Searched refs:oversampling (Results 1 – 9 of 9) sorted by relevance
| /Linux-v5.15/Documentation/devicetree/bindings/media/i2c/ |
| D | adv7343.txt | 16 - adi,power-mode-pll-ctrl: PLL and oversampling control. This control allows
18 oversampling to be switched off.
|
| /Linux-v5.15/drivers/spi/ |
| D | spi-geni-qcom.c | 82 unsigned int oversampling; member
99 speed_hz * mas->oversampling, in get_spi_clk_cfg()
107 *clk_div = DIV_ROUND_UP(sclk_freq, mas->oversampling * speed_hz); in get_spi_clk_cfg()
108 actual_hz = sclk_freq / (mas->oversampling * *clk_div); in get_spi_clk_cfg()
379 mas->oversampling = 2; in spi_geni_init()
381 mas->oversampling = 1; in spi_geni_init()
|
| /Linux-v5.15/drivers/iio/adc/ |
| D | ad7606.h | 98 unsigned int oversampling; member
|
| D | ad7606.c | 194 *val = st->oversampling; in ad7606_read_raw()
288 st->oversampling = st->oversampling_avail[i]; in ad7606_write_raw()
587 st->oversampling = 1; in ad7606_probe()
|
| /Linux-v5.15/drivers/tty/serial/ |
| D | amba-pl011.c | 84 bool oversampling; member
105 .oversampling = false,
120 .oversampling = false,
136 .oversampling = false,
183 .oversampling = true,
2035 if (uap->vendor->oversampling) in pl011_set_termios()
2123 if (uap->vendor->oversampling) { in pl011_set_termios()
2136 if (uap->vendor->oversampling) { in pl011_set_termios()
2408 if (uap->vendor->oversampling) { in pl011_console_get_options()
|
| D | stm32-usart.c | 730 u32 usartdiv, mantissa, fraction, oversampling; in stm32_usart_set_termios() local
839 oversampling = 8; in stm32_usart_set_termios()
843 oversampling = 16; in stm32_usart_set_termios()
848 mantissa = (usartdiv / oversampling) << USART_BRR_DIV_M_SHIFT; in stm32_usart_set_termios()
849 fraction = usartdiv % oversampling; in stm32_usart_set_termios()
|
| /Linux-v5.15/Documentation/sound/soc/ |
| D | overview.rst | 24 power via changing codec oversampling rates, bias currents, etc.
|
| /Linux-v5.15/drivers/tty/serial/8250/ |
| D | Kconfig | 354 Uses 8 times oversampling (compared to 16 times for 16650)
|
| /Linux-v5.15/Documentation/ABI/testing/ |
| D | sysfs-bus-iio | 124 Hardware dependent ADC oversampling. Controls the sampling ratio
131 Hardware dependent values supported by the oversampling filter.
|
