Home
last modified time | relevance | path

Searched refs:multiplexing (Results 1 – 25 of 60) sorted by relevance

123

/Linux-v5.10/Documentation/devicetree/bindings/pinctrl/
Dcortina,gemini-pinctrl.txt4 see further arm/gemini.txt. It is a purely group-based multiplexing pin
12 Subnodes of the pin controller contain pin control multiplexing set-up
15 Please refer to pinctrl-bindings.txt for generic pin multiplexing nodes
Dbrcm,bcm2835-gpio.txt46 The BCM2835 pin configuration and multiplexing supports the generic bindings.
60 Legacy pin configuration and multiplexing binding:
61 *** (Its use is deprecated, use generic multiplexing and configuration
Dste,nomadik.txt22 pin multiplexing node layout from the standard pin control bindings
25 Required pin multiplexing subnode properties:
29 group that will be combined with the function to form a multiplexing
Dpinctrl-zx.txt6 controllers work together to control pin multiplexing and configuration in
39 TOP_PMM and AON_IOCFG blocks, as the available multiplexing functions for
Dmscc,ocelot-pinctrl.txt16 The ocelot-pinctrl driver uses the generic pin multiplexing and generic pin
Dnxp,lpc1850-scu.txt9 The lpc1850-scu driver uses the generic pin multiplexing and generic pin
Dpinctrl-st.txt4 PIO multiplexing block. Each pin supports GPIO functionality (ALT0)
11 ST pinctrl driver controls PIO multiplexing block and also interacts with
Dpinctrl-bindings.txt3 Hardware modules that control pin multiplexing or configuration parameters
142 == Generic pin multiplexing node content ==
Dste,abx500.txt11 ST Ericsson's pin configuration nodes use the generic pin multiplexing
/Linux-v5.10/arch/arm/mach-omap1/
DKconfig32 bool "OMAP multiplexing support"
35 Pin multiplexing support for OMAP boards. If your bootloader
36 sets the multiplexing correctly, say N. Otherwise, or if unsure,
43 Makes the multiplexing functions print out a lot of debug info.
45 multiplexing registers.
53 to change the pin multiplexing setup. When there are no warnings
/Linux-v5.10/arch/arm/mach-davinci/
DKconfig213 bool "DAVINCI multiplexing support"
217 Pin multiplexing support for DAVINCI boards. If your bootloader
218 sets the multiplexing correctly, say N. Otherwise, or if unsure,
225 Makes the multiplexing functions print out a lot of debug info.
227 multiplexing registers.
234 to change the pin multiplexing setup. When there are no warnings
/Linux-v5.10/Documentation/driver-api/serial/
Dn_gsm.rst5 This line discipline implements the GSM 07.10 multiplexing protocol
82 Note that after closing the physical port the modem is still in multiplexing
85 a disconnect command frame manually before initializing the multiplexing mode
/Linux-v5.10/net/kcm/
DKconfig10 for multiplexing messages of a message based application
/Linux-v5.10/Documentation/devicetree/bindings/i2c/
Di2c-mux-pinctrl.txt3 This binding describes an I2C bus multiplexer that uses pin multiplexing to
4 route the I2C signals, and represents the pin multiplexing configuration
Di2c-demux-pinctrl.txt3 This binding describes an I2C bus demultiplexer that uses pin multiplexing to
4 route the I2C signals, and represents the pin multiplexing configuration using
/Linux-v5.10/drivers/net/ethernet/qualcomm/rmnet/
DKconfig12 for handling data in the multiplexing and aggregation protocol (MAP)
/Linux-v5.10/Documentation/devicetree/bindings/misc/
Deeprom-93xx46.txt12 each access to the EEPROM (e.g. for SPI bus multiplexing)
/Linux-v5.10/Documentation/devicetree/bindings/fsi/
Dfsi-master-gpio.txt12 - mux-gpios = <gpio-descriptor>; : GPIO for pin multiplexing with other
Dfsi-master-ast-cf.txt14 - mux-gpios = <gpio-descriptor>; : GPIO for pin multiplexing with other
/Linux-v5.10/Documentation/devicetree/bindings/memory-controllers/
Domap-gpmc.txt124 - gpmc,mux-add-data Address and data multiplexing configuration.
126 multiplexing mode and 2 for address-data
127 multiplexing mode.
/Linux-v5.10/drivers/video/fbdev/
Dcirrusfb.c360 int multiplexing; member
486 cinfo->multiplexing = 0; in cirrusfb_check_pixclock()
506 cinfo->multiplexing = 1; in cirrusfb_check_pixclock()
510 cinfo->multiplexing = 1; in cirrusfb_check_pixclock()
734 if (cinfo->multiplexing) { in cirrusfb_set_par_foo()
839 if (cinfo->multiplexing) in cirrusfb_set_par_foo()
953 cinfo->multiplexing ? in cirrusfb_set_par_foo()
998 if (cinfo->multiplexing) in cirrusfb_set_par_foo()
1027 cinfo->multiplexing ? in cirrusfb_set_par_foo()
1071 if (cinfo->multiplexing) in cirrusfb_set_par_foo()
/Linux-v5.10/Documentation/driver-api/media/
Ddtv-core.rst27 .. [#f1] Some standards use TCP/IP for multiplexing data, like DVB-H (an
/Linux-v5.10/Documentation/devicetree/bindings/ata/
Dcortina,gemini-sata-bridge.txt16 - cortina,gemini-ata-muxmode: tell the desired multiplexing mode for
/Linux-v5.10/Documentation/devicetree/bindings/display/
Darm,pl11x.txt53 pad used as B0, see also "LCD panel signal multiplexing
/Linux-v5.10/Documentation/driver-api/80211/
Dmac80211-advanced.rst154 :doc: Spatial multiplexing power save

123