Searched refs:measurements (Results 1 – 25 of 78) sorted by relevance
1234
11 addition the following input measurements are enabled per mode:23 allows a subset of the measurements to be enabled:28 3: All measurements per mode
11 chip takes continuous measurements). The continuous mode is15 while still needs some measurements occasionally.
11 dual tachometer measurements, and fan health monitoring.
8 proximity measurements constructed by hardware by9 combining measurements taken from a given set of
50 Used for performance and utilization measurements.56 Used for performance and utilization measurements.
18 on the signal from which time of flight measurements are
25 measurements due to changing temperature and ambient
25 1: 4 measurements26 2: 8 measurements27 3: 16 measurements
262 unsigned int measurements) in max30102_read_measurement() argument269 measurements * in max30102_read_measurement()273 switch (measurements) { in max30102_read_measurement()287 return (ret == measurements * MAX30102_REG_FIFO_DATA_BYTES) ? in max30102_read_measurement()295 unsigned int measurements = bitmap_weight(indio_dev->active_scan_mask, in max30102_interrupt_handler() local302 ret = max30102_read_measurement(data, measurements); in max30102_interrupt_handler()
34 in[1-20]_input Input voltage measurements (mV)36 fan[1-12]_input Fan tachometer measurements (rpm)
50 measurements, activates the corresponding alarm55 current measurements.
35 the threshold status bits. Depending on the measurements timeout settings64 provides a constant measurements discreteness. The data scaling is also104 temperature measurements within 7.130
27 An in-line attenuator allows measurements from 0 to 6 V. The
65 e.g. maximum two measurements per second at the given resolution.
59 The "curr*_input" measurements actually report the voltage drop across the
68 measurements. Several inputs have integrated attenuators so they can measure73 for negative voltage measurements.
22 dual tachometer measurements, and fan health monitoring.
108 bit count measurements. The frontend may reset it when a136 bit count measurements. The frontend may reset it when a165 bit count measurements. The frontend may reset it when a193 bit count measurements. The frontend may reset it when a214 bit count measurements. The frontend may reset it when a
10 TV standards, doesn't provide good statistics measurements and provides
37 device driver during its lifetime. For meaningful measurements, the
56 - dlg,jack-rate-us : Time between jack detect measurements (us)58 - dlg,jack-debounce : Number of debounce measurements taken for jack detect
32 measurements.33 Writing value "1" is setting the IAD bit (enables the measurements).
178 # Table of individual measurements:230 disable events during measurements:296 Aggregate counts per processor socket for system-wide mode measurements. This303 Aggregate counts per processor die for system-wide mode measurements. This310 Aggregate counts per physical processor for system-wide mode measurements. This320 Aggregate counts per NUMA nodes for system-wide mode measurements. This375 Aggregate counts per processor socket for system-wide mode measurements.378 Aggregate counts per processor die for system-wide mode measurements.381 Aggregate counts per physical processor for system-wide mode measurements.
13 measurements).
10 estimate signal strength and signal to noise measurements in dB.
