
|
| /Linux-v5.4/drivers/staging/fbtft/ |
| D | fb_agm1264k-fl.c | 33 #define CS1 gpio.aux[1] macro
119 if (!par->CS1) { in verify_gpios()
149 par->CS1 = gpio->gpio; in request_gpios_match()
198 gpiod_set_value(par->CS1, 0); in write_reg8_bus8()
202 gpiod_set_value(par->CS1, 1); in write_reg8_bus8()
401 gpiod_set_value(par->CS1, 1); in write_vmem()
|
| /Linux-v5.4/Documentation/devicetree/bindings/memory-controllers/ti/ |
| D | emif.txt | 39 - cs1-used : Have this property if CS1 of this EMIF
41 part attached to CS1, it should be the same type as the one on CS0,
|
| /Linux-v5.4/Documentation/devicetree/bindings/mtd/ |
| D | tango-nand.txt | 34 reg = <1>; /* CS1 */
|
| D | ti,am654-hbmc.txt | 43 <0x1 0x0 0x5 0x04000000 0x4000000>; /* CS1 - 64MB */
|
| D | stm32-fmc2-nand.txt | 11 Regions 5 to 7 contain the same areas for CS1.
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | armada-370-xp.dtsi | 273 <MBUS_ID(0x01, 0x5e) 0 0xffffffff>, /* CS1 */
291 <MBUS_ID(0x01, 0x5a) 0 0xffffffff>, /* CS1 */
|
| D | armada-388-clearfog.dts | 176 * CS1:
|
| D | imx6dl-riotboard.dts | 398 MX6QDL_PAD_DISP0_DAT15__GPIO5_IO09 0x000b1 /* CS1 */
412 MX6QDL_PAD_DISP0_DAT4__GPIO4_IO25 0x000b1 /* CS1 */
|
| D | imx6qdl-ts4900.dtsi | 166 MX6QDL_PAD_EIM_D19__GPIO3_IO19 0x100b1 /* Onboard flash CS1# */
176 MX6QDL_PAD_CSI0_DAT16__GPIO6_IO02 0x100b1 /* FPGA CS1# */
|
| D | omap3-overo-common-lcd35.dtsi | 123 reg = <1>; /* CS1 */
|
| D | omap3430-sdp.dts | 51 <1 0 0x28000000 0x1000000>, /* CS1: 16MB for NAND */
|
| D | armada-388-clearfog.dtsi | 231 * CS1: PIC microcontroller (Pro models)
|
| D | armada-385-turris-omnia.dts | 344 /* MISO, MOSI, SCLK and CS1 are routed to pin header CN11 */
|
| D | logicpd-som-lv-baseboard.dtsi | 63 1 0 0x2c000000 0x1000000 /* CS1: 16MB for LAN9221 */
|
| D | imx6dl-colibri-eval-v3.dts | 231 /* weim memory map: 32MB on CS0, CS1, CS2 and CS3 */
|
| /Linux-v5.4/arch/powerpc/boot/dts/ |
| D | motionpro.dts | 94 // 8-bit DualPort SRAM on LocalPlus Bus CS1
|
| D | charon.dts | 185 1 0 0xe0000000 0x04000000 // CS1 range, SM501
|
| D | mpc8308rdb.dts | 54 // CS0 and CS1 are swapped when
|
| /Linux-v5.4/Documentation/devicetree/bindings/memory-controllers/ |
| D | ingenic,jz4780-nemc.txt | 46 Example (NEMC node with a NAND child device attached at CS1):
|
| /Linux-v5.4/Documentation/devicetree/bindings/bus/ |
| D | qcom,ebi2.txt | 18 Also CS1 and CS2 has -A and -B signals. Why they have that is unclear to me.
25 CS1 GPIO39 (A) / GPIO123 (B) 0x1b000000-0x1b800000 (8MB)
|
| D | uniphier-system-bus.txt | 63 - the Ethernet device is connected at the offset 0x01f00000 of CS1 and
|
| D | imx-weim.txt | 36 IOMUXC_GPR1[11:0] CS0 CS1 CS2 CS3
|
| /Linux-v5.4/Documentation/devicetree/bindings/spi/ |
| D | spi-orion.txt | 51 <MBUS_ID(0x01, 0x5e) 0 0xffffffff>, /* CS1 */
|
| /Linux-v5.4/drivers/media/dvb-frontends/ |
| D | bcm3510_priv.h | 141 u8 CS1 :1; member
|
123
