Searched refs:ground (Results 1 – 25 of 28) sorted by relevance
12
| /Linux-v5.15/Documentation/hwmon/ |
| D | ntc_thermistor.rst | 56 -+- (ground)
68 -+- (ground)
80 -+----+- (ground)
92 -+- (ground)
|
| D | smsc47m192.rst | 108 to ground or Vcc. '1' indicates a diode fault.
|
| D | adm1026.rst | 96 voltage from the power lead rather than on the ground lead.
|
| /Linux-v5.15/drivers/extcon/ |
| D | extcon-intel-mrfld.c | 98 bool ground; in mrfld_extcon_get_id() local
122 ground = id & BCOVE_USBIDSTS_GND; in mrfld_extcon_get_id()
125 return ground ? INTEL_USB_ID_GND : INTEL_USB_ID_FLOAT; in mrfld_extcon_get_id()
127 return ground ? INTEL_USB_ID_FLOAT : INTEL_USB_ID_GND; in mrfld_extcon_get_id()
|
| /Linux-v5.15/Documentation/devicetree/bindings/mfd/ |
| D | samsung,sec-core.txt | 35 - samsung,s2mps11-wrstbi-ground: Indicates that WRSTBI pin of PMIC is pulled
38 - samsung,s2mps11-acokb-ground: Indicates that ACOKB pin of S2MPS11 PMIC is
39 connected to the ground so the PMIC must manually set PWRHOLD bit in CTRL1
|
| /Linux-v5.15/drivers/iio/position/ |
| D | Kconfig | 28 and keyboard angle respect to horizon (ground).
|
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | rk3288-veyron-sdmmc.dtsi | 34 * Builtin CD line is hooked to ground to prevent JTAG at boot
|
| D | kirkwood-openblocks_a7.dts | 84 * ground.
|
| D | at91-sama5d2_icp.dts | 370 * connect it to ground to get an edge e.g.
|
| D | at91-sama5d2_xplained.dts | 457 * connect it to ground to get an edge e.g.
|
| D | exynos5422-odroid-core.dtsi | 509 samsung,s2mps11-acokb-ground;
|
| /Linux-v5.15/Documentation/devicetree/bindings/iio/ |
| D | mount-matrix.txt | 96 ground plane and positive towards magnetic North, (x) is in the ground plane,
98 perpendicular to the ground plane and positive upwards.
|
| /Linux-v5.15/drivers/auxdisplay/ |
| D | Kconfig | 368 0 : no connection (eg: connected to ground)
383 0 : no connection (eg: connected to ground)
398 0 : no connection (eg: connected to ground)
413 0 : no connection (eg: connected to ground)
428 0 : no connection (eg: connected to ground)
443 0 : no connection (eg: connected to ground)
|
| /Linux-v5.15/arch/arm64/boot/dts/qcom/ |
| D | sc7180-trogdor-lazor.dtsi | 16 semtech,cs0-ground;
|
| /Linux-v5.15/Documentation/w1/ |
| D | w1-generic.rst | 6 signal wire (plus ground, so two wires).
8 Devices communicate on the bus by pulling the signal to ground via an open
|
| /Linux-v5.15/Documentation/ABI/testing/ |
| D | sysfs-bus-iio | 624 1kohm_to_gnd: connected to ground via an 1kOhm resistor,
625 2.5kohm_to_gnd: connected to ground via a 2.5kOhm resistor,
626 6kohm_to_gnd: connected to ground via a 6kOhm resistor,
627 20kohm_to_gnd: connected to ground via a 20kOhm resistor,
628 90kohm_to_gnd: connected to ground via a 90kOhm resistor,
629 100kohm_to_gnd: connected to ground via an 100kOhm resistor,
630 125kohm_to_gnd: connected to ground via an 125kOhm resistor,
631 500kohm_to_gnd: connected to ground via a 500kOhm resistor,
632 640kohm_to_gnd: connected to ground via a 640kOhm resistor,
1801 * Y is in the ground plane and positive towards magnetic North ;
[all …]
|
| /Linux-v5.15/Documentation/misc-devices/ |
| D | lis3lv02d.rst | 95 fall to the ground is out of question...
|
| /Linux-v5.15/Documentation/sound/designs/ |
| D | channel-mapping-api.rst | 41 As a ground design, each PCM substream may contain a control element
|
| /Linux-v5.15/arch/arm64/boot/dts/rockchip/ |
| D | rk3399-gru.dtsi | 517 * hooked to ground. Because we specified "cd-gpios" below dw_mmc
761 * In our case the official card detect is hooked to ground
|
| /Linux-v5.15/Documentation/driver-api/ |
| D | edac.rst | 13 creating a common ground for discussion, terms and their definitions
|
| /Linux-v5.15/Documentation/devicetree/bindings/regulator/ |
| D | qcom,spmi-regulator.txt | 232 to as NPM. HPM consumes more ground current than LPM, but
|
| /Linux-v5.15/Documentation/input/devices/ |
| D | joystick-parport.rst | 87 Ground is quite easy. On PC's parallel port the ground is on any of the
88 pins from pin 18 to pin 25. So use any pin of these you like for the ground::
|
| /Linux-v5.15/arch/arm64/boot/dts/exynos/ |
| D | exynos5433-tm2-common.dtsi | 393 samsung,s2mps11-wrstbi-ground;
|
| /Linux-v5.15/Documentation/process/ |
| D | applying-patches.rst | 396 The -mm patches serve as a sort of proving ground for new features and other
|
| D | howto.rst | 528 as a dumping ground for your feature. However, don't send 50 emails at
|
12
