Searched refs:Ready (Results 1 – 14 of 14) sorted by relevance
7 Ready Flag to being set prior to committing a new value to the sample11 Writing '1' will remove the polling for the Conversion Ready Flags to
11 - nxp,wdr-clks: Delay before Ready signal is tested on write (W_RDY)12 - nxp,rdr-clks: Delay before Ready signal is tested on read (R_RDY)
12 - gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins
42 - rb-gpios: the GPIO(s) used to check the Ready/Busy status of the NAND.45 - atmel,rb: an integer identifying the native Ready/Busy pin. Only meaningful
242 u8 Ready:1; member253 u8 Ready:1; member264 u8 Ready:1; member605 if (info->SD_Status.Insert && info->SD_Status.Ready) in sd_scsi_test_unit_ready()1459 if (info->MS_Status.Insert && info->MS_Status.Ready) { in ms_scsi_test_unit_ready()2105 if (info->MS_Status.Insert && info->MS_Status.Ready) { in ene_ms_init()2107 printk(KERN_INFO "Ready = %x\n", info->MS_Status.Ready); in ene_ms_init()2173 if (info->SD_Status.Insert && info->SD_Status.Ready) { in ene_sd_init()2178 usb_stor_dbg(us, "Ready = %x\n", s->Ready); in ene_sd_init()2204 if (!info->SD_Status.Ready) { in ene_init()[all …]
39 - Add support for fbdev drivers.- Ready and part of subsequent patches.
454 printf ("Ready.\n");460 printf ("Drive Not Ready.\n");
112 Ready-made header files for various distros are in the UDP-Lite tarball.
159 - Allow Test Unit Ready commands to take a full 5 seconds
559 vii. Added print : FW now in Ready State during initialization
917 "Re: [Emulex] Ready for next round. This patch cleans up the memory
310 field SPIORDY 0x02 /* SCSI PIO Ready */
1924 field SPIORDY 0x02 /* SCSI PIO Ready */
1266 USR3401 "U S Robotics V.34-Ready Fax Modem"
