| /Linux-v5.10/tools/perf/tests/attr/ |
| D | README | 35 perf record kill (test-record-basic)
36 perf record -b kill (test-record-branch-any)
37 perf record -j any kill (test-record-branch-filter-any)
38 perf record -j any_call kill (test-record-branch-filter-any_call)
39 perf record -j any_ret kill (test-record-branch-filter-any_ret)
40 perf record -j hv kill (test-record-branch-filter-hv)
41 perf record -j ind_call kill (test-record-branch-filter-ind_call)
42 perf record -j k kill (test-record-branch-filter-k)
43 perf record -j u kill (test-record-branch-filter-u)
44 perf record -c 123 kill (test-record-count)
[all …]
|
| D | test-record-basic | 3 args = --no-bpf-event kill >/dev/null 2>&1
|
| D | test-stat-basic | 3 args = -e cycles kill >/dev/null 2>&1
|
| D | test-record-freq | 3 args = --no-bpf-event -F 100 kill >/dev/null 2>&1
|
| D | test-record-graph-default | 3 args = --no-bpf-event -g kill >/dev/null 2>&1
|
| D | test-record-no-samples | 3 args = --no-bpf-event -n kill >/dev/null 2>&1
|
| /Linux-v5.10/include/linux/ |
| D | fs_pin.h | 9 void (*kill)(struct fs_pin *); member
14 static inline void init_fs_pin(struct fs_pin *p, void (*kill)(struct fs_pin *)) in init_fs_pin()
19 p->kill = kill; in init_fs_pin()
|
| /Linux-v5.10/Documentation/devicetree/bindings/power/reset/ |
| D | ltc2952-poweroff.txt | 5 A full powerdown can be triggered via the kill signal.
12 - kill-gpios: phandle + gpio-specifier for the GPIO connected to the
13 chip's kill line
19 until an explicit kill signal is received
28 kill-gpios = <&gpio0 2 GPIO_ACTIVE_LOW>;
|
| /Linux-v5.10/fs/ |
| D | fs_struct.c | 100 int kill; in exit_fs() local
104 kill = !--fs->users; in exit_fs()
107 if (kill) in exit_fs()
137 int kill; in unshare_fs_struct() local
144 kill = !--fs->users; in unshare_fs_struct()
149 if (kill) in unshare_fs_struct()
|
| /Linux-v5.10/tools/testing/selftests/powerpc/ |
| D | harness.c | 62 kill(-pid, SIGKILL); in run_test()
66 kill(-pid, SIGTERM); in run_test()
74 kill(-pid, SIGTERM); in run_test()
|
| /Linux-v5.10/arch/um/os-Linux/ |
| D | util.c | 94 if (kill(getpid(), SIGABRT) < 0) in uml_abort()
122 kill(0, SIGTERM); in os_dump_core()
128 kill(0, SIGCONT); in os_dump_core()
|
| D | process.c | 95 kill(pid, SIGALRM); in os_alarm_process()
100 kill(pid, SIGSTOP); in os_stop_process()
105 kill(pid, SIGKILL); in os_kill_process()
117 kill(pid, SIGKILL); in os_kill_ptraced_process()
|
| /Linux-v5.10/tools/testing/selftests/powerpc/signal/ |
| D | sigreturn_vdso.c | 89 kill(getpid(), SIGUSR1); in test_sigreturn_vdso()
101 kill(getpid(), SIGUSR1); in test_sigreturn_vdso()
117 kill(getpid(), SIGUSR1); in test_sigreturn_vdso()
|
| D | sig_sc_double_restart.c | 36 kill(getpid(), SIGUSR2); in SIGUSR1_handler()
147 kill(pid, SIGUSR1); in test_restart()
|
| /Linux-v5.10/Documentation/vm/ |
| D | hwpoison.rst | 12 kill the processes associated with it and avoid using it in the future.
66 early kill
73 late kill
76 Note some pages are always handled as late kill.
85 Enable early kill mode globally
88 Set early/late kill mode/revert to system default
96 Early kill
98 Late kill
|
| /Linux-v5.10/tools/testing/selftests/proc/ |
| D | setns-dcache.c | 41 kill(pid, SIGTERM); in f()
108 kill(pid, SIGTERM); in main()
|
| D | setns-sysvipc.c | 40 kill(pid, SIGTERM); in f()
107 kill(pid, SIGTERM); in main()
|
| /Linux-v5.10/security/apparmor/ |
| D | lib.c | 308 perms->kill = ALL_PERMS_MASK; in aa_apply_modes_to_perms()
354 accum->kill |= addend->kill & ~addend->allow; in aa_perms_accum_raw()
373 accum->kill |= addend->kill & ~accum->allow; in aa_perms_accum()
447 if (denied & perms->kill) in aa_check_perms()
|
| /Linux-v5.10/Documentation/networking/device_drivers/wifi/intel/ |
| D | ipw2100.rst | 177 0 RF kill not enabled (radio on)
178 1 SW based RF kill active (radio off)
179 2 HW based RF kill active (radio off)
180 3 Both HW and SW RF kill active (radio off)
186 0 If SW based RF kill active, turn the radio back on
187 1 If radio is on, activate SW based RF kill
192 If you enable the SW based RF kill and then toggle the HW
193 based RF kill from ON -> OFF -> ON, the radio will NOT come back on
204 RF kill switch"
|
| /Linux-v5.10/tools/testing/selftests/pidfd/ |
| D | pidfd_wait.c | 109 kill(getpid(), SIGSTOP); in TEST()
110 kill(getpid(), SIGSTOP); in TEST()
177 kill(getpid(), SIGSTOP); in TEST()
|
| /Linux-v5.10/tools/testing/selftests/breakpoints/ |
| D | breakpoint_test.c | 141 kill(getpid(), SIGUSR1); in check_trapped()
216 kill(getpid(), SIGUSR1); in trigger_tests()
261 kill(getpid(), SIGUSR1); in trigger_tests()
|
| /Linux-v5.10/arch/um/kernel/ |
| D | tlb.c | 477 goto kill; in flush_tlb_page()
481 goto kill; in flush_tlb_page()
485 goto kill; in flush_tlb_page()
489 goto kill; in flush_tlb_page()
524 goto kill; in flush_tlb_page()
531 kill: in flush_tlb_page()
|
| /Linux-v5.10/mm/ |
| D | memremap.c | 102 if (pgmap->ops && pgmap->ops->kill) in dev_pagemap_kill()
103 pgmap->ops->kill(pgmap); in dev_pagemap_kill()
348 if (pgmap->ops && (pgmap->ops->kill || pgmap->ops->cleanup)) in memremap_pages()
358 if (!pgmap->ops || !pgmap->ops->kill || !pgmap->ops->cleanup) { in memremap_pages()
|
| /Linux-v5.10/tools/testing/selftests/powerpc/pmu/ |
| D | lib.c | 92 kill(child_pid, SIGTERM); in kill_child_and_wait()
145 kill(pid, SIGKILL); in eat_cpu()
|
| /Linux-v5.10/tools/testing/selftests/uevent/ |
| D | uevent_filtering.c | 231 ret = kill(self, SIGKILL); in set_death_signal()
326 ret = kill(pid, SIGTERM); /* success */ in do_test()
328 ret = kill(pid, SIGUSR1); /* error */ in do_test()
|
