| /Linux-v5.15/drivers/clk/qcom/ |
| D | clk-branch.c | 28 static bool clk_branch_check_halt(const struct clk_branch *br, bool enabling) in clk_branch_check_halt() argument
39 return !!val == !enabling; in clk_branch_check_halt()
47 static bool clk_branch2_check_halt(const struct clk_branch *br, bool enabling) in clk_branch2_check_halt() argument
57 if (enabling) { in clk_branch2_check_halt()
66 static int clk_branch_wait(const struct clk_branch *br, bool enabling, in clk_branch_wait() argument
79 if (br->halt_check == BRANCH_HALT_DELAY || (!enabling && voted)) { in clk_branch_wait()
83 (enabling && voted)) { in clk_branch_wait()
87 if (check_halt(br, enabling)) in clk_branch_wait()
92 enabling ? "ff" : "n"); in clk_branch_wait()
|
| /Linux-v5.15/Documentation/PCI/ |
| D | pci-iov-howto.rst | 39 enabling and disabling of the capability via API provided by SR-IOV core.
49 checks, e.g., check numvfs == 0 if enabling VFs, ensure
91 command below before enabling SR-IOV capabilities. This is the
99 command below before enabling SR-IOV capabilities. Updating this
|
| /Linux-v5.15/Documentation/virt/kvm/ |
| D | cpuid.rst | 66 before enabling paravirtualized
70 before enabling paravirtualized
78 before enabling paravirtualized
|
| /Linux-v5.15/Documentation/driver-api/thermal/ |
| D | exynos_thermal_emulation.rst | 32 enabling. It means when you want to update the any value of delay or
34 time. (Or you have to keep the mode enabling.) If you don't, it fails to
|
| /Linux-v5.15/Documentation/ABI/obsolete/ |
| D | sysfs-firmware-acpi | 8 enabling this knob is not safe and thus unsupported.
|
| /Linux-v5.15/Documentation/devicetree/bindings/clock/ |
| D | gpio-gate-clock.txt | 10 - enable-gpios : GPIO reference for enabling and disabling the clock.
|
| /Linux-v5.15/Documentation/devicetree/bindings/ata/ |
| D | ahci-da850.txt | 9 for enabling/disabling the SATA clock receiver
|
| /Linux-v5.15/drivers/soc/bcm/bcm63xx/ |
| D | Kconfig | 21 is used for disabling and enabling SoC devices.
|
| /Linux-v5.15/Documentation/devicetree/bindings/sound/ |
| D | dmic.txt | 11 - wakeup-delay-ms: Delay (in ms) after enabling the DMIC
|
| /Linux-v5.15/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-adc-stm32 | 15 Writing value before enabling conversions sets trigger polarity.
|
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | facebook-bmc-flash-layout.dtsi | 34 * Although the master partition can be created by enabling
|
| D | facebook-bmc-flash-layout-128.dtsi | 52 * Although the master partition can be created by enabling
|
| /Linux-v5.15/Documentation/devicetree/bindings/net/nfc/ |
| D | pn544.txt | 8 - enable-gpios: Output GPIO pin used for enabling/disabling the PN544
|
| D | nxp-nci.txt | 8 - enable-gpios: Output GPIO pin used for enabling/disabling the chip
|
| D | st21nfca.txt | 7 - enable-gpios: Output GPIO pin used for enabling/disabling the ST21NFCA
|
| /Linux-v5.15/Documentation/admin-guide/media/ |
| D | davinci-vpbe.rst | 33 patch series, the interconnection and enabling and setting of the external
58 features. The VPBE module interacts with the OSD for enabling and
|
| /Linux-v5.15/Documentation/devicetree/bindings/arm/cpu-enable-method/ |
| D | marvell,berlin-smp | 5 This document describes the "marvell,berlin-smp" method for enabling secondary
|
| /Linux-v5.15/Documentation/hwmon/ |
| D | tps23861.rst | 26 as well as enabling/disabling the four ports.
|
| /Linux-v5.15/Documentation/devicetree/bindings/mtd/ |
| D | nand-macronix.txt | 12 with hardware ECC and not enabled at UBI level, then enabling the
|
| /Linux-v5.15/Documentation/devicetree/bindings/powerpc/opal/ |
| D | sensor-groups.txt | 26 sensor groups like clearing min/max, enabling/disabling sensor
|
| /Linux-v5.15/drivers/acpi/nfit/ |
| D | Kconfig | 26 on NVDIMM security enabling say Y, otherwise say N.
|
| /Linux-v5.15/drivers/video/fbdev/omap2/omapfb/dss/ |
| D | apply.c | 70 bool enabling; member
219 if (!op->enabled && !op->enabling) in dss_check_settings_low()
1027 if (!op->enabled && !op->enabling) in dss_ovl_setup_fifo()
1479 op->enabling = true; in dss_ovl_enable()
1490 op->enabling = false; in dss_ovl_enable()
1502 op->enabling = false; in dss_ovl_enable()
|
| /Linux-v5.15/drivers/staging/unisys/Documentation/ABI/ |
| D | sysfs-platform-visorchipset | 59 responsible for enabling and disabling SR-IOV devices when the
78 responsible for enabling and disabling SR-IOV devices when the
|
| /Linux-v5.15/Documentation/gpu/rfc/ |
| D | i915_gem_lmem.rst | 10 * Merge basic HW enabling of DG1(still without pciid)
|
| /Linux-v5.15/Documentation/devicetree/bindings/gpio/ |
| D | intel,ixp4xx-gpio.txt | 8 actual enabling/disabling of the interrupt line is done in the
|
