Searched refs:rclk (Results 1 – 18 of 18) sorted by relevance
| /Linux-v5.10/drivers/clk/qcom/ |
| D | clk-regmap.c | 24 struct clk_regmap *rclk = to_clk_regmap(hw); in clk_is_enabled_regmap() local
28 ret = regmap_read(rclk->regmap, rclk->enable_reg, &val); in clk_is_enabled_regmap()
32 if (rclk->enable_is_inverted) in clk_is_enabled_regmap()
33 return (val & rclk->enable_mask) == 0; in clk_is_enabled_regmap()
35 return (val & rclk->enable_mask) != 0; in clk_is_enabled_regmap()
50 struct clk_regmap *rclk = to_clk_regmap(hw); in clk_enable_regmap() local
53 if (rclk->enable_is_inverted) in clk_enable_regmap()
56 val = rclk->enable_mask; in clk_enable_regmap()
58 return regmap_update_bits(rclk->regmap, rclk->enable_reg, in clk_enable_regmap()
59 rclk->enable_mask, val); in clk_enable_regmap()
[all …]
|
| D | clk-regmap.h | 36 int devm_clk_register_regmap(struct device *dev, struct clk_regmap *rclk);
|
| /Linux-v5.10/sound/soc/samsung/ |
| D | arndale.c | 27 unsigned long rclk; in arndale_rt5631_hw_params() local
31 rclk = params_rate(params) * rfs; in arndale_rt5631_hw_params()
44 ret = snd_soc_dai_set_sysclk(codec_dai, 0, rclk, SND_SOC_CLOCK_OUT); in arndale_rt5631_hw_params()
60 unsigned int rfs, rclk; in arndale_wm1811_hw_params() local
70 rclk = params_rate(params) * rfs; in arndale_wm1811_hw_params()
80 rclk + 1, SND_SOC_CLOCK_IN); in arndale_wm1811_hw_params()
|
| D | snow.c | 36 unsigned long int rclk; in snow_card_hw_params() local
76 rclk = params_rate(params) * rfs; in snow_card_hw_params()
80 if ((pll_rate[i] - rclk * psr) <= 2) { in snow_card_hw_params()
87 dev_err(rtd->card->dev, "Unsupported RCLK rate: %lu\n", rclk); in snow_card_hw_params()
|
| /Linux-v5.10/drivers/slimbus/ |
| D | qcom-ctrl.c | 116 struct clk *rclk; member
283 clk_prepare_enable(ctrl->rclk); in qcom_clk_pause_wakeup()
507 ctrl->rclk = devm_clk_get(&pdev->dev, "core"); in qcom_slim_probe()
508 if (IS_ERR(ctrl->rclk)) in qcom_slim_probe()
509 return PTR_ERR(ctrl->rclk); in qcom_slim_probe()
511 ret = clk_set_rate(ctrl->rclk, SLIM_ROOT_FREQ); in qcom_slim_probe()
574 ret = clk_prepare_enable(ctrl->rclk); in qcom_slim_probe()
629 clk_disable_unprepare(ctrl->rclk); in qcom_slim_probe()
644 clk_disable_unprepare(ctrl->rclk); in qcom_slim_remove()
667 clk_disable_unprepare(ctrl->rclk); in qcom_slim_runtime_suspend()
|
| /Linux-v5.10/arch/arm64/boot/dts/qcom/ |
| D | qcs404-evb.dtsi | 260 rclk {
285 rclk {
|
| D | msm8992.dtsi | 495 sdc1_rclk_on: rclk-on {
500 sdc1_rclk_off: rclk-off {
|
| D | msm8994.dtsi | 677 sdc1_rclk_on: rclk-on {
682 sdc1_rclk_off: rclk-off {
|
| D | sdm630.dtsi | 725 sdc1_rclk_on: sdc1-rclk-on {
730 sdc1_rclk_off: sdc1-rclk-off {
|
| D | sc7180.dtsi | 1764 pinconf-rclk {
1789 pinconf-rclk {
|
| /Linux-v5.10/Documentation/devicetree/bindings/mtd/ |
| D | cadence-quadspi.txt | 20 - cdns,rclk-en : Flag to indicate that QSPI return clock is used to latch
|
| /Linux-v5.10/drivers/net/ethernet/faraday/ |
| D | ftgmac100.c | 93 struct clk *rclk; member
1738 priv->rclk = devm_clk_get_optional(priv->dev, "RCLK"); in ftgmac100_setup_clk()
1739 rc = clk_prepare_enable(priv->rclk); in ftgmac100_setup_clk()
1907 clk_disable_unprepare(priv->rclk); in ftgmac100_probe()
1935 clk_disable_unprepare(priv->rclk); in ftgmac100_remove()
|
| /Linux-v5.10/drivers/net/ethernet/marvell/octeontx2/af/ |
| D | rvu.h | 284 u64 rclk; member
|
| D | rvu.c | 1019 rsp->rclk_freq = rvu->fwdata->rclk; in rvu_mbox_handler_ready()
|
| /Linux-v5.10/arch/arm/boot/dts/ |
| D | am437x-cm-t43.dts | 122 AM4372_IOPAD(0x85c, PIN_INPUT_PULLDOWN | MUX_MODE2) /* gpmc_a7.rclk */
|
| D | keystone-k2g-ice.dts | 325 cdns,rclk-en;
|
| D | keystone-k2g-evm.dts | 325 cdns,rclk-en;
|
| D | exynos5420-pinctrl.dtsi | 202 sd0_rclk: sd0-rclk {
|
