Searched refs:CREG (Results 1 – 6 of 6) sorted by relevance
| /Linux-v5.15/sound/drivers/ |
| D | mtpav.c | 99 #define CREG 2 macro
212 } else if (reg == CREG) { in snd_mtpav_getreg()
213 rval = inb(chip->port + CREG); in snd_mtpav_getreg()
225 if (reg == DREG || reg == CREG) in snd_mtpav_mputreg()
254 tcbyt = snd_mtpav_getreg(chip, CREG); in snd_mtpav_send_byte()
259 snd_mtpav_mputreg(chip, CREG, clrwrite); // clear write bit in snd_mtpav_send_byte()
261 snd_mtpav_mputreg(chip, CREG, setwrite); // set write bit in snd_mtpav_send_byte()
346 snd_mtpav_mputreg(mtp_card, CREG, (SIGC_INTEN | SIGC_WRITE)); // enable pport interrupts in snd_mtpav_input_open()
364 snd_mtpav_mputreg(mtp_card, CREG, 0); // disable pport interrupts in snd_mtpav_input_close()
530 cbyt = snd_mtpav_getreg(mcrd, CREG); in snd_mtpav_read_bytes()
[all …]
|
| /Linux-v5.15/Documentation/devicetree/bindings/clock/ |
| D | lpc1850-creg-clk.txt | 1 * NXP LPC1850 CREG clocks
3 The NXP LPC18xx/43xx CREG (Configuration Registers) block contains
|
| /Linux-v5.15/Documentation/devicetree/bindings/gpio/ |
| D | snps,creg-gpio.txt | 1 Synopsys GPIO via CREG (Control REGisters) driver
|
| /Linux-v5.15/Documentation/devicetree/bindings/reset/ |
| D | snps,axs10x-reset.txt | 5 This block is controlled via memory-mapped register (AKA CREG) which
|
| /Linux-v5.15/drivers/gpio/ |
| D | Kconfig | 562 bool "Synopsys GPIO via CREG (Control REGisters) driver"
566 This driver supports GPIOs via CREG on various Synopsys SoCs.
|
| /Linux-v5.15/ |
| D | MAINTAINERS | 18054 SYNOPSYS CREG GPIO DRIVER
|
