| /Linux-v5.15/drivers/comedi/drivers/ |
| D | ni_6527.c | 275 unsigned int rising, in ni6527_set_edge_detection() argument
280 rising &= mask; in ni6527_set_edge_detection()
286 rising |= readb(dev->mmio + in ni6527_set_edge_detection()
295 writeb(rising & 0xff, in ni6527_set_edge_detection()
301 rising >>= 8; in ni6527_set_edge_detection()
313 unsigned int rising, falling, shift; in ni6527_intr_insn_config() local
320 rising = data[1]; in ni6527_intr_insn_config()
322 ni6527_set_edge_detection(dev, mask, rising, falling); in ni6527_intr_insn_config()
331 rising = 0; in ni6527_intr_insn_config()
339 rising = 0; in ni6527_intr_insn_config()
[all …]
|
| /Linux-v5.15/drivers/iio/cdc/ |
| D | ad7150.c | 190 int rising = (dir == IIO_EV_DIR_RISING); in ad7150_write_event_params() local
199 u16 value = chip->threshold[rising][chan]; in ad7150_write_event_params()
208 sens = chip->thresh_sensitivity[rising][chan]; in ad7150_write_event_params()
259 int rising = (dir == IIO_EV_DIR_RISING); in ad7150_write_event_config() local
283 if (rising) in ad7150_write_event_config()
332 int rising = (dir == IIO_EV_DIR_RISING); in ad7150_read_event_value() local
339 *val = chip->thresh_sensitivity[rising][chan->channel]; in ad7150_read_event_value()
342 *val = chip->threshold[rising][chan->channel]; in ad7150_read_event_value()
349 *val2 = chip->thresh_timeout[rising][chan->channel] * 10000; in ad7150_read_event_value()
365 int rising = (dir == IIO_EV_DIR_RISING); in ad7150_write_event_value() local
[all …]
|
| /Linux-v5.15/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-timer-stm32 | 37 OC4REF rising or falling edges generate pulses.
39 OC6REF rising or falling edges generate pulses.
41 OC4REF or OC6REF rising edges generate pulses.
43 OC4REF rising or OC6REF falling edges generate
46 OC5REF or OC6REF rising edges generate pulses.
48 OC5REF rising or OC6REF falling edges generate
134 Counting is enabled on rising edge of the connected
151 rising edges.
|
| D | sysfs-bus-iio-adc-hi8435 | 27 If falling threshold results hysteresis to odd value then rising
36 this value then the threshold rising event is pushed.
47 If rising threshold results hysteresis to odd value then falling
|
| D | sysfs-bus-iio-light-lm3533-als | 7 in each direction (rising|falling) and a zone change occurs.
42 in_illuminance0_threshY_{falling,rising} thresholds.
|
| D | sysfs-bus-iio-adc-stm32 | 9 - "rising-edge"
|
| /Linux-v5.15/drivers/iio/proximity/ |
| D | ping.c | 58 struct completion rising; member
83 complete(&data->rising); in ping_handle_irq()
107 reinit_completion(&data->rising); in ping_read()
137 ret = wait_for_completion_killable_timeout(&data->rising, HZ/50); in ping_read()
294 init_completion(&data->rising); in ping_probe()
|
| D | srf04.c | 65 struct completion rising; member
87 complete(&data->rising); in srf04_handle_irq()
114 reinit_completion(&data->rising); in srf04_read()
127 ret = wait_for_completion_killable_timeout(&data->rising, HZ/50); in srf04_read()
267 init_completion(&data->rising); in srf04_probe()
|
| /Linux-v5.15/drivers/gpio/ |
| D | gpio-xilinx.c | 506 DECLARE_BITMAP(rising, 64); in xgpio_irqhandler()
522 bitmap_complement(rising, chip->last_irq_read, 64); in xgpio_irqhandler()
523 bitmap_and(rising, rising, all, 64); in xgpio_irqhandler()
524 bitmap_and(rising, rising, chip->enable, 64); in xgpio_irqhandler()
525 bitmap_and(rising, rising, chip->rising_edge, 64); in xgpio_irqhandler()
533 bitmap_or(all, rising, falling, 64); in xgpio_irqhandler()
537 dev_dbg(gc->parent, "IRQ rising %*pb falling %*pb\n", 64, rising, 64, falling); in xgpio_irqhandler()
|
| D | gpio-mt7621.c | 37 u32 rising; member
120 mtk_gpio_w32(rg, GPIO_REG_REDGE, rise | (BIT(pin) & rg->rising)); in mediatek_gpio_irq_unmask()
157 if ((rg->rising | rg->falling | in mediatek_gpio_irq_type()
164 rg->rising &= ~mask; in mediatek_gpio_irq_type()
171 rg->rising |= mask; in mediatek_gpio_irq_type()
175 rg->rising |= mask; in mediatek_gpio_irq_type()
|
| D | gpio-sch.c | 178 int rising, falling; in sch_irq_type() local
182 rising = 1; in sch_irq_type()
186 rising = 0; in sch_irq_type()
190 rising = 1; in sch_irq_type()
199 sch_gpio_reg_set(sch, gpio_num, GTPE, rising); in sch_irq_type()
|
| D | gpio-hlwd.c | 76 u32 level, rising, falling; in hlwd_gpio_irqhandler() local
79 rising = level & emulated_pending; in hlwd_gpio_irqhandler()
90 rising &= hlwd->rising_edge; in hlwd_gpio_irqhandler()
94 pending |= rising | falling; in hlwd_gpio_irqhandler()
|
| D | gpio-pl061.c | 179 bool rising = trigger & IRQ_TYPE_EDGE_RISING; in pl061_irq_type() local
186 if (rising) in pl061_irq_type()
193 rising ? "RISING" : "FALLING"); in pl061_irq_type()
|
| /Linux-v5.15/Documentation/devicetree/bindings/net/nfc/ |
| D | nfcmrvl.txt | 22 - i2c-int-rising: Specifies that the chip read event shall be trigged on
23 rising edge.
55 i2c-int-rising;
|
| /Linux-v5.15/Documentation/devicetree/bindings/gpio/ |
| D | cavium-octeon-gpio.txt | 21 1 - edge triggered on the rising edge.
37 * 2) Triggering (1 - edge rising
|
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | stm32mp15xx-dhcom-picoitx.dtsi | 82 i2c-scl-rising-time-ns = <185>;
93 i2c-scl-rising-time-ns = <185>;
|
| D | stm32mp157a-stinger96.dtsi | 89 i2c-scl-rising-time-ns = <1000>;
99 i2c-scl-rising-time-ns = <185>;
232 interrupt-names = "onkey-falling", "onkey-rising";
|
| D | stm32mp15xx-dhcor-som.dtsi | 35 i2c-scl-rising-time-ns = <185>;
165 interrupt-names = "onkey-falling", "onkey-rising";
|
| D | stm32mp15xx-dhcom-drc02.dtsi | 75 i2c-scl-rising-time-ns = <185>;
99 i2c-scl-rising-time-ns = <185>;
|
| D | stm32mp15xx-osd32.dtsi | 66 i2c-scl-rising-time-ns = <185>;
195 interrupt-names = "onkey-falling", "onkey-rising";
|
| /Linux-v5.15/Documentation/devicetree/bindings/sound/ |
| D | cs35l34.txt | 44 - cirrus,tdm-rising-edge: Boolean property. If set, data is on the rising edge of
|
| /Linux-v5.15/drivers/net/dsa/mv88e6xxx/ |
| D | ptp.c | 120 int rising) in mv88e6352_config_eventcap() argument
128 if (!rising) in mv88e6352_config_eventcap()
271 int rising = (rq->extts.flags & PTP_RISING_EDGE); in mv88e6352_ptp_enable_extts() local
306 err = mv88e6352_config_eventcap(chip, PTP_CLOCK_EXTTS, rising); in mv88e6352_ptp_enable_extts()
|
| /Linux-v5.15/Documentation/devicetree/bindings/net/ |
| D | qca,qca7000.txt | 17 type as rising edge
50 interrupts = <25 0x1>; /* Index: 25, rising edge */
|
| /Linux-v5.15/arch/arm64/boot/dts/rockchip/ |
| D | rk3399-sapphire-excavator.dts | 161 i2c-scl-rising-time-ns = <300>;
177 i2c-scl-rising-time-ns = <600>;
|
| /Linux-v5.15/Documentation/devicetree/bindings/interrupt-controller/ |
| D | faraday,ftintc010.txt | 13 Must be 2 as the controller can specify level or rising edge
|
