| /Linux-v5.10/drivers/staging/comedi/drivers/ |
| D | ni_6527.c | 274 unsigned int falling) in ni6527_set_edge_detection() argument
279 falling &= mask; in ni6527_set_edge_detection()
288 falling |= readb(dev->mmio + in ni6527_set_edge_detection()
296 writeb(falling & 0xff, in ni6527_set_edge_detection()
300 falling >>= 8; in ni6527_set_edge_detection()
311 unsigned int rising, falling, shift; in ni6527_intr_insn_config() local
319 falling = data[2]; in ni6527_intr_insn_config()
320 ni6527_set_edge_detection(dev, mask, rising, falling); in ni6527_intr_insn_config()
330 falling = 0; in ni6527_intr_insn_config()
338 falling = 0; in ni6527_intr_insn_config()
[all …]
|
| /Linux-v5.10/Documentation/devicetree/bindings/pps/ |
| D | pps-gpio.txt | 15 - assert-falling-edge: when present, assert is indicated by a falling edge
24 assert-falling-edge;
|
| /Linux-v5.10/drivers/iio/proximity/ |
| D | ping.c | 59 struct completion falling; member
86 complete(&data->falling); in ping_handle_irq()
108 reinit_completion(&data->falling); in ping_read()
146 ret = wait_for_completion_killable_timeout(&data->falling, HZ/20); in ping_read()
295 init_completion(&data->falling); in ping_probe()
|
| D | srf04.c | 66 struct completion falling; member
90 complete(&data->falling); in srf04_handle_irq()
113 reinit_completion(&data->falling); in srf04_read()
135 ret = wait_for_completion_killable_timeout(&data->falling, HZ/20); in srf04_read()
266 init_completion(&data->falling); in srf04_probe()
|
| /Linux-v5.10/drivers/gpio/ |
| D | gpio-mt7621.c | 38 u32 falling; member
123 mtk_gpio_w32(rg, GPIO_REG_FEDGE, fall | (BIT(pin) & rg->falling)); in mediatek_gpio_irq_unmask()
159 if ((rg->rising | rg->falling | in mediatek_gpio_irq_type()
167 rg->falling &= ~mask; in mediatek_gpio_irq_type()
174 rg->falling |= mask; in mediatek_gpio_irq_type()
180 rg->falling |= mask; in mediatek_gpio_irq_type()
|
| D | gpio-hlwd.c | 76 u32 level, rising, falling; in hlwd_gpio_irqhandler() local
80 falling = ~level & emulated_pending; in hlwd_gpio_irqhandler()
91 falling &= hlwd->falling_edge; in hlwd_gpio_irqhandler()
94 pending |= rising | falling; in hlwd_gpio_irqhandler()
|
| /Linux-v5.10/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-adc-hi8435 | 17 this value then the threshold falling event is pushed.
27 If falling threshold results hysteresis to odd value then rising
47 If rising threshold results hysteresis to odd value then falling
|
| D | sysfs-bus-iio-timer-stm32 | 37 OC4REF rising or falling edges generate pulses.
39 OC6REF rising or falling edges generate pulses.
43 OC4REF rising or OC6REF falling edges generate
48 OC5REF rising or OC6REF falling edges generate
|
| D | sysfs-bus-iio-light-lm3533-als | 7 in each direction (rising|falling) and a zone change occurs.
42 in_illuminance0_threshY_{falling,rising} thresholds.
|
| /Linux-v5.10/Documentation/devicetree/bindings/iio/light/ |
| D | opt3001.txt | 5 the optional generation of IIO events on rising/falling light threshold changes
16 - interrupts: interrupt mapping for GPIO IRQ (configure for falling edge)
|
| /Linux-v5.10/arch/arm/boot/dts/ |
| D | socfpga_arria5_socdk.dts | 92 * adjust the falling times to decrease the i2c frequency to 50Khz
95 i2c-sda-falling-time-ns = <5000>;
96 i2c-scl-falling-time-ns = <5000>;
|
| D | socfpga_cyclone5_socdk.dts | 96 * adjust the falling times to decrease the i2c frequency to 50Khz
99 i2c-sda-falling-time-ns = <5000>;
100 i2c-scl-falling-time-ns = <5000>;
|
| D | socfpga_arria10_socdk.dtsi | 131 * adjust the falling times to decrease the i2c frequency to 50Khz
135 i2c-sda-falling-time-ns = <6000>;
136 i2c-scl-falling-time-ns = <6000>;
|
| D | ste-href-tvk1281618-r2.dtsi | 26 * the falling edge if they could be wired together.
44 * the falling edge if they could be wired together.
|
| D | stm32mp157a-stinger96.dtsi | 90 i2c-scl-falling-time-ns = <300>;
100 i2c-scl-falling-time-ns = <20>;
235 interrupt-names = "onkey-falling", "onkey-rising";
|
| /Linux-v5.10/Documentation/devicetree/bindings/gpio/ |
| D | cavium-octeon-gpio.txt | 22 2 - edge triggered on the falling edge
38 * 2 - edge falling
|
| /Linux-v5.10/drivers/pinctrl/bcm/ |
| D | pinctrl-nsp-gpio.c | 226 bool falling; in nsp_gpio_irq_set_type() local
230 falling = nsp_get_bit(chip, REG, NSP_GPIO_EVENT_INT_POLARITY, gpio); in nsp_gpio_irq_set_type()
235 falling = false; in nsp_gpio_irq_set_type()
239 falling = true; in nsp_gpio_irq_set_type()
257 nsp_set_bit(chip, REG, NSP_GPIO_EVENT_INT_POLARITY, gpio, falling); in nsp_gpio_irq_set_type()
268 level_low ? "true" : "false", falling ? "true" : "false"); in nsp_gpio_irq_set_type()
|
| /Linux-v5.10/Documentation/devicetree/bindings/net/nfc/ |
| D | nfcmrvl.txt | 20 - i2c-int-falling: Specifies that the chip read event shall be trigged on
21 falling edge.
|
| /Linux-v5.10/Documentation/devicetree/bindings/regulator/ |
| D | max8973-regulator.txt | 23 -maxim,enable-falling-slew-rate: boolean, enable falling slew rate.
|
| /Linux-v5.10/Documentation/devicetree/bindings/soc/fsl/cpm_qe/cpm/ |
| D | pic.txt | 9 - 2 is falling edge
|
| /Linux-v5.10/Documentation/devicetree/bindings/input/ |
| D | tca8418_keypad.txt | 9 - interrupts: IRQ line number, should trigger on falling edge
|
| /Linux-v5.10/arch/arm64/boot/dts/altera/ |
| D | socfpga_stratix10_socdk.dts | 131 i2c-sda-falling-time-ns = <890>; /* hcnt */
132 i2c-sdl-falling-time-ns = <890>; /* lcnt */
|
| D | socfpga_stratix10_socdk_nand.dts | 164 i2c-sda-falling-time-ns = <890>; /* hcnt */
165 i2c-sdl-falling-time-ns = <890>; /* lcnt */
|
| /Linux-v5.10/drivers/staging/iio/cdc/ |
| D | ad7150.c | 428 static AD7150_TIMEOUT(0, mag_adaptive, falling, MAG_ADAPTIVE, FALLING);
430 static AD7150_TIMEOUT(1, mag_adaptive, falling, MAG_ADAPTIVE, FALLING);
432 static AD7150_TIMEOUT(0, thresh_adaptive, falling, THRESH_ADAPTIVE, FALLING);
434 static AD7150_TIMEOUT(1, thresh_adaptive, falling, THRESH_ADAPTIVE, FALLING);
|
| /Linux-v5.10/Documentation/devicetree/bindings/timer/ |
| D | nuvoton,npcm7xx-timer.txt | 10 falling edge.
|
