Searched refs:nanoseconds (Results 1 – 25 of 87) sorted by relevance
1234
| /Linux-v5.15/Documentation/block/ |
| D | kyber-iosched.rst | 11 Target latency for reads (in nanoseconds).
15 Target latency for synchronous writes (in nanoseconds).
|
| /Linux-v5.15/Documentation/ABI/testing/ |
| D | sysfs-firmware-acpi | 12 of firmware image execution. In nanoseconds.
15 In nanoseconds.
18 image. In nanoseconds.
22 firmware. In nanoseconds.
26 UEFI compatible firmware. In nanoseconds.
30 nanoseconds.
33 hardware entry to S3. In nanoseconds.
39 including the most recent resume. In nanoseconds.
42 handoff to the OS waking vector. In nanoseconds.
|
| D | sysfs-class-scsi_tape | 21 closed. This item is measured in nanoseconds.
64 Shows the total amount of time in nanoseconds waiting for
95 Shows the total amount of time in nanoseconds waiting for
|
| D | sysfs-ptp | 122 and nanoseconds.
131 seconds, start time nanoseconds, period seconds, and
132 period nanoseconds. To disable a periodic output, set
133 all the seconds and nanoseconds values to zero.
|
| D | sysfs-class-pwm | 55 Sets the PWM signal period in nanoseconds.
62 Sets the PWM signal duty cycle in nanoseconds.
|
| /Linux-v5.15/Documentation/devicetree/bindings/input/touchscreen/ |
| D | fsl-mx25-tcq.txt | 14 - fsl,pen-debounce-ns: Pen debounce time in nanoseconds.
20 - fsl,settling-time-ns: Settling time in nanoseconds. The settling time is before
|
| /Linux-v5.15/Documentation/devicetree/bindings/i2c/ |
| D | i2c.txt | 38 Number of nanoseconds the SCL signal takes to fall; t(f) in the I2C
42 Number of nanoseconds the IP core additionally needs to setup SCL.
45 Number of nanoseconds the SCL signal takes to rise; t(r) in the I2C
49 Number of nanoseconds the SDA signal takes to fall; t(f) in the I2C
60 (i2c-digital-filter). This width is specified in nanoseconds.
|
| /Linux-v5.15/Documentation/devicetree/bindings/memory-controllers/ |
| D | omap-gpmc.txt | 57 Chip-select signal timings (in nanoseconds) corresponding to GPMC_CONFIG2:
62 ADV signal timings (in nanoseconds) corresponding to GPMC_CONFIG3:
70 WE signals timings (in nanoseconds) corresponding to GPMC_CONFIG4:
74 OE signals timings (in nanoseconds) corresponding to GPMC_CONFIG4:
80 Access time and cycle time timings (in nanoseconds) corresponding to
|
| /Linux-v5.15/Documentation/devicetree/bindings/spi/ |
| D | spi-fsl-dspi.txt | 29 - fsl,spi-cs-sck-delay: a delay in nanoseconds between activating chip
31 - fsl,spi-sck-cs-delay: a delay in nanoseconds between stopping the clock
|
| /Linux-v5.15/tools/lib/traceevent/Documentation/ |
| D | libtraceevent-set_flag.txt | 60 /* Print timestamps in nanoseconds */
64 /* print timestamps in nanoseconds */
|
| /Linux-v5.15/Documentation/devicetree/bindings/cpufreq/ |
| D | cpufreq-spear.txt | 14 unit of nanoseconds.
|
| D | nvidia,tegra124-cpufreq.txt | 18 in unit of nanoseconds.
|
| D | cpufreq-dt.txt | 18 in unit of nanoseconds.
|
| /Linux-v5.15/Documentation/devicetree/bindings/clock/ |
| D | nvidia,tegra124-dfll.txt | 56 - nvidia,pwm-period-nanoseconds: period of PWM square wave in nanoseconds.
128 nvidia,pwm-period-nanoseconds = <2500>; /* 2.5us */
|
| D | pwm-clock.txt | 17 is not exact but was rounded to nanoseconds.
|
| /Linux-v5.15/Documentation/devicetree/bindings/ptp/ |
| D | ptp-qoriq.txt | 16 - fsl,tclk-period Timer reference clock period in nanoseconds.
35 tclk_period = desired clock period nanoseconds
|
| /Linux-v5.15/Documentation/devicetree/bindings/pwm/ |
| D | pxa-pwm.txt | 14 nanoseconds.
|
| D | pwm-st.txt | 8 second cell is the period in nanoseconds - fixed to 2
|
| /Linux-v5.15/Documentation/accounting/ |
| D | taskstats-struct.rst | 106 * xxx_delay_total is the corresponding cumulative delay in nanoseconds
133 * Value is cumulative, in nanoseconds, without a corresponding count
141 * Value is cumulative, in nanoseconds, without a corresponding count
|
| /Linux-v5.15/Documentation/virt/kvm/ |
| D | msr.rst | 48 number of nanoseconds for wallclock at time of boot.
100 nanoseconds.
104 tsc-related quantity to nanoseconds
108 quantity to nanoseconds. This shift will ensure that
113 The conversion from tsc to nanoseconds involves an additional
298 nanoseconds. Time during which the vcpu is idle, will not be
|
| /Linux-v5.15/tools/perf/Documentation/ |
| D | perf-timechart.txt | 67 as number of nanoseconds. If non-numeric string is given it's
77 Merge events that are merge-dist nanoseconds apart.
|
| /Linux-v5.15/Documentation/devicetree/bindings/net/ |
| D | cpsw.txt | 39 - cpts_clock_mult : Numerator to convert input clock ticks into nanoseconds
40 - cpts_clock_shift : Denominator to convert input clock ticks into nanoseconds
|
| /Linux-v5.15/drivers/iio/light/ |
| D | si1133.c | 518 static int si1133_get_int_time_index(int milliseconds, int nanoseconds) in si1133_get_int_time_index() argument
524 nanoseconds == si1133_int_time_table[i][1]) in si1133_get_int_time_index()
531 int milliseconds, int nanoseconds) in si1133_set_integration_time() argument
535 index = si1133_get_int_time_index(milliseconds, nanoseconds); in si1133_set_integration_time()
|
| /Linux-v5.15/Documentation/admin-guide/cgroup-v1/ |
| D | blkio-controller.rst | 166 for the IOs done by this cgroup. This is in nanoseconds to make it
187 device). This is in nanoseconds to make it meaningful for flash
215 waiting in the scheduler queue. This is in nanoseconds. If this is
225 nanoseconds. If this is read when the cgroup is in an empty state,
233 from other queues/cgroups. This is in nanoseconds. If this is read
|
| /Linux-v5.15/Documentation/trace/ |
| D | events-nmi.rst | 32 to the filter is in nanoseconds! You can filter on 'delta_ns'::
|
1234
