Searched refs:measurements (Results 1 – 25 of 79) sorted by relevance
1234
11 addition the following input measurements are enabled per mode:23 allows a subset of the measurements to be enabled:28 3: All measurements per mode
11 chip takes continuous measurements). The continuous mode is15 while still needs some measurements occasionally.
11 dual tachometer measurements, and fan health monitoring.
8 proximity measurements constructed by hardware by9 combining measurements taken from a given set of
50 Used for performance and utilization measurements.56 Used for performance and utilization measurements.
25 1: 4 measurements26 2: 8 measurements27 3: 16 measurements
262 unsigned int measurements) in max30102_read_measurement() argument269 measurements * in max30102_read_measurement()273 switch (measurements) { in max30102_read_measurement()287 return (ret == measurements * MAX30102_REG_FIFO_DATA_BYTES) ? in max30102_read_measurement()295 unsigned int measurements = bitmap_weight(indio_dev->active_scan_mask, in max30102_interrupt_handler() local302 ret = max30102_read_measurement(data, measurements); in max30102_interrupt_handler()
34 in[1-20]_input Input voltage measurements (mV)36 fan[1-12]_input Fan tachometer measurements (rpm)
50 measurements, activates the corresponding alarm55 current measurements.
35 the threshold status bits. Depending on the measurements timeout settings64 provides a constant measurements discreteness. The data scaling is also104 temperature measurements within 7.130
27 An in-line attenuator allows measurements from 0 to 6 V. The
59 The "curr*_input" measurements actually report the voltage drop across the
65 e.g. maximum two measurements per second at the given resolution.
68 measurements. Several inputs have integrated attenuators so they can measure73 for negative voltage measurements.
108 bit count measurements. The frontend may reset it when a136 bit count measurements. The frontend may reset it when a165 bit count measurements. The frontend may reset it when a193 bit count measurements. The frontend may reset it when a214 bit count measurements. The frontend may reset it when a
10 TV standards, doesn't provide good statistics measurements and provides
37 device driver during its lifetime. For meaningful measurements, the
32 measurements.33 Writing value "1" is setting the IAD bit (enables the measurements).
144 # Table of individual measurements:195 disable events during measurements:261 Aggregate counts per processor socket for system-wide mode measurements. This268 Aggregate counts per processor die for system-wide mode measurements. This275 Aggregate counts per physical processor for system-wide mode measurements. This285 Aggregate counts per NUMA nodes for system-wide mode measurements. This336 Aggregate counts per processor socket for system-wide mode measurements.339 Aggregate counts per processor die for system-wide mode measurements.342 Aggregate counts per physical processor for system-wide mode measurements.
56 - dlg,jack-rate-us : Time between jack detect measurements (us)58 - dlg,jack-debounce : Number of debounce measurements taken for jack detect
4 A 16 bit ADC is used for current measurements. IADC can measure the current
11 measurements).
10 estimate signal strength and signal to noise measurements in dB.
20 the measurements list would include the code for handling a new format50 The same mechanism is employed to display measurements entries.
22 chip takes continuous measurements). The one-shot mode is
