| /Linux-v5.15/drivers/rtc/ |
| D | rtc-imxdi.c | 55 #define DSR 0x14 /* Status Reg */ macro
275 di_write_busy_wait(imxdi, DSR_CAF, DSR); in di_handle_valid_state()
325 di_write_busy_wait(imxdi, DSR_NVF, DSR); in di_handle_invalid_state()
327 di_write_busy_wait(imxdi, DSR_TCO, DSR); in di_handle_invalid_state()
334 return di_handle_valid_state(imxdi, __raw_readl(imxdi->ioaddr + DSR)); in di_handle_invalid_state()
377 DSR_MCO | DSR_TCO), DSR); in di_handle_invalid_and_failure_state()
379 dsr = readl(imxdi->ioaddr + DSR); in di_handle_invalid_and_failure_state()
391 di_write_busy_wait(imxdi, DSR_SVF, DSR); in di_handle_invalid_and_failure_state()
394 dsr = readl(imxdi->ioaddr + DSR); in di_handle_invalid_and_failure_state()
415 dsr = readl(imxdi->ioaddr + DSR); in di_handle_state()
[all …]
|
| /Linux-v5.15/drivers/net/wan/ |
| D | hd64570.h | 130 #define DSR 0x10 /* DMA Status */ macro
131 #define DSR_RX(node) (DSR + (node ? DMAC1RX_OFFSET : DMAC0RX_OFFSET))
132 #define DSR_TX(node) (DSR + (node ? DMAC1TX_OFFSET : DMAC0TX_OFFSET))
|
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | am335x-netcom-plus-2xx.dts | 28 AM33XX_PADCONF(AM335X_PIN_LCD_HSYNC, PIN_INPUT_PULLDOWN, MUX_MODE7) /* DSR */
41 AM33XX_PADCONF(AM335X_PIN_GPMC_AD13, PIN_INPUT_PULLDOWN, MUX_MODE7) /* DSR */
|
| D | am335x-baltos-ir3220.dts | 34 …3XX_PADCONF(AM335X_PIN_LCD_HSYNC, PIN_INPUT_PULLDOWN, MUX_MODE7) /* lcd_hsync.gpio2[23] DSR */
47 …3XX_PADCONF(AM335X_PIN_GPMC_AD13, PIN_INPUT_PULLDOWN, MUX_MODE7) /* gpmc_ad13.gpio1[13] DSR */
|
| D | am335x-baltos-ir5221.dts | 42 …3XX_PADCONF(AM335X_PIN_LCD_HSYNC, PIN_INPUT_PULLDOWN, MUX_MODE7) /* lcd_hsync.gpio2[23] DSR */
55 …3XX_PADCONF(AM335X_PIN_GPMC_AD13, PIN_INPUT_PULLDOWN, MUX_MODE7) /* gpmc_ad13.gpio1[13] DSR */
|
| D | am335x-baltos-ir2110.dts | 28 …3XX_PADCONF(AM335X_PIN_LCD_HSYNC, PIN_INPUT_PULLDOWN, MUX_MODE7) /* lcd_hsync.gpio2[23] DSR */
|
| D | imx6dl-eckelmann-ci4x10.dts | 233 MX6QDL_PAD_EIM_D25__GPIO3_IO25 0x0001b010 /* DSR */
245 MX6QDL_PAD_NANDF_CS3__GPIO6_IO16 0x0001b010 /* DSR */
|
| D | gemini-dlink-dir-685.dts | 113 /* Collides with LPC_LAD[2], UART DSR, SSP ECLK pins */
|
| D | imx6qdl-colibri.dtsi | 641 /* Additional DTR, DSR, DCD */
|
| D | imx7-colibri.dtsi | 937 MX7D_PAD_LPSR_GPIO1_IO07__GPIO1_IO7 0x14 /* DSR */
|
| D | imx6qdl-apalis.dtsi | 844 /* Additional DTR, DSR, DCD */
|
| /Linux-v5.15/drivers/staging/octeon-usb/ |
| D | TODO | 2 D-Link DSR-1000N and EBH5600 evaluation board with USB mass storage.
|
| /Linux-v5.15/arch/mips/boot/dts/cavium-octeon/ |
| D | dlink_dsr-500n.dts | 3 * Device tree source for D-Link DSR-500N.
|
| D | dlink_dsr-1000n.dts | 3 * Device tree source for D-Link DSR-1000N.
|
| D | dlink_dsr-500n-1000n.dtsi | 3 * Device tree source for D-Link DSR-500N/1000N (common parts).
|
| /Linux-v5.15/Documentation/usb/ |
| D | iuu_phoenix.rst | 44 0=none, 1=CD, 2=!CD, 3=DSR, 4=!DSR, 5=CTS, 6=!CTS, 7=RING, 8=!RING (int)
|
| D | usb-serial.rst | 340 Queries of inputs (CTS,DSR,CD,RI) show the last
456 implemented. Support for finding out about DSR and CTS line status is
|
| /Linux-v5.15/Documentation/devicetree/bindings/soc/fsl/cpm_qe/ |
| D | serial.txt | 14 CTS, RTS, DCD, DSR, DTR, and RI.
|
| /Linux-v5.15/Documentation/devicetree/bindings/serial/ |
| D | cirrus,clps711x-uart.txt | 11 - {rts,cts,dtr,dsr,rng,dcd}-gpios: specify a GPIO for RTS/CTS/DTR/DSR/RI/DCD
|
| /Linux-v5.15/Documentation/arm/sa1100/ |
| D | assabet.rst | 253 Radio: TX, RX, CTS, DSR, DCD, RI
255 - COM: TX, RX, CTS, DSR, DCD, RTS, DTR, PM
294 - COM1,2: TX, RX, CTS, DSR, DCD, RTS, DTR
|
| /Linux-v5.15/Documentation/devicetree/bindings/mfd/ |
| D | atmel-usart.txt | 38 - {rts,cts,dtr,dsr,rng,dcd}-gpios: specify a GPIO for RTS/CTS/DTR/DSR/RI/DCD line respectively.
|
| /Linux-v5.15/drivers/tty/ |
| D | nozomi.c | 241 unsigned int DSR:1; member
296 unsigned int DSR:1; member
946 if (old_ctrl.DSR != ctrl_dl.DSR) in receive_flow_control()
1667 | (ctrl_dl->DSR ? TIOCM_DSR : 0) in ntty_tiocmget()
|
| /Linux-v5.15/drivers/dma/dw/ |
| D | regs.h | 52 DW_REG(DSR);
|
| /Linux-v5.15/Documentation/driver-api/serial/ |
| D | driver.rst | 111 - TIOCM_DSR state of DSR signal
115 the port does not support CTS, DCD or DSR, the driver should
|
| /Linux-v5.15/arch/arm64/boot/dts/freescale/ |
| D | imx8mm-venice-gw7902.dts | 839 MX8MM_IOMUXC_SAI1_RXD2_GPIO4_IO4 0x140 /* DSR */
|
