| /Linux-v5.15/drivers/edac/ |
| D | Kconfig | 81 Support for error detection and correction of DRAM ECC errors on
88 Error Injection into the ECC detection circuits. The amd64_edac
106 Support for error detection and correction for Amazon's Annapurna
107 Labs Alpine chips which allow 1 bit correction and 2 bits detection.
113 Support for error detection and correction on the AMD 76x
120 Support for error detection and correction on the Intel
127 Support for error detection and correction on the Intel
135 Support for error detection and correction on the Intel
142 Support for error detection and correction on the Intel
149 Support for error detection and correction on the Intel
[all …]
|
| /Linux-v5.15/Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-detect.rst | 10 or object detection capable devices.
24 Sets the motion detection mode.
33 - Disable motion detection.
35 - Use a single motion detection threshold.
38 detection threshold. These thresholds are set through the
42 value that specifies which per-region motion detection thresholds
51 Sets the global motion detection threshold to be used with the
52 ``V4L2_DETECT_MD_MODE_GLOBAL`` motion detection mode.
55 Sets the motion detection thresholds for each cell in the grid. To
57 detection mode. Matrix element (0, 0) represents the cell at the
[all …]
|
| /Linux-v5.15/Documentation/devicetree/bindings/extcon/ |
| D | extcon-palmas.txt | 13 - ti,enable-id-detection: Perform ID detection. If id-gpio is specified
14 it performs id-detection using GPIO else using OTG core.
15 - ti,enable-vbus-detection: Perform VBUS detection.
16 - id-gpio: gpio for GPIO ID detection. See gpio binding.
|
| /Linux-v5.15/Documentation/sound/soc/ |
| D | jack.rst | 2 ASoC jack detection
9 - It allows more than one jack detection method to work together on one
34 machine driver and updated by jack detection methods.
49 Jack detection methods
52 Actual jack detection is done by code which is able to monitor some
54 specifying a subset of bits to update. The jack detection code should
61 CODEC integrated jack detection can be see in the WM8350 driver.
71 the list of pins to update then set up one or more jack detection
|
| /Linux-v5.15/drivers/extcon/ |
| D | Kconfig | 29 Say Y here to enable support for USB peripheral detection
65 Say Y here to enable extcon support for charger detection / control
72 Say Y here to enable extcon support for charger detection / control
89 If you say yes here you get support for the USB OTG role detection by
127 detection by palmas usb.
135 detection by NXP PTN5150 CC (Configuration Channel) logic chip.
141 Say Y here to enable SPMI PMIC based USB cable detection
171 Say Y here to enable GPIO based USB cable detection extcon support.
172 Used typically if GPIO is used for USB ID pin detection.
178 Say Y here to enable USB Type C cable detection extcon support when
[all …]
|
| /Linux-v5.15/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-light-isl29018 | 10 detection. The range of Scheme 0 proximity count is from 0 to
12 bits (2's complementary) proximity_less_ambient detection. The
15 Scheme 0 has wider dynamic range, Scheme 1 proximity detection
|
| /Linux-v5.15/Documentation/devicetree/bindings/sound/ |
| D | nokia,rx51.txt | 10 - jack-detection-gpios: GPIO for jack detection
24 jack-detection-gpios = <&gpio6 17 GPIO_ACTIVE_HIGH>; /* 177 */
|
| D | rt5677.txt | 38 Configures GPIO Mic Jack detection 1.
43 Configures GPIO Mic Jack detection 2 and 3.
77 realtek,jd2-gpio = <3>; /* Enables Jack detection for GPIO6 */
|
| D | rt5645.txt | 41 1 : Mode-0 (VDD=3.3V), two port jack detection
42 2 : Mode-1 (VDD=3.3V), one port jack detection
43 3 : Mode-2 (VDD=1.8V), one port jack detection
|
| D | rt5651.txt | 31 u32, micbias over-current detection threshold in µA, valid values are
35 u32, micbias over-current detection scale-factor, valid values are:
|
| D | omap-abe-twl6040.txt | 15 - ti,jack-detection: Need to be present if the board capable to detect jack
62 ti,jack-detection;
|
| D | rt5640.txt | 50 u32, micbias over-current detection threshold in µA, valid values are
54 u32, micbias over-current detection scale-factor, valid values are:
|
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | imx7d-flex-concentrator.dts | 151 * Ethernet PHY type ID auto-detection. Otherwise this communication
185 "", "module-b-detection", "", "module-a-detection", "", "", "", "";
256 /* Module A detection (low = present) */
258 /* Module B detection (low = present) */
|
| /Linux-v5.15/drivers/net/wireless/ti/wl1251/ |
| D | acx.c | 621 struct acx_energy_detection *detection; in wl1251_acx_cca_threshold() local
626 detection = kzalloc(sizeof(*detection), GFP_KERNEL); in wl1251_acx_cca_threshold()
627 if (!detection) in wl1251_acx_cca_threshold()
630 detection->rx_cca_threshold = CCA_THRSH_DISABLE_ENERGY_D; in wl1251_acx_cca_threshold()
631 detection->tx_energy_detection = 0; in wl1251_acx_cca_threshold()
634 detection, sizeof(*detection)); in wl1251_acx_cca_threshold()
638 kfree(detection); in wl1251_acx_cca_threshold()
|
| /Linux-v5.15/Documentation/devicetree/bindings/input/touchscreen/ |
| D | colibri-vf50-ts.txt | 10 - interrupts: pen irq interrupt for touch detection
12 - pinctrl-0: pinctrl node for pen/touch detection state pinmux
|
| /Linux-v5.15/Documentation/arm/pxa/ |
| D | mfp.rst | 18 detection of each pin. Below is a diagram of internal connections between
61 - GPIO level change detection
66 4. Wakeup detection is now controlled by MFP, PWER does not control the
145 d) although PXA3xx MFP supports edge detection on each pin, the
166 Bit 4: EDGE_RISE_EN - enable detection of rising edge on this pin
167 Bit 5: EDGE_FALL_EN - enable detection of falling edge on this pin
168 Bit 6: EDGE_CLEAR - disable edge detection on this pin
253 * edge detection = none
|
| /Linux-v5.15/drivers/usb/common/ |
| D | Kconfig | 33 protocol) and USB charger detection.
45 based USB cable detection, used typically if an input GPIO is used
|
| /Linux-v5.15/Documentation/devicetree/bindings/arm/ |
| D | versatile-sysreg.txt | 5 platform functions like board detection and identification, software
|
| /Linux-v5.15/Documentation/x86/ |
| D | buslock.rst | 6 Bus lock detection and handling
31 #AC exception for split lock detection
37 #DB exception for bus lock detection
|
| /Linux-v5.15/Documentation/admin-guide/ |
| D | lockup-watchdogs.rst | 11 stack trace is displayed upon detection and, by default, the system
22 upon detection and the system will stay locked up unless the default
65 between fast response to lockups and detection overhead.
|
| /Linux-v5.15/Documentation/hwmon/ |
| D | abituguru3.rst | 40 Force detection. Note this parameter only causes the
41 detection to be skipped, and thus the insmod to
|
| /Linux-v5.15/Documentation/devicetree/bindings/mmc/ |
| D | pxa-mmc.txt | 10 - marvell,detect-delay-ms: sets the detection delay timeout in ms.
|
| /Linux-v5.15/Documentation/dev-tools/ |
| D | kcsan.rst | 85 It may be desirable to disable data race detection for specific accesses,
94 * Disabling data race detection for entire functions can be accomplished by
104 * To disable data race detection for a particular compilation unit, add to the
109 * To disable data race detection for all compilation units listed in a
165 Core parameters that affect KCSAN's overall performance and bug detection
173 overall system performance and race detection ability.
303 An alternative data race detection approach for the kernel can be found in the
|
| /Linux-v5.15/Documentation/sound/hd-audio/ |
| D | controls.rst | 88 detection is enabled or not. When enabled, the widgets power state
91 doesn't provide a proper jack-detection, this won't work; in such a
97 the jack detection so that the headphone auto-mute can work, while
|
| /Linux-v5.15/Documentation/w1/masters/ |
| D | ds2482.rst | 34 detection is done. You should instantiate the device explicitly.
|
