Searched refs:leaving (Results 1 – 25 of 79) sorted by relevance
1234
/Linux-v5.15/net/bridge/ |
D | br_switchdev.c | 198 static void nbp_switchdev_hwdom_put(struct net_bridge_port *leaving) in nbp_switchdev_hwdom_put() argument 200 struct net_bridge *br = leaving->br; in nbp_switchdev_hwdom_put() 205 if (p->hwdom == leaving->hwdom) in nbp_switchdev_hwdom_put() 209 clear_bit(leaving->hwdom, &br->busy_hwdoms); in nbp_switchdev_hwdom_put()
|
/Linux-v5.15/Documentation/ABI/testing/ |
D | sysfs-class-led-trigger-oneshot | 25 delay_on ms, then blink off for delay_off ms, leaving the LED 27 blink on for delay_on ms, leaving the LED normally on.
|
/Linux-v5.15/Documentation/filesystems/ |
D | hfsplus.rst | 33 leaving that decision to the CDROM driver. This option will fail
|
D | hfs.rst | 38 leaving that decision to the CDROM driver. This option will fail
|
D | ocfs2.rst | 84 Setting it to 0 will have the same effect as leaving
|
/Linux-v5.15/net/tipc/ |
D | Kconfig | 48 advanced algorithm: AEAD AES-GCM (like IPSec or TLS) before leaving/
|
/Linux-v5.15/Documentation/netlabel/ |
D | cipso_ipv4.rst | 23 adding the CIPSO label to the socket. This causes all packets leaving the
|
/Linux-v5.15/Documentation/ABI/stable/ |
D | sysfs-firmware-opal-elog | 32 do not parse this at all in kernel, leaving it up to
|
/Linux-v5.15/tools/testing/selftests/futex/ |
D | README | 56 Perhaps something like "wait-wake-1" "wait-wake-2" is adequate, leaving the
|
/Linux-v5.15/Documentation/networking/ |
D | page_pool.rst | 16 must run page_pool_release_page() when a page is leaving the page_pool or
|
D | batman-adv.rst | 134 Counters for different types of packets entering and leaving the batman-adv
|
/Linux-v5.15/Documentation/driver-api/media/ |
D | tx-rx.rst | 131 effectively leaving the current frame unfinished. The receiver driver
|
/Linux-v5.15/Documentation/devicetree/bindings/mtd/ |
D | marvell-nand.txt | 43 from the core and leaving them completely untouched. Bootloader
|
/Linux-v5.15/arch/arm/boot/dts/ |
D | imx6qdl-cubox-i.dtsi | 197 * leaving it as a pull-up, even if it is just 10uA.
|
D | bcm283x.dtsi | 14 * bcm2835 and bcm2836 implementations, leaving the CPU configuration to
|
/Linux-v5.15/Documentation/ide/ |
D | ChangeLog.ide-cd.1994-2004 | 5 * 1.03 Nov 25, 1994 -- leaving unmask_intr[] as a user-setting (as for disks) 230 * - CD-ROM leaving door locked fix from Andries
|
/Linux-v5.15/mm/ |
D | Kconfig.debug | 112 This is useful for discovering cases where the kernel is leaving W+X
|
/Linux-v5.15/Documentation/userspace-api/media/v4l/ |
D | pixfmt-srggb10-ipu3.rst | 21 to 32 bytes leaving 6 most significant bits padding in the last byte.
|
/Linux-v5.15/drivers/block/paride/ |
D | Transition-notes | 100 in the area, under pi_spinlock and we do not release it until after leaving
|
/Linux-v5.15/Documentation/scheduler/ |
D | sched-rt-group.rst | 62 have to play some music and respond to input, leaving it with around 80% CPU
|
D | sched-energy.rst | 138 save energy compared to leaving it on prev_cpu, i.e. the CPU where the task ran 188 compared to leaving P on CPU0. EAS assumes that OPPs follow utilization
|
/Linux-v5.15/Documentation/gpu/ |
D | drm-internals.rst | 135 other BARs, so leaving it mapped could cause undesired behaviour like
|
/Linux-v5.15/Documentation/m68k/ |
D | buddha-driver.rst | 15 example leaving some address lines out of the equations...).
|
/Linux-v5.15/Documentation/driver-api/acpi/ |
D | linuxized-acpica.rst | 220 break the Linux kernel, leaving us build/boot failures. In order to
|
/Linux-v5.15/security/ |
D | Kconfig.hardening | 152 returning from system calls. This has the effect of leaving
|
1234