| /Linux-v5.10/drivers/misc/ |
| D | qcom-coincell.c | 32 int vset, bool enable) in qcom_coincell_chgr_config() argument
53 if (vset == qcom_vset_map[j]) in qcom_coincell_chgr_config()
57 dev_err(chgr->dev, "invalid vset-millivolts value %d\n", vset); in qcom_coincell_chgr_config()
90 u32 vset = 0; in qcom_coincell_probe() local
116 rc = of_property_read_u32(node, "qcom,vset-millivolts", &vset); in qcom_coincell_probe()
124 return qcom_coincell_chgr_config(&chgr, rset, vset, enable); in qcom_coincell_probe()
|
| /Linux-v5.10/Documentation/devicetree/bindings/regulator/ |
| D | ti-abb-regulator.txt | 50 - ti,ldovbb-vset-mask - Required if ldo-address is set, mask for LDO override
51 register to provide override vset value.
53 override register to enable override vset value.
66 efuse the value to set in 'ti,ldovbb-vset-mask' at ldo-address.
123 ti,ldovbb-vset-mask = <0x1F>;
130 1200000 0 0x4 0 0x40000 0x1f00 /* FBB optional, vset */
|
| /Linux-v5.10/Documentation/devicetree/bindings/power/supply/ |
| D | qcom,coincell-charger.txt | 23 - qcom,vset-millivolts:
46 qcom,vset-millivolts = <3000>;
|
| /Linux-v5.10/drivers/power/supply/ |
| D | abx500_chargalg.c | 546 int vset, int iset) in abx500_chargalg_ac_en() argument
555 vset = min(vset, di->ac_chg->max_out_volt); in abx500_chargalg_ac_en()
560 di->chg_info.ac_vset = vset; in abx500_chargalg_ac_en()
570 return di->ac_chg->ops.enable(di->ac_chg, enable, vset, iset); in abx500_chargalg_ac_en()
584 int vset, int iset) in abx500_chargalg_usb_en() argument
591 vset = min(vset, di->usb_chg->max_out_volt); in abx500_chargalg_usb_en()
596 di->chg_info.usb_vset = vset; in abx500_chargalg_usb_en()
598 return di->usb_chg->ops.enable(di->usb_chg, enable, vset, iset); in abx500_chargalg_usb_en()
692 int vset, int iset) in abx500_chargalg_start_charging() argument
697 "AC parameters: Vset %d, Ich %d\n", vset, iset); in abx500_chargalg_start_charging()
[all …]
|
| D | ab8500_charger.c | 1360 int enable, int vset, int iset) in ab8500_charger_ac_en() argument
1378 dev_dbg(di->dev, "Enable AC: %dmV %dmA\n", vset, iset); in ab8500_charger_ac_en()
1400 volt_index = ab8500_voltage_to_regval(vset); in ab8500_charger_ac_en()
1537 int enable, int vset, int ich_out) in ab8500_charger_usb_en() argument
1573 dev_dbg(di->dev, "Enable USB: %dmV %dmA\n", vset, ich_out); in ab8500_charger_usb_en()
1576 volt_index = ab8500_voltage_to_regval(vset); in ab8500_charger_usb_en()
1718 int vset, int iset) in ab8500_charger_usb_check_enable() argument
1747 ret = ab8500_charger_usb_en(&di->usb_chg, true, vset, iset); in ab8500_charger_usb_check_enable()
1767 int vset, int iset) in ab8500_charger_ac_check_enable() argument
1797 ret = ab8500_charger_ac_en(&di->usb_chg, true, vset, iset); in ab8500_charger_ac_check_enable()
|
| D | pm2301_charger.c | 700 int enable, int vset, int iset) in pm2xxx_charger_ac_en() argument
715 dev_dbg(pm2->dev, "Enable AC: %dmV %dmA\n", vset, iset); in pm2xxx_charger_ac_en()
732 volt_index = pm2xxx_voltage_to_regval(vset); in pm2xxx_charger_ac_en()
|
| /Linux-v5.10/drivers/leds/ |
| D | leds-mlxreg.c | 60 mlxreg_led_store_hw(struct mlxreg_led_data *led_data, u8 vset) in mlxreg_led_store_hw() argument
85 nib = (ror32(data->mask, data->bit) == 0xf0) ? rol32(vset, data->bit) : in mlxreg_led_store_hw()
86 rol32(vset, data->bit + 4); in mlxreg_led_store_hw()
|
| D | leds-mlxcpld.c | 258 static void mlxcpld_led_store_hw(u8 mask, u8 off, u8 vset) in mlxcpld_led_store_hw() argument
275 nib = (mask == 0xf0) ? vset : (vset << 4); in mlxcpld_led_store_hw()
|
| /Linux-v5.10/drivers/regulator/ |
| D | ti-abb-regulator.c | 52 u32 vset; member
232 val |= info->vset << __ffs(abb->ldovbb_vset_mask); in ti_abb_program_ldovbb()
609 info->vset = (efuse_val & vset_mask) >> __ffs(vset_mask); in ti_abb_init_table()
610 dev_dbg(dev, "[%d]v=%d vset=%x\n", i, *volt_table, info->vset); in ti_abb_init_table()
|
| /Linux-v5.10/arch/arm/boot/dts/ |
| D | dra7.dtsi | 584 ti,ldovbb-vset-mask = <0x1F>;
587 * NOTE: only FBB mode used but actual vset will
617 ti,ldovbb-vset-mask = <0x1F>;
620 * NOTE: only FBB mode used but actual vset will
650 ti,ldovbb-vset-mask = <0x1F>;
653 * NOTE: only FBB mode used but actual vset will
683 ti,ldovbb-vset-mask = <0x1F>;
686 * NOTE: only FBB mode used but actual vset will
|
| D | omap5.dtsi | 608 ti,ldovbb-vset-mask = <0x1F>;
611 * NOTE: only FBB mode used but actual vset will
638 ti,ldovbb-vset-mask = <0x1F>;
641 * NOTE: only FBB mode used but actual vset will
|
| D | qcom-msm8974-sony-xperia-amami.dts | 420 qcom,vset-millivolts = <3000>;
|
| D | qcom-msm8974-sony-xperia-honami.dts | 469 qcom,vset-millivolts = <3000>;
|
| D | qcom-msm8974-sony-xperia-castor.dts | 640 qcom,vset-millivolts = <3000>;
|
| /Linux-v5.10/drivers/scsi/ |
| D | pmcraid.h | 295 struct pmcraid_ioasa_vset vset; member
|
| D | ipr.h | 726 struct ipr_ioasa_vset vset; member
740 struct ipr_ioasa_vset vset; member
|
| D | pmcraid.c | 2524 ioasa->u.vset.failing_lba_hi != 0) { in pmcraid_frame_auto_sense()
2536 failing_lba = le32_to_cpu(ioasa->u.vset.failing_lba_hi); in pmcraid_frame_auto_sense()
2543 failing_lba = le32_to_cpu(ioasa->u.vset.failing_lba_lo); in pmcraid_frame_auto_sense()
2559 vset.failing_lba_lo); in pmcraid_frame_auto_sense()
|
| D | ipr.c | 6308 ioasa->u.vset.failing_lba_hi != 0) { in ipr_gen_sense()
6319 failing_lba = be32_to_cpu(ioasa->u.vset.failing_lba_hi); in ipr_gen_sense()
6326 failing_lba = be32_to_cpu(ioasa->u.vset.failing_lba_lo); in ipr_gen_sense()
6358 failing_lba = be32_to_cpu(ioasa->u.vset.failing_lba_lo); in ipr_gen_sense()
|
