Searched refs:irqm (Results 1 – 7 of 7) sorted by relevance
| /Linux-v5.10/Documentation/scsi/ |
| D | ChangeLog.ncr53c8xx | 197 ncr53c8xx=irqm:??, as follows:
198 a) If bit 0x10 is set in irqm, IRQF_SHARED flag is not used.
199 b) If bit 0x20 is set in irqm, IRQF_DISABLED flag is not used.
201 Option 'ncr53c8xx=irqm:0x20' may be used when an IRQ is shared by
|
| D | ChangeLog.sym53c8xx | 440 ncr53c8xx=irqm:??, as follows:
441 a) If bit 0x10 is set in irqm, SA_SHIRQ flag is not used.
442 b) If bit 0x20 is set in irqm, SA_INTERRUPT flag is not used.
444 Option 'ncr53c8xx=irqm:0x20' may be used when an IRQ is shared by
|
| D | ncr53c8xx.rst | 939 irqm:0 always open drain
940 irqm:1 same as initial settings (assumed BIOS settings)
941 irqm:2 always totem pole
942 irqm:0x10 driver will not use IRQF_SHARED flag when requesting irq
1067 irq mode from BIOS settings irqm:1
1079 tags:0,sync:50,debug:0,burst:7,led:0,wide:1,settle:2,diff:0,irqm:0
1092 tags:32,sync:12,debug:0,burst:7,led:1,wide:1,settle:2,diff:0,irqm:0
|
| D | sym53c8xx_2.rst | 560 irqm=0 always open drain
561 irqm=1 same as initial settings (assumed BIOS settings)
562 irqm=2 always totem pole
|
| /Linux-v5.10/drivers/scsi/ |
| D | ncr53c8xx.h | 524 u8 irqm; member
|
| D | ncr53c8xx.c | 729 driver_setup.irqm = val; in sym53c8xx__setup()
3946 switch(driver_setup.irqm & 3) { in ncr_prepare_setting()
|
| /Linux-v5.10/drivers/scsi/sym53c8xx_2/ |
| D | sym_glue.c | 52 module_param_named(irqm, sym_driver_setup.irq_mode, byte, 0);
66 MODULE_PARM_DESC(irqm, "0 for open drain, 1 to leave alone, 2 for totem pole");
|
