| /Linux-v5.10/drivers/net/wireless/intel/ipw2x00/ |
| D | Kconfig | 42 bool "Enable promiscuous mode"
45 Enables promiscuous/monitor mode support for the ipw2100 driver.
47 promiscuous mode via the Wireless Tool's Monitor mode. While in this
104 bool "Enable promiscuous mode"
107 Enables promiscuous/monitor mode support for the ipw2200 driver.
109 promiscuous mode via the Wireless Tool's Monitor mode. While in this
117 bool "Enable creation of a RF radiotap promiscuous interface"
|
| /Linux-v5.10/Documentation/networking/device_drivers/ethernet/intel/ |
| D | i40e.rst | 80 promiscuous mode on the Physical Function (PF).
88 set the VF to promiscuous mode.
92 For promiscuous all:
96 For promiscuous Multicast:
101 "off",meaning that promiscuous mode for the VF will be limited. To set the
102 promiscuous mode for the VF to true promiscuous and allow the VF to see all
107 The vf-true-promisc-support priv-flag does not enable promiscuous mode; rather,
108 it designates which type of promiscuous mode (limited or true) you will get
109 when you enable promiscuous mode using the ip link commands above. Note that
112 device. The PF remains in limited promiscuous mode (unless it is in MFP mode)
[all …]
|
| /Linux-v5.10/drivers/net/ethernet/micrel/ |
| D | ksz884x.c | 1292 u8 promiscuous; member
1475 int promiscuous; member
3787 if (hw->promiscuous) in hw_setup()
5378 if (priv->promiscuous) in netdev_close()
5379 --hw->promiscuous; in netdev_close()
5448 hw->promiscuous = 0; in prepare_hardware()
5494 priv->promiscuous = 0; in netdev_open()
5673 struct ksz_hw *hw, int promiscuous) in dev_set_promiscuous() argument
5675 if (promiscuous != priv->promiscuous) { in dev_set_promiscuous()
5676 u8 prev_state = hw->promiscuous; in dev_set_promiscuous()
[all …]
|
| /Linux-v5.10/drivers/net/ieee802154/ |
| D | cc2520.c | 213 bool promiscuous; /* Flag for promiscuous mode */ member
485 if (priv->promiscuous) { in cc2520_tx()
567 if (!priv->promiscuous) { in cc2520_rx()
797 priv->promiscuous = on; in cc2520_set_promiscuous_mode()
|
| D | ca8210.c | 373 bool promiscuous; member
679 priv->promiscuous = false; in ca8210_reset_send()
1827 if (priv->promiscuous) in ca8210_skb_rx()
2383 priv->promiscuous = on; in ca8210_set_promiscuous_mode()
3129 priv->promiscuous = false; in ca8210_probe()
|
| D | adf7242.c | 281 bool promiscuous; member
798 lp->promiscuous = on; in adf7242_set_promiscuous_mode()
1052 adf7242_set_promiscuous_mode(lp->hw, lp->promiscuous); in adf7242_soft_reset()
|
| /Linux-v5.10/drivers/net/wireless/intersil/orinoco/ |
| D | orinoco.h | 142 int promiscuous, mc_count; member
|
| D | hw.c | 680 priv->promiscuous = 0; in orinoco_hw_program_rids()
1074 if (promisc != priv->promiscuous) { in __orinoco_hw_set_multicast_list()
1082 priv->promiscuous = promisc; in __orinoco_hw_set_multicast_list()
|
| D | main.c | 2091 priv->promiscuous = 0; in orinoco_init()
|
| /Linux-v5.10/Documentation/networking/device_drivers/ethernet/ti/ |
| D | cpsw_switchdev.rst | 30 - optimized promiscuous mode: The P0_UNI_FLOOD (both ports) is enabled in
32 So, Ports in promiscuous mode will keep possibility of mcast and vlan
|
| /Linux-v5.10/Documentation/networking/device_drivers/fddi/ |
| D | defza.rst | 38 requested explicitly or if the CAM overflows. The promiscuous mode
|
| /Linux-v5.10/net/batman-adv/ |
| D | Kconfig | 65 configured to have promiscuous mode enabled in order to make
|
| /Linux-v5.10/drivers/net/wireless/st/cw1200/ |
| D | debug.c | 129 if (priv->rx_filter.promiscuous) in cw1200_status_show()
|
| D | wsm.h | 1365 bool promiscuous; member
1375 if (arg->promiscuous) in wsm_set_rx_filter()
|
| /Linux-v5.10/drivers/net/arcnet/ |
| D | Kconfig | 110 things as promiscuous mode, so packet sniffing is possible, and
|
| /Linux-v5.10/drivers/net/ethernet/cortina/ |
| D | gemini.h | 709 unsigned int promiscuous:1; member
|
| /Linux-v5.10/Documentation/networking/ |
| D | ipvlan.rst | 131 puts the NIC in promiscuous mode and degraded performance is a concern.
|
| D | decnet.rst | 217 will simply set themselves into promiscuous mode in order to receive
|
| D | bonding.rst | 1902 underlying device -- i.e. the bonding interface -- to promiscuous
2146 common to enable promiscuous mode on the device, so that all traffic
2148 The bonding driver handles promiscuous mode changes to the bonding
2153 the promiscuous mode setting is propagated to all slaves.
2156 promiscuous mode setting is propagated only to the active slave.
2167 promiscuous setting will be propagated to the new active slave.
|
| /Linux-v5.10/drivers/net/ethernet/intel/ |
| D | e100.c | 565 promiscuous = (1 << 1), enumerator
1111 if (nic->flags & promiscuous || nic->loopback) { in e100_configure()
1587 nic->flags |= promiscuous; in e100_set_multicast_list()
1589 nic->flags &= ~promiscuous; in e100_set_multicast_list()
|
| /Linux-v5.10/Documentation/admin-guide/media/ |
| D | faq.rst | 180 into promiscuous mode so it accepts any packets from the PID
|
| /Linux-v5.10/drivers/net/ethernet/ibm/ |
| D | ibmvnic.h | 152 __be32 promiscuous; member
|
| /Linux-v5.10/drivers/net/ethernet/marvell/ |
| D | mv643xx_eth.c | 1860 goto promiscuous; in mv643xx_eth_program_multicast_filter()
1865 goto promiscuous; in mv643xx_eth_program_multicast_filter()
1894 promiscuous: in mv643xx_eth_program_multicast_filter()
|
| /Linux-v5.10/drivers/scsi/be2iscsi/ |
| D | be_cmds.h | 686 u8 promiscuous; member
|
| /Linux-v5.10/scripts/ |
| D | spelling.txt | 1109 promiscous||promiscuous
|
