| /Linux-v5.15/drivers/net/wireless/intel/ipw2x00/ |
| D | Kconfig | 42 bool "Enable promiscuous mode"
45 Enables promiscuous/monitor mode support for the ipw2100 driver.
47 promiscuous mode via the Wireless Tool's Monitor mode. While in this
104 bool "Enable promiscuous mode"
107 Enables promiscuous/monitor mode support for the ipw2200 driver.
109 promiscuous mode via the Wireless Tool's Monitor mode. While in this
117 bool "Enable creation of a RF radiotap promiscuous interface"
|
| /Linux-v5.15/Documentation/networking/device_drivers/ethernet/intel/ |
| D | ice.rst | 567 trusted VF to request selective promiscuous mode on the Physical Function (PF).
574 NOTE: It's important to set the VF to trusted before setting promiscuous mode.
575 If the VM is not trusted, the PF will ignore promiscuous mode requests from the
577 new request to set the VF to promiscuous.
580 set the VF to promiscuous mode.
582 For promiscuous all::
587 For promiscuous Multicast::
593 "off," meaning that promiscuous mode for the VF will be limited. To set the
594 promiscuous mode for the VF to true promiscuous and allow the VF to see all
599 The vf-true-promisc-support private flag does not enable promiscuous mode;
[all …]
|
| D | i40e.rst | 80 promiscuous mode on the Physical Function (PF).
88 set the VF to promiscuous mode.
92 For promiscuous all:
96 For promiscuous Multicast:
101 "off",meaning that promiscuous mode for the VF will be limited. To set the
102 promiscuous mode for the VF to true promiscuous and allow the VF to see all
107 The vf-true-promisc-support priv-flag does not enable promiscuous mode; rather,
108 it designates which type of promiscuous mode (limited or true) you will get
109 when you enable promiscuous mode using the ip link commands above. Note that
112 device. The PF remains in limited promiscuous mode (unless it is in MFP mode)
[all …]
|
| /Linux-v5.15/drivers/net/ethernet/micrel/ |
| D | ksz884x.c | 1224 u8 promiscuous; member
1407 int promiscuous; member
3712 if (hw->promiscuous) in hw_setup()
5303 if (priv->promiscuous) in netdev_close()
5304 --hw->promiscuous; in netdev_close()
5373 hw->promiscuous = 0; in prepare_hardware()
5419 priv->promiscuous = 0; in netdev_open()
5598 struct ksz_hw *hw, int promiscuous) in dev_set_promiscuous() argument
5600 if (promiscuous != priv->promiscuous) { in dev_set_promiscuous()
5601 u8 prev_state = hw->promiscuous; in dev_set_promiscuous()
[all …]
|
| /Linux-v5.15/drivers/net/ieee802154/ |
| D | cc2520.c | 213 bool promiscuous; /* Flag for promiscuous mode */ member
485 if (priv->promiscuous) { in cc2520_tx()
567 if (!priv->promiscuous) { in cc2520_rx()
797 priv->promiscuous = on; in cc2520_set_promiscuous_mode()
|
| D | ca8210.c | 374 bool promiscuous; member
680 priv->promiscuous = false; in ca8210_reset_send()
1827 if (priv->promiscuous) in ca8210_skb_rx()
2383 priv->promiscuous = on; in ca8210_set_promiscuous_mode()
3129 priv->promiscuous = false; in ca8210_probe()
|
| D | adf7242.c | 281 bool promiscuous; member
798 lp->promiscuous = on; in adf7242_set_promiscuous_mode()
1052 adf7242_set_promiscuous_mode(lp->hw, lp->promiscuous); in adf7242_soft_reset()
|
| /Linux-v5.15/drivers/net/wireless/intersil/orinoco/ |
| D | orinoco.h | 142 int promiscuous, mc_count; member
|
| D | hw.c | 680 priv->promiscuous = 0; in orinoco_hw_program_rids()
1078 if (promisc != priv->promiscuous) { in __orinoco_hw_set_multicast_list()
1086 priv->promiscuous = promisc; in __orinoco_hw_set_multicast_list()
|
| /Linux-v5.15/Documentation/networking/device_drivers/ethernet/ti/ |
| D | cpsw_switchdev.rst | 30 - optimized promiscuous mode: The P0_UNI_FLOOD (both ports) is enabled in
32 So, Ports in promiscuous mode will keep possibility of mcast and vlan
|
| /Linux-v5.15/Documentation/networking/device_drivers/fddi/ |
| D | defza.rst | 38 requested explicitly or if the CAM overflows. The promiscuous mode
|
| /Linux-v5.15/net/batman-adv/ |
| D | Kconfig | 64 configured to have promiscuous mode enabled in order to make
|
| /Linux-v5.15/drivers/net/wireless/st/cw1200/ |
| D | debug.c | 129 if (priv->rx_filter.promiscuous) in cw1200_status_show()
|
| D | wsm.h | 1353 bool promiscuous; member
1363 if (arg->promiscuous) in wsm_set_rx_filter()
|
| /Linux-v5.15/drivers/net/arcnet/ |
| D | Kconfig | 110 things as promiscuous mode, so packet sniffing is possible, and
|
| /Linux-v5.15/drivers/net/ethernet/cortina/ |
| D | gemini.h | 709 unsigned int promiscuous:1; member
|
| /Linux-v5.15/Documentation/networking/ |
| D | ipvlan.rst | 131 puts the NIC in promiscuous mode and degraded performance is a concern.
|
| D | decnet.rst | 217 will simply set themselves into promiscuous mode in order to receive
|
| D | bonding.rst | 1927 underlying device -- i.e. the bonding interface -- to promiscuous
2171 common to enable promiscuous mode on the device, so that all traffic
2173 The bonding driver handles promiscuous mode changes to the bonding
2178 the promiscuous mode setting is propagated to all slaves.
2181 promiscuous mode setting is propagated only to the active slave.
2192 promiscuous setting will be propagated to the new active slave.
|
| /Linux-v5.15/drivers/net/ethernet/intel/ |
| D | e100.c | 565 promiscuous = (1 << 1), enumerator
1111 if (nic->flags & promiscuous || nic->loopback) { in e100_configure()
1587 nic->flags |= promiscuous; in e100_set_multicast_list()
1589 nic->flags &= ~promiscuous; in e100_set_multicast_list()
|
| /Linux-v5.15/drivers/net/ethernet/ibm/ |
| D | ibmvnic.h | 154 __be32 promiscuous; member
|
| /Linux-v5.15/Documentation/admin-guide/media/ |
| D | faq.rst | 180 into promiscuous mode so it accepts any packets from the PID
|
| /Linux-v5.15/drivers/net/ethernet/marvell/ |
| D | mv643xx_eth.c | 1866 goto promiscuous; in mv643xx_eth_program_multicast_filter()
1871 goto promiscuous; in mv643xx_eth_program_multicast_filter()
1900 promiscuous: in mv643xx_eth_program_multicast_filter()
|
| /Linux-v5.15/drivers/scsi/be2iscsi/ |
| D | be_cmds.h | 686 u8 promiscuous; member
|
| /Linux-v5.15/Documentation/networking/devlink/ |
| D | devlink-trap.rst | 487 the interface is not in promiscuous mode
|
