Home
last modified time | relevance | path

Searched refs:SDRAM (Results 1 – 25 of 53) sorted by relevance

123

/Linux-v5.15/arch/arm/mach-s3c/
Dsleep-s3c2410.S38 orr r7, r7, #S3C2410_REFRESH_SELF @ SDRAM sleep command
39 orr r8, r8, #S3C2410_MISCCR_SDSLEEP @ SDRAM power-down signals
50 streq r7, [r4] @ SDRAM sleep command
51 streq r8, [r5] @ SDRAM power-down config
/Linux-v5.15/arch/arm/mach-pxa/
Dsleep.S54 @ prepare SDRAM refresh settings
58 @ enable SDRAM self-refresh mode
95 @ prepare SDRAM refresh settings
99 @ enable SDRAM self-refresh mode
106 @ We keep the change-down close to the actual suspend on SDRAM
159 @ external accesses after SDRAM is put in self-refresh mode
165 @ put SDRAM into self-refresh
/Linux-v5.15/Documentation/devicetree/bindings/arm/altera/
Dsocfpga-sdram-edac.txt1 Altera SOCFPGA SDRAM Error Detection & Correction [EDAC]
2 The EDAC accesses a range of registers in the SDRAM controller.
7 - interrupts : Should contain the SDRAM ECC IRQ in the
Dsocfpga-sdram-controller.txt1 Altera SOCFPGA SDRAM Controller
5 syscon is required by the Altera SOCFPGA SDRAM EDAC.
/Linux-v5.15/Documentation/driver-api/memory-devices/
Dti-emif.rst4 TI EMIF SDRAM Controller Driver
29 SoCs. EMIF is an SDRAM controller that, based on its revision,
30 supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols.
/Linux-v5.15/Documentation/devicetree/bindings/arm/omap/
Ddmm.txt4 SDRAM controllers (called EMIFs on OMAP). DMM manages various aspects of memory
5 accesses such as priority generation amongst initiators, configuration of SDRAM
/Linux-v5.15/drivers/memory/
DKconfig20 Data from JEDEC specs for DDR SDRAM memories,
23 DDR SDRAM controllers.
34 bool "Atmel (Multi-port DDR-)SDRAM Controller"
39 This driver is for Atmel SDRAM Controller or Atmel Multi-port
40 DDR-SDRAM Controller available on Atmel AT91SAM9 and SAMA5 SoCs.
98 SoCs. EMIF is an SDRAM controller that, based on its revision,
99 supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols.
/Linux-v5.15/Documentation/devicetree/bindings/memory-controllers/ti/
Demif.txt1 * EMIF family of TI SDRAM controllers
3 EMIF - External Memory Interface - is an SDRAM controller used in
57 has capability for generating SDRAM temperature alerts
/Linux-v5.15/arch/arm/boot/dts/
Dr7s9210-rza2mevb.dts8 * Hence the 64 MiB of SDRAM on the sub-board needs to be enabled, which has
22 * SW6 SW6-1 set to SDRAM
84 reg = <0x0c000000 0x04000000>; /* SDRAM */
Dintel-ixp42x-welltech-epbx100.dts17 /* 64 MB SDRAM */
Dvexpress-v2p-ca9.dts243 /* DDR2 SDRAM and Test Chip DDR2 I/O supply */
252 /* DDR2 SDRAM VTT termination voltage */
Dintel-ixp42x-netgear-wg302v2.dts19 /* 16 MB SDRAM according to OpenWrt database */
Dintel-ixp42x-adi-coyote.dts20 /* CHECKME: 16 MB SDRAM minimum, maybe the Coyote actually has more */
/Linux-v5.15/drivers/video/fbdev/omap/
DKconfig53 bool "Set DMA SDRAM access priority high"
57 (SDRAM) this will speed up graphics DMA operations.
/Linux-v5.15/arch/arm/mach-omap2/
DKconfig149 bool "OMAP2 SDRAM Controller support"
212 access SDRAM during CORE DVFS, select Y here. This should boost
213 SDRAM performance at lower CORE OPPs. There are relatively few
/Linux-v5.15/Documentation/devicetree/bindings/fpga/
Daltera-fpga2sdram-bridge.txt1 Altera FPGA To SDRAM Bridge Driver
/Linux-v5.15/arch/arm/mach-omap1/
Dsleep.S81 @ prepare to put SDRAM into self-refresh manually
166 @ prepare to put SDRAM into self-refresh manually
236 @ Prepare to put SDRAM into self-refresh manually
/Linux-v5.15/arch/arm/mach-lpc32xx/
Dsuspend.S52 @ Wait for SDRAM busy status to go busy and then idle
/Linux-v5.15/Documentation/arm/stm32/
Dstm32f429-overview.rst13 - External memory support through FMC controller (PSRAM, SDRAM, NOR, NAND)
Dstm32h750-overview.rst13 - FMC controller to connect SDRAM, NOR and NAND memories
Dstm32h743-overview.rst13 - FMC controller to connect SDRAM, NOR and NAND memories
Dstm32f746-overview.rst13 - FMC controller to connect SDRAM, NOR and NAND memories
Dstm32f769-overview.rst13 - FMC controller to connect SDRAM, NOR and NAND memories
/Linux-v5.15/Documentation/devicetree/bindings/clock/
Dmvebu-core-clock.txt30 3 = hclk (SDRAM Controller Internal Clock)
31 4 = dclk (SDRAM Interface Clock)
/Linux-v5.15/drivers/video/fbdev/aty/
Dmach64_ct.c356 else if (par->ram_type >= SDRAM) in aty_set_pll_ct()
471 case SDRAM: in aty_init_pll_ct()
559 if (M64_HAS(SDRAM_MAGIC_PLL) && (par->ram_type >= SDRAM)) in aty_init_pll_ct()

123