| /Linux-v5.15/drivers/ata/ |
| D | pata_ns87415.c | 59 u16 clocking; in ns87415_set_mode() local
68 clocking = 17 - clamp_val(t.active, 2, 17); in ns87415_set_mode()
69 clocking |= (16 - clamp_val(t.recover, 1, 16)) << 4; in ns87415_set_mode()
71 clocking |= (clocking << 8); in ns87415_set_mode()
72 pci_write_config_word(dev, timing, clocking); in ns87415_set_mode()
|
| /Linux-v5.15/Documentation/devicetree/bindings/clock/ti/ |
| D | dpll.txt | 45 "ssc-deltam" - DPLL supports spread spectrum clocking (SSC), contains
47 "ssc-modfreq" - DPLL supports spread spectrum clocking (SSC), contains
61 - ti,ssc-deltam : DPLL supports spread spectrum clocking, frequency
63 - ti,ssc-modfreq-hz : DPLL supports spread spectrum clocking, spread
65 - ti,ssc-downspread : DPLL supports spread spectrum clocking, boolean
|
| /Linux-v5.15/drivers/staging/clocking-wizard/ |
| D | dt-binding.txt | 11 - compatible: Must be 'xlnx,clocking-wizard'
23 compatible = "xlnx,clocking-wizard";
|
| /Linux-v5.15/sound/soc/codecs/ |
| D | wm8737.c | 331 u16 clocking = 0; in wm8737_hw_params() local
342 clocking |= WM8737_CLKDIV2; in wm8737_hw_params()
353 clocking |= coeff_div[i].usb | (coeff_div[i].sr << WM8737_SR_SHIFT); in wm8737_hw_params()
374 clocking); in wm8737_hw_params()
|
| D | wm8955.c | 246 int clocking = 0; in wm8955_configure_clocking() local
278 clocking |= WM8955_MCLKSEL; in wm8955_configure_clocking()
325 WM8955_MCLKSEL, clocking); in wm8955_configure_clocking()
|
| /Linux-v5.15/Documentation/sound/soc/ |
| D | clocking.rst | 5 This text describes the audio clocking terms in ASoC and digital audio in
6 general. Note: Audio clocking can be complex!
|
| D | index.rst | 17 clocking
|
| /Linux-v5.15/arch/powerpc/boot/dts/ |
| D | pdm360ng.dts | 94 fsl,preserve-clocking;
112 fsl,preserve-clocking;
|
| D | socrates.dts | 94 fsl,preserve-clocking;
126 fsl,preserve-clocking;
|
| D | uc101.dts | 86 fsl,preserve-clocking;
|
| /Linux-v5.15/Documentation/devicetree/bindings/serial/ |
| D | arm,mps2-uart.txt | 8 Required clocking property:
|
| /Linux-v5.15/Documentation/devicetree/bindings/timer/ |
| D | arm,armv7m-systick.txt | 10 Required clocking property, have to be one of:
|
| D | arm,mps2-timer.txt | 10 Required clocking property, have to be one of:
|
| /Linux-v5.15/Documentation/devicetree/bindings/misc/ |
| D | lwn-bk4.txt | 17 - spi-max-frequency : Maximum SPI clocking speed of device in Hz, should be
|
| /Linux-v5.15/drivers/clk/versatile/ |
| D | Kconfig | 10 Supports clocking on ARM Reference designs:
|
| /Linux-v5.15/drivers/staging/ |
| D | Makefile | 29 obj-$(CONFIG_COMMON_CLK_XLNX_CLKWZRD) += clocking-wizard/
|
| /Linux-v5.15/Documentation/devicetree/bindings/watchdog/ |
| D | nuvoton,npcm-wdt.txt | 14 Required clocking property, have to be one of:
|
| /Linux-v5.15/drivers/net/wan/ |
| D | wanxl.h | 145 u32 clocking; member
|
| D | fsl_ucc_hdlc.h | 106 u32 clocking; member
|
| /Linux-v5.15/Documentation/devicetree/bindings/net/wireless/ |
| D | ti,wlcore,spi.txt | 19 - spi-max-frequency : Maximum SPI clocking speed of device in Hz
|
| D | ti,wl1251.txt | 9 - spi-max-frequency : Maximum SPI clocking speed of device in Hz
|
| /Linux-v5.15/arch/powerpc/platforms/52xx/ |
| D | Kconfig | 18 - CDM configuration (clocking) is setup correctly by firmware,
|
| /Linux-v5.15/Documentation/devicetree/bindings/clock/ |
| D | ti,cdce925.txt | 31 spectrum clocking parameters for a board.
|
| /Linux-v5.15/drivers/clk/baikal-t1/ |
| D | Kconfig | 8 responsible for the chip subsystems clocking and resetting. It
|
| /Linux-v5.15/Documentation/driver-api/ |
| D | slimbus.rst | 36 Framer device is responsible for clocking the bus, and transmitting frame-sync
49 responsible to select the active-framer for clocking the bus.
|
