/Linux-v5.15/Documentation/devicetree/bindings/sound/ |
D | ti,pcm3168a.txt | 30 - reset-gpios : Optional reset gpio line connected to RST pin of the codec. 31 The RST line is low active: 32 RST = low: device power-down 33 RST = high: device is enabled
|
/Linux-v5.15/drivers/media/platform/mtk-jpeg/ |
D | mtk_jpeg_dec_parse.c | 15 #define RST 0xd0 macro 126 case RST ... RST + 7: in mtk_jpeg_do_parse()
|
/Linux-v5.15/arch/arm/mach-shmobile/ |
D | pm-rcar-gen2.c | 21 #define RST 0xe6160000 macro 106 p = ioremap(RST, 0x63); in rcar_gen2_pm_init()
|
/Linux-v5.15/arch/mips/rb532/ |
D | setup.c | 32 writel(0x80000001, IDT434_REG_BASE + RST); in rb_machine_restart()
|
/Linux-v5.15/arch/mips/include/asm/mach-rc32434/ |
D | rb.h | 13 #define RST (1 << 15) macro
|
/Linux-v5.15/Documentation/devicetree/bindings/input/touchscreen/ |
D | auo_pixcir_ts.txt | 23 <&gpf 5 1 0>; /* RST */
|
D | zforce_ts.txt | 26 reset-gpios = <&gpio5 9 0>; /* RST */
|
/Linux-v5.15/arch/arm/boot/dts/ |
D | omap3-sbc-t3730.dts | 25 OMAP3_CORE1_IOPAD(0x2130, PIN_OUTPUT | MUX_MODE4) /* ccdc_wen.gpio_167 - SB-T35 USB HUB RST */
|
D | omap3-sbc-t3530.dts | 25 OMAP3_CORE1_IOPAD(0x2130, PIN_OUTPUT | MUX_MODE4) /* ccdc_wen.gpio_167 - SB-T35 USB HUB RST */
|
D | omap3-sbc-t3517.dts | 48 OMAP3_CORE1_IOPAD(0x21ec, PIN_OUTPUT | MUX_MODE4) /* ccdc_wen.gpio_98 - SB-T35 USB HUB RST */
|
D | ste-hrefv60plus.dtsi | 351 * Display Interface 1 uses GPIO 65 for RST (reset). 352 * Display Interface 2 uses GPIO 66 for RST (reset).
|
D | imx6ul-imx6ull-opos6ul.dtsi | 102 /* RST# */
|
D | omap3-cm-t3517.dts | 94 OMAP3_CORE1_IOPAD(0x2184, PIN_OUTPUT | MUX_MODE4) /* mcbsp4_clkx.gpio_152 - USB HUB RST */
|
D | sun8i-s3-pinecube.dts | 56 reset-gpios = <&pio 1 3 GPIO_ACTIVE_LOW>; /* PB3 WIFI-RST */
|
D | imx53-voipac-dmm-668.dtsi | 55 /* FEC RST */
|
/Linux-v5.15/tools/perf/trace/beauty/ |
D | msg_flags.c | 48 P_MSG_FLAG(RST); in syscall_arg__scnprintf_msg_flags()
|
/Linux-v5.15/drivers/pinctrl/ |
D | pinctrl-falcon.c | 107 MFP_FALCON(GPIO0, RST, GPIO, NONE, NONE), 113 MFP_FALCON(GPIO6, RST, GPIO, NONE, NONE), 182 GRP_MUX("por", RST, pins_por), 186 GRP_MUX("hrst", RST, pins_hrst),
|
/Linux-v5.15/tools/testing/selftests/net/mptcp/ |
D | mptcp_sockopt.sh | 25 ip netns exec $ns $t -A OUTPUT -p tcp --tcp-flags RST RST -m mark --mark 0 -j ACCEPT
|
/Linux-v5.15/arch/arm64/boot/dts/allwinner/ |
D | sun50i-a64-oceanic-5205-5inmfd.dts | 48 reset-gpios = <&pio 7 11 GPIO_ACTIVE_HIGH>; /* CTP-RST: PH11 */
|
D | sun50i-a64-amarula-relic.dts | 43 reset-gpios = <&pio 4 14 GPIO_ACTIVE_LOW>; /* CSI-RST-R: PE14 */ 125 reset-gpios = <&pio 7 8 GPIO_ACTIVE_HIGH>; /* CTP-RST: PH8 */
|
/Linux-v5.15/Documentation/translations/zh_CN/doc-guide/ |
D | parse-headers.rst | 67 文本 块将文件转换成重构文本(RST)。它接受一个可选的<例外文件>,其中描述了
|
/Linux-v5.15/Documentation/networking/ |
D | nf_conntrack-sysctl.rst | 114 If it's non-zero, we mark only out of window RST segments as INVALID. 120 If it's 1, we don't mark out of window RST segments as INVALID.
|
D | snmp_counter.rst | 276 and RST packets. Doesn't like TcpInSegs, the TcpOutSegs is aware of 384 the 'segments sent containing the RST flag', but in linux kernel, this 400 The socket receives a RST packet in Establish or CloseWait state. 467 connection. So TCP layer sends a RST to the other side, indicate the 480 when the application closes a connection, kernel will send a RST 487 kernel will send a RST to the other side of the TCP connection. 498 enough memory to keep the orphan socket, kernel would send an RST to 514 situation, kernel won't send RST, just give up the connection. 519 for the fin packet from the other side, kernel could send a RST and 526 The kernel TCP layer will send RST if the `RFC2525 2.17 section`_ is [all …]
|
/Linux-v5.15/drivers/gpu/drm/mediatek/ |
D | mtk_dpi_regs.h | 13 #define RST BIT(0) macro
|
/Linux-v5.15/Documentation/hwmon/ |
D | smm665.rst | 108 and/or other activity. Triggered signals can include HEALTHY, RST, Power Off, 110 or crit if exceeding the limits triggers RST, Power Off, or Fault, and as min or
|