| /Linux-v5.15/Documentation/admin-guide/pm/ |
| D | intel_pstate.rst | 222 the so-called "turbo" frequency ranges). In other words, in the passive mode
238 will be referred to as the "turbo threshold" in what follows.
240 The P-states above the turbo threshold are referred to as "turbo P-states" and
241 the whole sub-range of P-states they belong to is referred to as the "turbo
247 Specifically, if software sets the P-state of a CPU core within the turbo range
248 (that is, above the turbo threshold), the processor is permitted to take over
249 performance scaling control for that core and put it into turbo P-states of its
253 the given core, even if it is within the turbo range, whereas all of the later
255 turbo range, even above the one set by software. In other words, on those
256 processors setting any P-state from the turbo range will enable the processor
[all …]
|
| D | intel-speed-select.rst | 75 Intel(R) SST-TF (feature turbo-freq) is supported
155 speed-select-turbo-freq:disabled
184 speed-select-turbo-freq:disabled
216 workload, disable turbo::
277 speed-select-turbo-freq:disabled
281 speed-select-turbo-freq:disabled
290 "speed-select-turbo-freq" (Intel(R) SST-TF) is supported at both performance
551 that turbo is disabled. To disable turbo, execute::
578 frequency as the turbo is disabled). The turbostat output::
709 This feature enables the ability to set different "All core turbo ratio limits"
[all …]
|
| /Linux-v5.15/Documentation/ABI/testing/ |
| D | sysfs-platform-msi-laptop | 46 Contains either 0 or 1 and indicates if turbo mode is turned
47 on. In turbo mode power LED is orange and processor is
49 only possible to toggle turbo mode state by pressing Fn+F10,
51 If user presses Fn+F10 too frequent, turbo mode state is not
|
| D | sysfs-devices-system-cpu | 334 no_turbo: limits the driver to selecting P states below the turbo
438 frequency is throttled to lower frequency in turbo (at and above
442 max frequency is throttled to lower frequency in sub-turbo(below
|
| /Linux-v5.15/Documentation/scheduler/ |
| D | schedutil.txt | 64 4C-turbo; if available and turbo enabled
65 f_max := { 1C-turbo; if turbo enabled
72 We pick 4C turbo over 1C turbo to make it slightly more sustainable.
|
| /Linux-v5.15/arch/arm64/boot/dts/qcom/ |
| D | sdm850.dtsi | 19 turbo-mode;
|
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | exynos4412-prime.dtsi | 16 /delete-property/turbo-mode;
|
| D | omap34xx.dtsi | 76 turbo-mode;
|
| /Linux-v5.15/drivers/misc/ |
| D | xilinx_sdfec.c | 410 struct xsdfec_turbo turbo; in xsdfec_set_turbo() local
414 err = copy_from_user(&turbo, arg, sizeof(turbo)); in xsdfec_set_turbo()
418 if (turbo.alg >= XSDFEC_TURBO_ALG_MAX) in xsdfec_set_turbo()
421 if (turbo.scale > XSDFEC_TURBO_SCALE_MAX) in xsdfec_set_turbo()
428 turbo_write = ((turbo.scale & XSDFEC_TURBO_SCALE_MASK) in xsdfec_set_turbo()
430 turbo.alg; in xsdfec_set_turbo()
|
| /Linux-v5.15/arch/arm/mach-pxa/ |
| D | sleep.S | 115 @ ensure x1 for run and turbo mode with memory clock
127 @ note, turbo is not preserved over sleep so there is no
|
| /Linux-v5.15/drivers/net/wireless/ath/ath5k/ |
| D | reset.c | 672 u32 turbo, mode, clock, bus_flags; in ath5k_hw_nic_wakeup() local
675 turbo = 0; in ath5k_hw_nic_wakeup()
792 turbo = AR5K_PHY_TURBO_MODE; in ath5k_hw_nic_wakeup()
794 turbo |= AR5K_PHY_TURBO_SHORT; in ath5k_hw_nic_wakeup()
825 ath5k_hw_reg_write(ah, turbo, AR5K_PHY_TURBO); in ath5k_hw_nic_wakeup()
|
| /Linux-v5.15/arch/powerpc/boot/dts/ |
| D | klondike.dts | 166 turbo = "no";
196 turbo = "no";
|
| /Linux-v5.15/drivers/opp/ |
| D | opp.h | 80 bool turbo; member
|
| D | debugfs.c | 130 debugfs_create_bool("turbo", S_IRUGO, d, &opp->turbo); in opp_debug_create_one()
|
| D | of.c | 860 new_opp->turbo = of_property_read_bool(np, "turbo-mode"); in _opp_add_static_v2()
907 __func__, new_opp->turbo, new_opp->rate, in _opp_add_static_v2()
|
| /Linux-v5.15/Documentation/userspace-api/media/dvb/ |
| D | frontend-property-satellite-systems.rst | 74 In addition to all parameters valid for DVB-S, turbo code supports the
|
| /Linux-v5.15/arch/arm/mm/ |
| D | proc-mohawk.S | 345 mrc p14, 0, r4, c6, c0, 0 @ clock configuration, for turbo mode
363 mcr p14, 0, r4, c6, c0, 0 @ clock configuration, turbo mode.
|
| D | proc-xsc3.S | 416 mrc p14, 0, r4, c6, c0, 0 @ clock configuration, for turbo mode
434 mcr p14, 0, r4, c6, c0, 0 @ clock configuration, turbo mode.
|
| D | proc-xscale.S | 532 mrc p14, 0, r4, c6, c0, 0 @ clock configuration, for turbo mode
548 mcr p14, 0, r4, c6, c0, 0 @ clock configuration, turbo mode.
|
| /Linux-v5.15/Documentation/input/devices/ |
| D | bcm5974.rst | 19 :Copyright: |copy| 2005 Frank Arnold (frank@scirocco-5v-turbo.de)
|
| /Linux-v5.15/Documentation/devicetree/bindings/misc/ |
| D | xlnx,sd-fec.txt | 25 - xlnx,sdfec-code : Should contain "ldpc" or "turbo" to describe the codes
|
| /Linux-v5.15/drivers/platform/x86/ |
| D | acer-wmi.c | 314 u8 turbo; member
329 if (quirks->turbo) in set_quirks()
361 .turbo = 1,
|
| /Linux-v5.15/Documentation/networking/ |
| D | plip.rst | 26 LapLink null-printer cable [can also work in turbo mode, with a PLIP
|
| /Linux-v5.15/drivers/cpufreq/ |
| D | intel_pstate.c | 162 int turbo; member
1602 vid = cpudata->vid.turbo; in atom_get_val()
1651 cpudata->vid.turbo = value & 0x7f; in atom_get_vid()
|
| /Linux-v5.15/arch/arm64/boot/dts/renesas/ |
| D | r8a77961.dtsi | 73 turbo-mode;
79 turbo-mode;
85 turbo-mode;
112 turbo-mode;
|
